[Federal Register: July 27, 2004 (Volume 69, Number 143)]
[Rules and Regulations]
[Page 44591-44592]
From the Federal Register Online via GPO Access [wais.access.gpo.gov]
[DOCID:fr27jy04-7]
-----------------------------------------------------------------------
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
14 CFR Part 39
[Docket No. 2003-NM-285-AD; Amendment 39-13743; AD 2004-15-09]
RIN 2120-AA64
Airworthiness Directives; Bombardier Model DHC-8-101, -102, -103,
-106, -201, -202, -301, -311, and -315 Airplanes
AGENCY: Federal Aviation Administration, DOT.
ACTION: Final rule.
-----------------------------------------------------------------------
SUMMARY: This amendment adopts a new airworthiness directive (AD),
applicable to certain Bombardier Model DHC-8-101, -102, -103, -106, -
201, -202, -301, -311, and -315 airplanes. This amendment requires an
inspection of the fuel tube assembly of the auxiliary power unit (APU)
for clearance from adjacent components; and an inspection of the fuel
tube assembly and the bleed air duct shroud for discrepancies
(insufficient clearance, nicks, dents, chafing, or other damage); and
related investigative and corrective actions if necessary. This
amendment also requires relocation of certain support clamps on the APU
fuel tube assembly. This action is necessary to prevent a fuel leak
caused by chafing of the APU fuel tube assembly, which could result in
fire in the center wing area. This action is intended to address the
identified unsafe condition.
DATES: Effective August 31, 2004.
The incorporation by reference of certain publications listed in
the regulations is approved by the Director of the Federal Register as
of August 31, 2004.
ADDRESSES: The service information referenced in this AD may be
obtained from Bombardier, Inc., Bombardier Regional Aircraft Division,
123 Garratt Boulevard, Downsview, Ontario M3K 1Y5, Canada. This
information may be examined at the FAA, Transport Airplane Directorate,
1601 Lind Avenue, SW., Renton, Washington; or at the FAA, New York
Aircraft Certification Office, 1600 Stewart Avenue, suite 410,
Westbury, New York; or at the National Archives and Records
Administration (NARA). For information on the availability of this
material at NARA, call (202) 741-6030, or go to: http://www.archives.gov/federal_register/code_of_federal_regulations/ibr_locations.html
.
FOR FURTHER INFORMATION CONTACT: Mazdak Hobbi, Aerospace Engineer,
Airframe and Propulsion Branch, ANE-171, FAA, New York Aircraft
Certification Office, 1600 Stewart Avenue, suite 410, Westbury, New
York 11590; telephone (516) 228-7330; fax (516) 794-5531.
SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal
Aviation Regulations (14 CFR part 39) to include an airworthiness
directive (AD) that is applicable to certain Bombardier Model DHC-8-
101, -102, -103, -106, -201, -202, -301, -311, and -315 airplanes was
published in the Federal Register on May 19, 2004 (69 FR 28863). That
action proposed to require an inspection of the fuel tube assembly of
the auxiliary power unit (APU) for clearance from adjacent components;
an inspection of the fuel tube assembly and the bleed air duct shroud
for discrepancies (insufficient clearance, nicks, dents, chafing, or
other damage); and related investigative and corrective actions if
necessary. That action also proposed to require relocation of certain
support clamps on the APU fuel tube assembly.
Comments
Interested persons have been afforded an opportunity to participate
in the making of this amendment. No comments were submitted in response
to the proposal or the FAA's determination of the cost to the public.
Conclusion
The FAA has determined that air safety and the public interest
require the adoption of the rule as proposed.
Cost Impact
The FAA estimates that 125 airplanes of U.S. registry will be
affected by this AD, that it will take approximately 1 work hour per
airplane to accomplish the required actions, and that the average labor
rate is $65 per work hour. Based on these figures, the cost impact of
the AD on U.S. operators is estimated to be $8,125, or $65 per
airplane.
The cost impact figure discussed above is based on assumptions that
no operator has yet accomplished any of the requirements of this AD
action, and that no operator would accomplish those actions in the
future if this AD were not adopted. The cost impact figures discussed
in AD rulemaking actions represent only the time necessary to perform
the specific actions actually required by the AD. These figures
typically do not include incidental costs, such as the time required to
gain access and close up, planning time, or time necessitated by other
administrative actions.
Regulatory Impact
The regulations adopted herein will not have a substantial direct
effect on the States, on the relationship between the national
Government and the States, or on the distribution of power and
responsibilities among the various levels of government. Therefore, it
is determined that this final rule does not have federalism
implications under Executive Order 13132.
For the reasons discussed above, I certify that this action (1) is
not a ``significant regulatory action'' under Executive Order 12866;
(2) is not a ``significant rule'' under DOT Regulatory Policies and
Procedures (44 FR 11034, February 26, 1979); and (3) will not have a
significant economic impact, positive or negative, on a substantial
number of small entities under the criteria of the Regulatory
Flexibility Act. A final evaluation has been prepared for this action
and it is contained in the Rules Docket. A copy of it may be obtained
from the Rules
[[Page 44592]]
Docket at the location provided under the caption ADDRESSES.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by
reference, Safety.
Adoption of the Amendment
0
Accordingly, pursuant to the authority delegated to me by the
Administrator, the Federal Aviation Administration amends part 39 of
the Federal Aviation Regulations (14 CFR part 39) as follows:
PART 39--AIRWORTHINESS DIRECTIVES
0
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 [Amended]
0
2. Section 39.13 is amended by adding the following new airworthiness
directive:
2004-15-09 Bombardier, Inc. (Formerly de Havilland, Inc.): Amendment
39-13743. Docket 2003-NM-285-AD.
Applicability: Model DHC-8-101, -102, -103, -106, -201, -202, -
301, -311, and -315 airplanes, serial number 003 through 585
inclusive; certificated in any category; with auxiliary power unit
(APU) installation per Standard Option Only (S.O.O.) 8155 or Change
Request (CR) 849SO08155.
Compliance: Required as indicated, unless accomplished
previously.
To prevent a fuel leak caused by chafing of the APU fuel tube
assembly, which could result in fire in the center wing area,
accomplish the following:
Inspection, Relocation and Related Investigative and Corrective Actions
(a) Within 6 months after the effective date of this AD: Do a
general visual inspection of the APU fuel tube assembly for
discrepancies. The inspection includes examining the routing of the
fuel tube assembly to ensure that the tube has sufficient clearance
between the shroud of the bleed air duct and the gust lock cable;
and inspecting the fuel tube assembly and the bleed air duct shroud
for other discrepancies such as nicks, dents, chafing, or other
damage. If the inspection shows no discrepancies, before further
flight, relocate the clamps on the fuel tube assembly. If the
inspection shows discrepancies, before further flight, do the
applicable related investigative and corrective actions, and
relocate the clamps on the fuel tube assembly. Accomplish all
actions per the Accomplishment Instructions of Bombardier Service
Bulletin 8-49-19, Revision A, dated July 7, 2003.
Note 1: For the purposes of this AD, a general visual inspection
is defined as: ``A visual examination of an interior or exterior
area, installation, or assembly to detect obvious damage, failure,
or irregularity. This level of inspection is made from within
touching distance unless otherwise specified. A mirror may be
necessary to enhance visual access to all exposed surfaces in the
inspection area. This level of inspection is made under normally
available lighting conditions such as daylight, hangar lighting,
flashlight, or droplight and may require removal or opening of
access panels or doors. Stands, ladders, or platforms may be
required to gain proximity to the area being checked.''
Inspections Accomplished Per Previous Issue of Service Bulletin
(b) Actions accomplished before the effective date of this AD
per Bombardier Service Bulletin 8-49-19, dated May 13, 2003, are
considered acceptable for compliance with the corresponding action
specified in this AD.
Alternative Methods of Compliance
(c) In accordance with 14 CFR 39.19, the Manager, New York
Aircraft Certification Office, FAA, is authorized to approve
alternative methods of compliance for this AD.
Incorporation by Reference
(d) Unless otherwise specified in this AD, the actions shall be
done in accordance with Bombardier Service Bulletin 8-49-19,
Revision A, dated July 7, 2003. This incorporation by reference was
approved by the Director of the Federal Register in accordance with
5 U.S.C. 552(a) and 1 CFR part 51. Copies may be obtained from
Bombardier, Inc., Bombardier Regional Aircraft Division, 123 Garratt
Boulevard, Downsview, Ontario M3K 1Y5, Canada. Copies may be
inspected at the FAA, Transport Airplane Directorate, 1601 Lind
Avenue, SW., Renton, Washington; or at the FAA, New York Aircraft
Certification Office, 1600 Stewart Avenue, suite 410, Westbury, New
York; or at the National Archives and Records Administration (NARA).
For information on the availability of this material at NARA, call
(202) 741-6030, or go to: http://www.archives.gov/federal_register/code_of_federal_regulations/ibr_locations.html
.
Note 2: The subject of this AD is addressed in Canadian
airworthiness directive CF-2003-22, dated September 3, 2003.
Effective Date
(e) This amendment becomes effective on August 31, 2004.
Issued in Renton, Washington, on July 9, 2004.
Kevin M. Mullin,
Acting Manager, Transport Airplane Directorate, Aircraft Certification
Service.
[FR Doc. 04-16680 Filed 7-26-04; 8:45 am]
BILLING CODE 4910-13-P