[Federal Register: January 5, 2005 (Volume 70, Number 3)]
[Rules and Regulations]
[Page 690-691]
From the Federal Register Online via GPO Access [wais.access.gpo.gov]
[DOCID:fr05ja05-10]
[[Page 690]]
-----------------------------------------------------------------------
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
14 CFR Part 39
[Docket No. FAA-2004-18752; Directorate Identifier 2004-NM-107-AD;
Amendment 39-13929; AD 2005-01-05]
RIN 2120-AA64
Airworthiness Directives; Empresa Brasileira de Aeronautica S.A.
(EMBRAER) Model EMB-135 and EMB-145 Series Airplanes
AGENCY: Federal Aviation Administration (FAA), DOT.
ACTION: Final rule.
-----------------------------------------------------------------------
SUMMARY: The FAA is superseding an existing airworthiness directive
(AD), which applies to certain EMBRAER Model EMB-135 and EMB-145 series
airplanes. That AD currently requires replacing the nose landing gear
wheel nuts and associated inner and outer seals, and reidentifying the
landing gear strut. This new AD adds an airplane to the applicability
and revises a part number for a replacement part. This AD is prompted
by a report of an invalid part number for the new nose landing gear
wheel nut. We are issuing this AD to prevent separation of the wheels
from the nose landing gear due to the failure of the outer wheel
bearings, and consequent loss of control of the airplane during takeoff
and landing.
DATES: This AD becomes effective February 9, 2005.
On June 9, 2004 (69 FR 24940, May 5, 2004), the Director of the
Federal Register approved the incorporation by reference of EMBRAER
Service Bulletin 145-32-0068, Change 04, dated January 20, 2003; and
EMBRAER Service Bulletin 145LEG-32-0006, Change 01, dated January 20,
2003.
ADDRESSES: For service information identified in this AD, contact
Empresa Brasileira de Aeronautica S.A. (EMBRAER), P.O. Box 343--CEP
12.225, Sao Jose dos Campos--SP, Brazil.
You can examine this information at the National Archives and
Records Administration (NARA). For information on the availability of
this material at NARA, call (202) 741-6030, or go to: http://www.archives.gov/federal_register/code_of_federal_regulations/ibr_locations.html
.
You can examine the contents of this AD docket on the Internet at
http://dms.dot.gov, or at the Docket Management Facility, U.S.
Department of Transportation, 400 Seventh Street SW, room PL-401, on
the plaza level of the Nassif Building, Washington, DC.
FOR FURTHER INFORMATION CONTACT:
Technical information: Todd Thompson, Aerospace Engineer;
International Branch, ANM-116, FAA, Transport Airplane Directorate,
1601 Lind Avenue, SW, Renton, Washington 98055-4056; telephone (425)
227-1175; fax (425) 227-1149.
Plain language information: Marcia Walters, marcia.walters@faa.gov.
Examining the Docket
The AD docket contains the proposed AD, comments, and any final
disposition. You can examine the AD docket on the Internet at http://dms.dot.gov
, or in person at the Docket Management Facility office
between 9 a.m. and 5 p.m., Monday through Friday, except Federal
holidays. The Docket Management Facility office (telephone (800) 647-
5227) is located on the plaza level of the Nassif Building at the DOT
street address stated in the ADDRESSES section.
SUPPLEMENTARY INFORMATION: The FAA proposed to amend part 39 of the
Federal Aviation Regulations (14 CFR Part 39) with an AD to supersede
AD 2004-09-15, amendment 39-13604, (69 FR 24940, May 5, 2004). The
existing AD applies to certain EMBRAER Model EMB-135 and EMB-145 series
airplanes. The proposed AD was published in the Federal Register on
August 4, 2004 (69 FR 47038), and continued to require replacing the
nose landing gear wheel nuts and associated inner and outer seals, and
reidentifying the landing gear strut. The proposed AD also added an
airplane to the applicability and revised a part number for a
replacement part.
Comments
We provided the public the opportunity to participate in the
development of this AD. We have considered the comment that has been
submitted on the proposed AD.
Request to Add an Alternative Method of Compliance (AMOC)
The commenter requests that a reference to replacement seal
assembly part number (P/N) AEC-68-1498, which was approved as an AMOC
for AD 2004-09-15, be included in the proposed AD. The commenter notes
that P/N AEC-68-1498 has a parts manufacturer approval and is an FAA-
approved replacement assembly for the P/N 68-1498 seal assembly. The
commenter contends that P/N AEC-68-1498 should be included in the
proposed AD as an approved seal assembly.
The FAA does not agree to include a reference to replacement seal
assembly P/N AEC-68-1498 in this final rule. However, we do agree that
AMOCs approved previously for AD 2004-09-15, amendment 39-13604, are
acceptable as AMOCs for this final rule. We have revised paragraph (i)
of this final rule to include the following statement: ``AMOCs,
approved previously in accordance with AD 2004-09-15, amendment 39-
13604, are approved as AMOCs for this AD.''
Conclusion
We have carefully reviewed the available data, including the
comment that was submitted, and determined that air safety and the
public interest require adopting the AD with the change described
previously. We have determined that this change will neither increase
the economic burden on any operator nor increase the scope of the AD.
Costs of Compliance
This AD affects about 365 airplanes of U.S. registry.
The actions that are required by AD 2004-09-15, and retained in
this AD, take about 1 work hour per airplane, at an average labor rate
of $65 per work hour. Required parts will be provided free of charge by
the airplane manufacturer. Based on these figures, the estimated cost
of the currently required actions for U.S. operators is $23,725, or $65
per airplane.
Authority for This Rulemaking
The FAA's authority to issue rules regarding aviation safety is
found in Title 49 of the United States Code. Subtitle I, Section 106
describes the authority of the FAA Administrator. Subtitle VII,
Aviation Programs, describes in more detail the scope of the agency's
authority.
This rulemaking is promulgated under the authority described in
Subtitle VII, Part A, Subpart III, Section 44701, ``General
requirements.'' Under that section, the FAA is charged with promoting
safe flight of civil aircraft in air commerce by prescribing
regulations for practices, methods, and procedures the Administrator
finds necessary for safety in air commerce. This regulation is within
the scope of that authority because it addresses an unsafe condition
that is likely to exist or develop on products identified in this AD.
Regulatory Findings
We have determined that this AD will not have federalism
implications under Executive Order 13132. This AD will not have a
substantial direct effect on the States, on the relationship between
the national government and the States,
[[Page 691]]
or on the distribution of power and responsibilities among the various
levels of government.
For the reasons discussed above, I certify that this AD:
(1) Is not a ``significant regulatory action'' under Executive
Order 12866;
(2) Is not a ``significant rule'' under DOT Regulatory Policies and
Procedures (44 FR 11034, February 26, 1979); and
(3) Will not have a significant economic impact, positive or
negative, on a substantial number of small entities under the criteria
of the Regulatory Flexibility Act.
We prepared a regulatory evaluation of the estimated costs to
comply with this AD. See the ADDRESSES section for a location to
examine the regulatory evaluation.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by
reference, Safety.
Adoption of the Amendment
0
Accordingly, under the authority delegated to me by the Administrator,
the FAA amends 14 CFR part 39 as follows:
PART 39--AIRWORTHINESS DIRECTIVES
0
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 [Amended]
0
2. The FAA amends Sec. 39.13 by removing amendment 39-13604 (69 FR
24940, May 5, 2004), and by adding the following new airworthiness
directive:
2005-01-05 Empresa Brasileira de Aeronautica S.A. (EMBRAER):
Amendment 39-13929. Docket No. FAA-2004-18752; Directorate
Identifier 2004-NM-107-AD.
Effective Date
(a) This airworthiness directive (AD) becomes effective February
9, 2005.
Affected ADs
(b) This AD supersedes AD 2004-09-15, amendment 39-13604.
Applicability
(c) This AD applies to Model EMB-135 and EMB-145 series
airplanes having serial numbers (S/N) 145003 through 145373
inclusive, 145375, 145377 through 145391 inclusive, and 145393
through 145408 inclusive; certificated in any category; equipped
with nose landing gear struts, part number (P/N) 1170C0000-01
(including all modifications), P/N 1170C0000-02, or P/N 1170C0000-
03.
Unsafe Condition
(d) This AD was prompted by a report of an invalid part number
for the new nose landing gear wheel nut. We are issuing this AD to
prevent separation of the wheels from the nose landing gear due to
the failure of the outer wheel bearings, and consequent loss of
control of the airplane during takeoff and landing.
Compliance
(e) You are responsible for having the actions required by this
AD performed within the compliance times specified, unless the
actions have already been done.
Replacement and Reidentification
(f) At the applicable time specified in paragraph (f)(1) or
(f)(2) of this AD, replace the nose landing gear wheel nuts, P/N
1170-0007, with new wheel nuts, P/N 1170-0082; replace the
associated inner and outer seals, P/N 68-1157 or P/N 72-290, with
new seals, P/N 68-1498; and reidentify the struts. Do the actions in
accordance with the Accomplishment Instructions of EMBRAER Service
Bulletin 145-32-0068, Change 04, dated January 20, 2003; or EMBRAER
Service Bulletin 145LEG-32-0006, Change 01, dated January 20, 2003;
as applicable.
(1) For Model EMB-135 and EMB-145 series airplanes having S/N
145003 through 145373 inclusive, 145377 through 145391 inclusive,
and 145393 through 145408 inclusive: Within 12 months after June 9,
2004 (the effective date of AD 2004-09-15).
(2) For Model EMB-145 series airplane having S/N 145375: Within
12 months after the effective date of this AD.
(g) Actions accomplished before the effective date of this AD
per the EMBRAER Service Bulletins listed in Table 1 of this AD are
considered acceptable for compliance with the corresponding actions
specified in this AD:
Table 1.--Service Bulletins Considered Acceptable for Compliance
------------------------------------------------------------------------
EMBRAER service bulletin Change level Date
------------------------------------------------------------------------
145-32-0068..................... Original....... May 4, 2001.
145-32-0068..................... 01............. Jan. 14, 2002.
145-32-0068..................... 02............. Apr. 16, 2002.
145-32-0068..................... 03............. Nov. 25, 2002.
145LEG-32-0006.................. Original....... Nov. 26, 2002.
------------------------------------------------------------------------
Parts Installation
(h) As of the effective date of this AD, no person may install
nose landing gear wheel nuts, P/N 1170-0007, or the associated inner
and outer seals, P/N 68-1157 or P/N 72-290, on any airplane.
Alternative Methods of Compliance (AMOC)
(i)(1) The Manager, International Branch, ANM-116, Transport
Airplane Directorate, FAA, has the authority to approve AMOCs for
this AD, if requested in accordance with the procedures found in 14
CFR 39.19.
(2) AMOCS approved previously in accordance with AD 2004-09-15,
amendment 39-13604, are approved as AMOCs for this AD.
Related Information
(j) Brazilian airworthiness directive 2002-03-01R2, effective
April 22, 2003, also addresses the subject of this AD.
Material Incorporated by Reference
(k) You must use EMBRAER Service Bulletin 145-32-0068, Change
04, dated January 20, 2003; or EMBRAER Service Bulletin 145LEG-32-
0006, Change 01, dated January 20, 2003; as applicable; to perform
the actions that are required by this AD, unless the AD specifies
otherwise. The Director of the Federal Register previously approved
the incorporation by reference of these documents as of June 9, 2004
(69 FR 24940, May 5, 2004). For copies of the service information,
contact Empresa Brasileira de Aeronautica S.A. (EMBRAER), P.O. Box
343--CEP 12.225, Sao Jose dos Campos--SP, Brazil. For information on
the availability of this material at the National Archives and
Records Administration (NARA), call (202) 741-6030, or go to http://www.archives.gov/federal_register/code_of_federal_regulations/ibr_locations.html.
You may view the AD docket at the Docket
Management Facility, U.S. Department of Transportation, 400 Seventh
Street SW., room PL-401, Nassif Building, Washington, DC.
Issued in Renton, Washington, on December 27, 2004.
Kevin M. Mullin,
Acting Manager, Transport Airplane Directorate, Aircraft Certification
Service.
[FR Doc. 05-164 Filed 1-4-05; 8:45 am]
BILLING CODE 4910-13-P