[Federal Register: November 7, 2003 (Volume 68, Number 216)]
[Rules and Regulations]
[Page 63011-63013]
From the Federal Register Online via GPO Access [wais.access.gpo.gov]
[DOCID:fr07no03-1]
========================================================================
Rules and Regulations
Federal Register
________________________________________________________________________
This section of the FEDERAL REGISTER contains regulatory documents
having general applicability and legal effect, most of which are keyed
to and codified in the Code of Federal Regulations, which is published
under 50 titles pursuant to 44 U.S.C. 1510.
The Code of Federal Regulations is sold by the Superintendent of Documents.
Prices of new books are listed in the first FEDERAL REGISTER issue of each
week.
========================================================================
[[Page 63011]]
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
14 CFR Part 23
[Docket No. CE199, Special Condition 23-139-SC]
Special Conditions; Garmin International, Inc. EFIS on the
Diamond DA-40; Protection of Systems for High Intensity Radiated Fields
(HIRF)
AGENCY: Federal Aviation Administration (FAA), DOT.
ACTION: Final special conditions; request for comments.
-----------------------------------------------------------------------
SUMMARY: These special conditions are issued to Garmin International,
Inc., 1200 E. 151st St., Olathe, KS 66062, for a Supplemental Type
Certificate for the Diamond Aircraft Industries DA-40. This airplane
will have novel and unusual design features when compared to the state
of technology envisaged in the applicable airworthiness standards.
These novel and unusual design features include the installation of an
electronic flight instrument system (EFIS) display, Model G-1000,
manufactured by Garmin International, Inc. for which the applicable
regulations do not contain adequate or appropriate airworthiness
standards for the protection of these systems from the effects of high
intensity radiated fields (HIRF). These special conditions contain the
additional safety standards that the Administrator considers necessary
to establish a level of safety equivalent to the airworthiness
standards applicable to these airplanes.
DATES: The effective date of these special conditions is October 22,
2003. Comments must be received on or before December 8, 2003.
ADDRESSES: Comments on these special conditions may be mailed in
duplicate to: Federal Aviation Administration, Regional Counsel, ACE-7,
Attention: Rules Docket Clerk, Docket No. CE199, Room 506, 901 Locust,
Kansas City, Missouri 64106. All comments must be marked: Docket No.
CE199. Comments may be inspected in the Rules Docket weekdays, except
Federal holidays, between 7:30 a.m. and 4 p.m.
FOR FURTHER INFORMATION CONTACT: Wes Ryan, Aerospace Engineer,
Standards Office (ACE-110), Small Airplane Directorate, Aircraft
Certification Service, Federal Aviation Administration, 901 Locust,
Room 301, Kansas City, Missouri 64106; telephone (816) 329-4127.
SUPPLEMENTARY INFORMATION:
The FAA has determined that notice and opportunity for prior public
comment hereon are impracticable because these procedures would
significantly delay issuance of the approval design and thus delivery
of the affected aircraft. In addition, the substance of these special
conditions has been subject to the public comment process in several
prior instances with no substantive comments received. The FAA,
therefore, finds that good cause exists for making these special
conditions effective upon issuance.
Comments Invited
Interested persons are invited to submit such written data, views,
or arguments, as they may desire. Communications should identify the
regulatory docket or notice number and be submitted in duplicate to the
address specified above. All communications received on or before the
closing date for comments will be considered by the Administrator. The
special conditions may be changed in light of the comments received.
All comments received will be available in the Rules Docket for
examination by interested persons, both before and after the closing
date for comments. A report summarizing each substantive public contact
with FAA personnel concerning this rulemaking will be filed in the
docket. Commenters wishing the FAA to acknowledge receipt of their
comments submitted in response to this notice must include a self-
addressed, stamped postcard on which the following statement is made:
``Comments to Docket No. CE199.'' The postcard will be date stamped and
returned to the commenter.
Background
On March 6, 2003, Garmin International, Inc., 1200 E. 151st St.,
Olathe, KS 66062, made an application to the FAA for a new Supplemental
Type Certificate for the Diamond Aircraft Industries DA-40 airplane.
The DA-40 is currently approved under TC No. A47CE. The proposed
modification incorporates a novel or unusual design feature, such as
digital avionics consisting of an EFIS that is vulnerable to HIRF
external to the airplane.
Type Certification Basis
Under the provisions of 14 CFR part 21, Sec. 21.101, Garmin
International, Inc. must show that the Diamond DA-40 aircraft meets the
following original certification basis provisions or the applicable
regulations in effect on the date of application for the change to the
DA-40: Type Certification under 14 CFR part 21, Sec. 21.29, including
the following requirements: Joint Aviation Requirements (JAR) 23,
Initial Issue, dated March 11, 1994. The DA-40 was certificated using
the FAA/JAA validation certification procedures and significant
regulatory differences were addressed. Therefore, the certification
basis is equivalent to 14 CFR part 23, effective February 1, 1965,
including Amendments 23-1 through Amendment 23-51. 14 CFR part 36,
effective December 1, 1969, including Amendments 36-1 through Amendment
36-21. Special Condition 23-107-SC, applicable to the Model DA-40 for
protection of systems for High Intensity Radiated Fields, published on
June 7, 2001. Exemptions, if any; and the special conditions adopted by
this rulemaking action.
Discussion
If the Administrator finds that the applicable airworthiness
standards do not contain adequate or appropriate safety standards
because of novel or unusual design features of an airplane, special
conditions are prescribed under the provisions of Sec. 21.16.
Special conditions, as appropriate, as defined in Sec. 11.19, are
issued in accordance with Sec. 11.38 after public notice and become
part of the type certification basis in accordance with Sec. 21.101.
Special conditions are initially applicable to the model for which
they are issued. Should the applicant apply
[[Page 63012]]
for a supplemental type certificate to modify any other model already
included on the same type certificate to incorporate the same novel or
unusual design feature, the special conditions would also apply to the
other model under the provisions of Sec. 21.101.
Novel or Unusual Design Features
Garmin International, Inc. plans to incorporate certain novel and
unusual design features into the Diamond DA-40 airplane for which the
airworthiness standards do not contain adequate or appropriate safety
standards for protection from the effects of HIRF. These features
include EFIS, which are susceptible to the HIRF environment, that were
not envisaged by the existing regulations for this type of airplane.
Protection of Systems From High Intensity Radiated Fields (HIRF)
Recent advances in technology have given rise to the application in
aircraft designs of advanced electrical and electronic systems that
perform functions required for continued safe flight and landing. Due
to the use of sensitive solid-state advanced components in analog and
digital electronics circuits, these advanced systems are readily
responsive to the transient effects of induced electrical current and
voltage caused by the HIRF. The HIRF can degrade electronic systems
performance by damaging components or upsetting system functions.
Furthermore, the HIRF environment has undergone a transformation
that was not foreseen when the current requirements were developed.
Higher energy levels are radiated from transmitters that are used for
radar, radio, and television. Also, the number of transmitters has
increased significantly. There is also uncertainty concerning the
effectiveness of airframe shielding for HIRF. Furthermore, coupling to
cockpit-installed equipment through the cockpit window apertures is
undefined.
The combined effect of the technological advances in airplane
design and the changing environment has resulted in an increased level
of vulnerability of electrical and electronic systems required for the
continued safe flight and landing of the airplane. Effective measures
against the effects of exposure to HIRF must be provided by the design
and installation of these systems. The accepted maximum energy levels
in which civilian airplane system installations must be capable of
operating safely are based on surveys and analysis of existing radio
frequency emitters. These special conditions require that the airplane
be evaluated under these energy levels for the protection of the
electronic system and its associated wiring harness. These external
threat levels, which are lower than previous required values, are
believed to represent the worst case to which an airplane would be
exposed in the operating environment.
These special conditions require qualification of systems that
perform critical functions, as installed in aircraft, to the defined
HIRF environment in paragraph 1 or, as an option to a fixed value using
laboratory tests, in paragraph 2, as follows:
(1) The applicant may demonstrate that the operation and
operational capability of the installed electrical and electronic
systems that perform critical functions are not adversely affected when
the aircraft is exposed to the HIRF environment defined below:
------------------------------------------------------------------------
Field Strength
(volts per meter)
Frequency ---------------------
Peak Average
------------------------------------------------------------------------
10 kHz-100 kHz.................................... 50 50
100 kHz-500 kHz................................... 50 50
500 kHz-2 MHz..................................... 50 50
2 MHz-30 MHz...................................... 100 100
30 MHz-70 MHz..................................... 50 50
70 MHz-100 MHz.................................... 50 50
100 MHz-200 MHz................................... 100 100
200 MHz-400 MHz................................... 100 100
400 MHz-700 MHz................................... 700 50
700 MHz-1 GHz..................................... 700 100
1 GHz-2 GHz....................................... 2000 200
2 GHz-4 GHz....................................... 3000 200
4 GHz-6 GHz....................................... 3000 200
6 GHz-8 GHz....................................... 1000 200
8 GHz-12 GHz...................................... 3000 300
12 GHz-18 GHz..................................... 2000 200
18 GHz-40 GHz..................................... 600 200
------------------------------------------------------------------------
The field strengths are expressed in terms of peak root-mean-square
(rms) values.
or,
(2) The applicant may demonstrate by a system test and analysis
that the electrical and electronic systems that perform critical
functions can withstand a minimum threat of 100 volts per meter,
electrical field strength, from 10 kHz to 18 GHz. When using this test
to show compliance with the HIRF requirements, no credit is given for
signal attenuation due to installation.
A preliminary hazard analysis must be performed by the applicant,
for approval by the FAA, to identify either electrical or electronic
systems that perform critical functions. The term ``critical'' means
those functions whose failure would contribute to, or cause, a failure
condition that would prevent the continued safe flight and landing of
the airplane. The systems identified by the hazard analysis that
perform critical functions are candidates for the application of HIRF
requirements. A system may perform both critical and non-critical
functions. Primary electronic flight display systems, and their
associated components, perform critical functions such as attitude,
altitude, and airspeed indication. The HIRF requirements apply only to
critical functions.
Compliance with HIRF requirements may be demonstrated by tests,
analysis, models, similarity with existing systems, or any combination
of these. Service experience alone is not acceptable since normal
flight operations may not include an exposure to the HIRF environment.
Reliance on a system with similar design features for redundancy as a
means of protection
[[Page 63013]]
against the effects of external HIRF is generally insufficient since
all elements of a redundant system are likely to be exposed to the
fields concurrently.
Applicability
As discussed above, these special conditions are applicable to the
Diamond DA-40 airplane. Should Garmin International, Inc. apply at a
later date for a supplemental type certificate to modify any other
model on the same type certificate to incorporate the same novel or
unusual design feature, the special conditions would apply to that
model as well under the provisions of Sec. 21.101.
Conclusion
This action affects only certain novel or unusual design features
on one model of airplane. It is not a rule of general applicability and
affects only the applicant who applied to the FAA for approval of these
features on the airplane.
The substance of these special conditions has been subjected to the
notice and comment period in several prior instances and has been
derived without substantive change from those previously issued. It is
unlikely that prior public comment would result in a significant change
from the substance contained herein. For this reason, and because a
delay would significantly affect the certification of the airplane,
which is imminent, the FAA has determined that prior public notice and
comment are unnecessary and impracticable, and good cause exists for
adopting these special conditions upon issuance. The FAA is requesting
comments to allow interested persons to submit views that may not have
been submitted in response to the prior opportunities for comment
described above.
List of Subjects in 14 CFR Part 23
Aircraft, Aviation safety, Signs and symbols.
Citation
The authority citation for these special conditions is as follows:
Authority: 49 U.S.C. 106(g), 40113 and 44701; 14 CFR 21.16 and
21.101; and 14 CFR 11.38 and 11.19.
The Special Conditions
0
Accordingly, pursuant to the authority delegated to me by the
Administrator, the following special conditions are issued as part of
the type certification basis for Diamond DA-40 airplane modified by
Garmin International, Inc. to add a G-1000 EFIS system.
1. Protection of Electrical and Electronic Systems from High Intensity
Radiated Fields (HIRF)
Each system that performs critical functions must be designed and
installed to ensure that the operations, and operational capabilities
of these systems to perform critical functions, are not adversely
affected when the airplane is exposed to high intensity radiated
electromagnetic fields external to the airplane.
2. For the purpose of these special conditions, the following
definition applies:
Critical Functions: Functions whose failure would contribute to, or
cause, a failure condition that would prevent the continued safe flight
and landing of the airplane.
Issued in Kansas City, Missouri, on October 22, 2003.
Michael Gallagher,
Manager, Small Airplane Directorate, Aircraft Certification Service.
[FR Doc. 03-28013 Filed 11-6-03; 8:45 am]
BILLING CODE 4910-13-P