[Federal Register: November 2, 2004 (Volume 69, Number 211)]
[Rules and Regulations]
[Page 63442-63443]
From the Federal Register Online via GPO Access [wais.access.gpo.gov]
[DOCID:fr02no04-3]
-----------------------------------------------------------------------
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
14 CFR Part 39
[Docket No. 2003-SW-39-AD; Amendment 39-13839; AD 2004-22-11]
RIN 2120-AA64
Airworthiness Directives; Eurocopter Deutschland GmbH Model EC135
P1, P2, T1, and T2 Helicopters
AGENCY: Federal Aviation Administration, DOT.
ACTION: Final rule.
-----------------------------------------------------------------------
SUMMARY: This amendment supersedes an existing airworthiness directive
(AD) for Eurocopter Deutschland GmbH (Eurocopter) Model EC135 P1, P2,
T1, and T2 helicopters. That AD currently requires adding the AD or a
statement to the Rotorcraft Flight Manual (RFM) informing the pilot to
reduce power and land as soon as practicable if a thump-like sound
followed by an unusual vibration occurs during flight. That AD also
requires visually inspecting the main rotor drive torque strut assembly
(strut) for a crack or a break, recording the inspections in the
historical or equivalent record, re-marking and relocating the strut,
as appropriate, and replacing any unairworthy strut with an airworthy
strut. Also, that AD establishes life limits for certain struts and
revises the life limit for other struts. This amendment requires the
same actions as the existing AD except that it changes the visual
inspection from a one-time inspection to daily inspections; reduces the
life limit for aluminum struts; and eliminates the once-only transfer
and remarking of certain struts. This amendment is prompted by an
incident in which a pilot felt an in-flight increase in vibration and
subsequent discovery of a failed strut. The actions specified by this
AD are intended to prevent failure of a strut and subsequent loss of
control of the helicopter.
DATES: Effective December 7, 2004.
The incorporation by reference of certain publications listed in
the regulations is approved by the Director of the Federal Register as
of December 7, 2004.
ADDRESSES: The service information referenced in this AD may be
obtained from American Eurocopter Corporation, 2701 Forum Drive, Grand
Prairie, Texas 75053-4005, telephone (972) 641-3460, fax (972) 641-
3527. This information may be examined at the FAA, Office of the
Regional Counsel, Southwest Region, 2601 Meacham Blvd., Room 663, Fort
Worth, Texas; or at the National Archives and Records Administration
(NARA). For information on the availability of this material at NARA,
call 202-741-6030, or go to: http://www.archives.gov/federal_register/code_of_federal_regulations/ibr_locations.html
.
FOR FURTHER INFORMATION CONTACT: Richard Monschke, Aviation Safety
Engineer, FAA, Rotorcraft Directorate, Rotorcraft Standards Staff, Fort
Worth, Texas 76193-0110, telephone (817) 222-5116, fax (817) 222-5961.
SUPPLEMENTARY INFORMATION: A proposal to amend 14 CFR part 39 by
superseding AD 2003-20-11, Amendment 39-13329 (68 FR 58581, October 10,
2003), for the specified Eurocopter model helicopters was published in
the Federal Register on June 2, 2004 (69 FR 31051). The action proposed
to require adding the AD or a statement to the RFM informing the pilot
to reduce power and land as soon as practicable if a thump-like sound
followed by unusual vibration occurs during flight; visually inspecting
the strut for a crack or a break before the first flight of each day;
replacing any unairworthy strut with an airworthy strut; replacing all
aluminum struts with titanium struts on or before accumulating 500
hours time-in service (TIS) or no later than December 31, 2004,
whichever occurs first; installing the struts in pairs; and canceling
the once-only transfer and remarking of certain struts.
The Luftfahrt-Bundesamt (LBA), the airworthiness authority for the
Federal Republic of Germany, notified the FAA that an unsafe condition
may exist on Eurocopter Model EC135 P1, P2, T1, and T2 helicopters. The
LBA advises that the holders of affected aircraft registered in the
Federal Republic of Germany must carry out the inspection for a crack,
marking, replacement, and reduction of life limit of struts in
accordance with the manufacturer's alert service bulletin.
Eurocopter has issued Alert Service Bulletin EC135-63A-002,
Revision 4, dated July 7, 2003 (ASB), concerning reduction in life
limit for the strut, and visual inspections of the strut and emergency
stop. The ASB contains errors--in paragraph 1.A., the abbreviation ``S/
N'' should be ``P/N'' and in paragraphs 1.C., 1.E.(1), and 1.E.(2), it
incorrectly states that the ASB is Revision 3 rather than Revision 4.
The LBA classified this ASB as mandatory and issued AD No. 2001-107/3,
dated August 21, 2003, to ensure the continued airworthiness of these
helicopters in the Federal Republic of Germany.
These helicopter models are manufactured in Germany and are type
certificated for operation in the United States under the provisions of
14 CFR 21.29 and the applicable bilateral agreement. Pursuant to the
applicable bilateral agreement, the LBA has kept the FAA informed of
the situation described above. The FAA has examined the findings of the
LBA, reviewed all available information, and determined that AD action
is necessary for products of this type design that are certificated for
operation in the United States.
Interested persons have been afforded an opportunity to participate
in the making of this amendment. No comments were received on the
proposal or the FAA's determination of the cost to the public. The FAA
has determined that air safety and the public interest require the
adoption of the rule as proposed with only a minor editorial change.
This change will neither increase the economic burden on any operator
nor increase the scope of the AD.
The FAA estimates that this AD will affect 50 helicopters of U.S.
registry. It will take approximately 92.25 work hours per helicopter to
accomplish the inspections and parts replacement at an average labor
rate of $65 per work hour. Required parts will cost approximately
$7,296 per helicopter. Based on these figures, we estimate the total
cost impact of this AD on U.S. operators to be $664,612 to replace the
aluminum struts on the entire fleet.
The regulations adopted herein will not have a substantial direct
effect on the States, on the relationship between the national
government and the States, or on the distribution of power and
responsibilities among the various levels of government. Therefore, it
is determined that this final rule does not have federalism
implications under Executive Order 13132.
For the reasons discussed above, I certify that this action (1) is
not a ``significant regulatory action'' under Executive Order 12866;
(2) is not a ``significant rule'' under DOT Regulatory Policies and
Procedures (44 FR 11034, February 26, 1979); and (3) will not have a
significant economic
[[Page 63443]]
impact, positive or negative, on a substantial number of small entities
under the criteria of the Regulatory Flexibility Act. A final
evaluation has been prepared for this action and it is contained in the
Rules Docket. A copy of it may be obtained from the Rules Docket at the
location provided under the caption ADDRESSES.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by
reference, Safety.
Adoption of the Amendment
0
Accordingly, pursuant to the authority delegated to me by the
Administrator, the Federal Aviation Administration amends part 39 of
the Federal Aviation Regulations (14 CFR part 39) as follows:
PART 39--AIRWORTHINESS DIRECTIVES
0
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 [Amended]
0
2. Section 39.13 is amended by removing Amendment 39-13329 (68 FR
58581, October 10, 2003), and by adding a new airworthiness directive
(AD), Amendment 39-13839, to read as follows:
2004-22-11 Eurocopter Deutschland GmbH: Amendment 39-13839. Docket
No. 2003-SW-39-AD. Supersedes AD 2003-20-11, Amendment 39-13329,
Docket No. 2003-SW-08-AD.
Applicability: Model EC135 P1, P2, T1, and T2 helicopters, with
main rotor drive aluminum torque strut assembly (strut), part number
(P/N) L633M1001 103 or L633M1001 105, installed, certificated in any
category.
Compliance: Required as indicated, unless accomplished
previously.
To prevent failure of the strut and subsequent loss of control
of the helicopter, do the following:
(a) Before further flight, insert a copy of this AD or insert a
statement into the Emergency Procedures Section of the Rotorcraft
Flight Manual (RFM) to inform the pilot to reduce power and land as
soon as practicable if a thump-like sound followed by an unusual
vibration occurs during flight.
(b) Before the first flight of each day, using a light and
mirror, inspect each aluminum strut for a crack or a break by
following the Accomplishment Instructions, paragraph 3.B. of
Eurocopter Alert Service Bulletin EC135-63A-002, Revision 4, dated
July 7, 2003 (ASB). Replace any cracked or broken strut with a new
titanium strut, P/N L633M1001 104, before further flight.
(c) Within the next 100 hours time-in-service (TIS), for each
aluminum strut with 400 or more hours TIS, replace each aluminum
strut with a titanium strut, P/N L633M1001 104.
(d) This AD revises the Airworthiness Limitations section of the
maintenance manual by reducing the retirement life of each aluminum
strut, P/N L633M1001 103 and L633M1001 105, to 500 total hours TIS
or retiring them no later than December 31, 2004, whichever comes
first.
(e) The aluminum struts must be replaced with titanium struts in
pairs and at the same time. Installing one aluminum strut and one
titanium strut is not authorized. After installing titanium struts,
recalculate the weight and balance using 0.356kg as the weight and
1498.76kgmm as the moment for both titanium struts.
Note 1: The once-only transferring and remarking of certain
aluminum struts provided in the superseded AD are no longer
authorized.
(f) Replacing aluminum struts, P/N L633M1001 103 and L633M1001
105, with titanium struts, P/N L633M1001 104, constitutes
terminating action for the requirements of this AD. Titanium struts
have no life limit.
(g) To request a different method of compliance or a different
compliance time for this AD, follow the procedures in 14 CFR 39.19.
Contact the Safety Management Group for information about previously
approved alternative methods of compliance.
(h) The inspections shall be done in accordance with Eurocopter
Alert Service Bulletin EC135-63A-002, Revision 4, dated July 7,
2003. The Director of the Federal Register approved the
incorporation by reference in accordance with 5 U.S.C. 552(a) and 1
CFR part 51. Copies may be obtained from American Eurocopter
Corporation, 2701 Forum Drive, Grand Prairie, Texas 75053-4005,
telephone (972) 641-3460, fax (972) 641-3527. Copies may be
inspected at the FAA, Office of the Regional Counsel, Southwest
Region, 2601 Meacham Blvd., Room 663, Fort Worth, Texas; or at the
National Archives and Records Administration (NARA). For information
on the availability of this material at NARA, call 202-741-6030, or
go to: http://www.archives.gov/federal_register/code_of_federal_regulations/ibr_locations.html
.
(i) This amendment becomes effective on December 7, 2004.
Note 2: The subject of this AD is addressed in Luftfahrt-
Bundesamt (Federal Republic of Germany) AD 2001-107/3, dated August
21, 2003.
Issued in Fort Worth, Texas, on October 22, 2004.
David A. Downey,
Manager, Rotorcraft Directorate, Aircraft Certification Service.
[FR Doc. 04-24226 Filed 11-1-04; 8:45 am]
BILLING CODE 4910-13-P