[Federal Register: January 3, 2005 (Volume 70, Number 1)]
[Rules and Regulations]
[Page 10]
From the Federal Register Online via GPO Access [wais.access.gpo.gov]
[DOCID:fr03ja05-3]
-----------------------------------------------------------------------
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
14 CFR Part 39
[Docket No. 2002-NM-182-AD; Amendment 39-13882; AD 2004-24-06]
RIN 2120-AA64
Airworthiness Directives; Saab Model SAAB SF340A and SAAB 340B
Series Airplanes
AGENCY: Federal Aviation Administration, DOT.
ACTION: Final rule; correction.
-----------------------------------------------------------------------
SUMMARY: This document corrects a typographical error that appeared in
airworthiness directive (AD) 2004-24-06 that was published in the
Federal Register on November 30, 2004 (69 FR 69505). The typographical
error resulted in incorrect reference to certain main landing gear
(MLG) part numbers as retract actuator bracket attachment bolt (RABAB)
part numbers. This AD is applicable to certain Saab Model SAAB SF340A
and SAAB 340B series airplanes. This AD requires replacement of the
RABAB of the MLG with a new RABAB; reidentification of the MLG shock
strut; an inspection for corrosion, fretting, or other damage of
certain RABABs; and applicable corrective actions.
DATES: Effective January 4, 2005.
FOR FURTHER INFORMATION CONTACT: Dan Rodina, Aerospace Engineer;
International Branch, ANM-116, FAA, Transport Airplane Directorate,
1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (425)
227-2125; fax (425) 227-1149.
SUPPLEMENTARY INFORMATION: Airworthiness Directive (AD) 2004-24-06,
amendment 39-13882, applicable to certain Saab Model SAAB SF340A and
SAAB 340B series airplanes, was published in the Federal Register on
November 30, 2004 (69 FR 69505). That AD requires replacement of the
retract actuator bracket attachment bolt (RABAB) of the main landing
gear (MLG) with a new RABAB; reidentification of the MLG shock strut;
an inspection for corrosion, fretting, or other damage of certain
RABABs; and applicable corrective actions.
As published, the AD contains an incorrect reference to the old
RABAB part number. Instead of the RABAB part number, certain MLG
assembly part numbers were listed as RABAB part numbers.
Since no other part of the regulatory information has been changed,
the final rule is not being republished in the Federal Register.
The effective date of this AD remains January 4, 2005.
Sec. 39.13 [Corrected]
0
In the Federal Register of November 30, 2004, on page 69506, make the
following corrections:
0
1. In the first column, following instruction 2, the airworthiness
directive number ``2004-24-067'' is corrected to read ``2004-24-06'';
0
2. In the second column, paragraph (c) of this AD 2004-24-06 is
corrected to read as follows:
* * * * *
(c) As of the effective date of this AD, no person may install a
MLG shock strut, part number (P/N) AIR83022-5 through -18 inclusive, or
P/N AIR83064-1 through -5 inclusive, on any airplane; and no person may
install a RABAB, P/N AIR124792, on any MLG shock strut.
* * * * *
Issued in Renton, Washington, on December 21, 2004.
Kevin M. Mullin,
Acting Manager, Transport Airplane Directorate, Aircraft Certification
Service.
[FR Doc. 04-28653 Filed 12-28-04; 1:42 pm]
BILLING CODE 4910-13-P