[Federal Register: March 8, 2005 (Volume 70, Number 44)]
[Proposed Rules]
[Page 11170-11172]
From the Federal Register Online via GPO Access [wais.access.gpo.gov]
[DOCID:fr08mr05-21]
-----------------------------------------------------------------------
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
14 CFR Part 39
[Docket No. FAA-2005-20500; Directorate Identifier 2004-NM-235-AD]
RIN 2120-AA64
Airworthiness Directives; Airbus Model A320 Series Airplanes
AGENCY: Federal Aviation Administration (FAA), Department of
Transportation (DOT).
ACTION: Notice of proposed rulemaking (NPRM).
-----------------------------------------------------------------------
SUMMARY: The FAA proposes to adopt a new airworthiness directive (AD)
for certain Airbus Model A320 series airplanes. This proposed AD would
require post-maintenance bleeding of accumulated air from, or ground
functional testing of, the ram air turbine (RAT) system; modifying and
reidentifying the airborne ground check module of the RAT system; and
replacing the RAT reducer assembly if applicable. This proposed AD is
prompted by reports of unsuccessful in-flight RAT tests during which a
deployed RAT failed to pressurize the blue hydraulic circuit of the RAT
system. We are proposing this AD to prevent failure of the RAT during
an in-flight emergency, which could lead to loss of hydraulic and
electrical power and reduced controllability of the airplane.
DATES: We must receive comments on this proposed AD by April 7, 2005.
ADDRESSES: Use one of the following addresses to submit comments on
this proposed AD.
DOT Docket Web site: Go to http://dms.dot.gov and follow
the instructions for sending your comments electronically.
Government-wide rulemaking Web site: Go to http://www.regulations.gov
and follow the instructions for sending your
comments electronically.
Mail: Docket Management Facility, U.S. Department of
Transportation, 400 Seventh Street, SW., Nassif Building, room PL-401,
Washington, DC 20590.
By fax: (202) 493-2251.
Hand Delivery: Room PL-401 on the plaza level of the
Nassif Building, 400 Seventh Street, SW., Washington, DC, between 9
a.m. and 5 p.m., Monday through Friday, except Federal holidays.
For service information identified in this proposed AD, contact
Airbus, 1 Rond Point Maurice Bellonte, 31707 Blagnac Cedex, France.
You can examine the contents of this AD docket on the Internet at
http://dms.dot.gov, or in person at the Docket Management Facility,
U.S. Department of Transportation, 400 Seventh Street, SW., room PL-
401, on the plaza level of the Nassif Building, Washington, DC. This
docket number is FAA-2005-20500; the directorate identifier for this
docket is 2004-NM-235-AD.
FOR FURTHER INFORMATION CONTACT: Dan Rodina, Aerospace Engineer,
International Branch, ANM-116, FAA, Transport Airplane Directorate,
1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (425)
227-2125; fax (425) 227-1149.
SUPPLEMENTARY INFORMATION:
Comments Invited
We invite you to submit any relevant written data, views, or
arguments regarding this proposed AD. Send your comments to an address
listed under ADDRESSES. Include ``Docket No. FAA-2005-20500;
Directorate Identifier 2004-NM-235-AD'' at the beginning of your
comments. We specifically invite comments on the overall regulatory,
economic, environmental, and energy aspects of the proposed AD. We will
consider all comments submitted by the closing date and may amend the
proposed AD in light of those comments.
We will post all comments we receive, without change, to http://dms.dot.gov
, including any personal information you provide. We will
also post a report summarizing each substantive verbal contact with FAA
personnel concerning this proposed AD. Using the search function of our
docket Web site, anyone can find and read the comments in any of our
dockets, including the name of the individual who sent the comment (or
signed the comment on behalf of an association, business, labor union,
etc.). You can review the DOT's complete Privacy Act Statement in the
Federal Register published on April 11, 2000 (65 FR 19477-78), or you
can visit http://dms.dot.gov.
[[Page 11171]]
Examining the Docket
You can examine the AD docket on the Internet at http://dms.dot.gov
, or in person at the Docket Management Facility office
between 9 a.m. and 5 p.m., Monday through Friday, except Federal
holidays. The Docket Management Facility office (telephone (800) 647-
5227) is located on the plaza level of the Nassif Building at the DOT
street address stated in the ADDRESSES section. Comments will be
available in the AD docket shortly after the DMS receives them.
Discussion
The Direction G[eacute]n[eacute]rale de l'Aviation Civile (DGAC),
which is the airworthiness authority for France, notified us that an
unsafe condition may exist on certain Airbus Model A320 series
airplanes. The DGAC advises that several operators have reported
unsuccessful in-flight ram air turbine (RAT) system tests during which
a deployed RAT failed to pressurize the blue hydraulic circuit of the
RAT system. Investigation revealed that the warming flow jet plug
installed in the RAT main housing can allow free air to accumulate
within the RAT system, leading to RAT pump cavitations. This condition,
if not corrected, could result in failure of the RAT during an in-
flight emergency, which could lead to loss of hydraulic and electrical
power and reduced controllability of the airplane.
Relevant Service Information
Airbus has issued All Operators Telex (AOT) A320-29A1112, Revision
01, dated April 8, 2004. The AOT describes procedures for either
bleeding accumulated air from the RAT system or doing ground functional
testing of the RAT after performing any maintenance on the blue
hydraulic circuit of the RAT system.
Airbus has issued Service Bulletin A320-29-1111, dated June 29,
2004. The service bulletin describes procedures for modifying and
reidentifying the airborne ground check module (AGCM) of the RAT
system; and, for certain airplanes, replacing the reducer assembly with
a new reducer assembly. Accomplishing the actions of the service
bulletin would end the need for the actions specified by the AOT.
Airbus Service Bulletin A320-29-1111 refers to Hamilton Sundstrand
Service Bulletin ERPS13GCM-29-5, dated June 29, 2004, as an additional
source of service information for modifying and reidentifying the AGCM.
The DGAC mandated the service information and issued French
airworthiness directive F-2004-150, dated September 1, 2004, to ensure
the continued airworthiness of these airplanes in France.
Accomplishing the actions specified in the service information is
intended to adequately address the unsafe condition.
FAA's Determination and Requirements of the Proposed AD
These airplane models are manufactured in France and are type
certificated for operation in the United States under the provisions of
section 21.29 of the Federal Aviation Regulations (14 CFR 21.29) and
the applicable bilateral airworthiness agreement. Pursuant to this
bilateral airworthiness agreement, the DGAC has kept the FAA informed
of the situation described above. We have examined the DGAC's findings,
evaluated all pertinent information, and determined that we need to
issue an AD for products of this type design that are certificated for
operation in the United States.
Therefore, we are proposing this AD, which would require
accomplishing the actions specified in the service information
described previously.
Costs of Compliance
This proposed AD would affect about 130 airplanes of U.S. registry.
The proposed system bleed/functional test would take about 1 work
hour per airplane, at an average labor rate of $65 per work hour. Based
on these figures, the estimated cost of the proposed AD for U.S.
operators is $8,450, or $65 per airplane.
The proposed AGCM replacement would take about 2 work hours per
airplane, at an average labor rate of $65 per work hour. Required parts
would be supplied at no charge. Based on these figures, the estimated
cost of this proposed action for U.S. operators is $16,900, or $130 per
airplane.
The proposed reducer replacement, for subject airplanes, would take
about 1 work hour per airplane, at an average labor rate of $65 per
work hour. Required parts would be supplied at no charge. Based on
these figures, the estimated cost of this proposed action is $65 per
airplane.
Authority for This Rulemaking
Title 49 of the United States Code specifies the FAA's authority to
issue rules on aviation safety. Subtitle I, Section 106, describes the
authority of the FAA Administrator. Subtitle VII, Aviation Programs,
describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in
Subtitle VII, Part A, Subpart III, Section 44701, ``General
requirements.'' Under that section, Congress charges the FAA with
promoting safe flight of civil aircraft in air commerce by prescribing
regulations for practices, methods, and procedures the Administrator
finds necessary for safety in air commerce. This regulation is within
the scope of that authority because it addresses an unsafe condition
that is likely to exist or develop on products identified in this
rulemaking action.
Regulatory Findings
We have determined that this proposed AD would not have federalism
implications under Executive Order 13132. This proposed AD would not
have a substantial direct effect on the States, on the relationship
between the national Government and the States, or on the distribution
of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify that the proposed
regulation:
1. Is not a ``significant regulatory action'' under Executive Order
12866;
2. Is not a ``significant rule'' under the DOT Regulatory Policies
and Procedures (44 FR 11034, February 26, 1979); and
3. Will not have a significant economic impact, positive or
negative, on a substantial number of small entities under the criteria
of the Regulatory Flexibility Act.
We prepared a regulatory evaluation of the estimated costs to
comply with this proposed AD. See the ADDRESSES section for a location
to examine the regulatory evaluation.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Safety.
The Proposed Amendment
Accordingly, under the authority delegated to me by the
Administrator, the FAA proposes to amend 14 CFR part 39 as follows:
PART 39--AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 [Amended]
2. The FAA amends Sec. 39.13 by adding the following new
airworthiness directive (AD):
Airbus: Docket No. FAA-2005-20500; Directorate Identifier 2004-NM-
235-AD.
[[Page 11172]]
Comments Due Date
(a) The Federal Aviation Administration must receive comments on
this AD action by April 7, 2005.
Affected ADs
(b) None.
Applicability
(c) This AD applies to Airbus Model A320 series airplanes,
certificated in any category; equipped with Hamilton Sundstrand
airborne ground check module (AGCM) having part number 769104,
769105, or 760106 installed; except those airplanes on which Airbus
Modification 27189 has been done in production and on which Airbus
Modification 28413 has not been done.
Unsafe Condition
(d) This AD was prompted by reports of unsuccessful in-flight
ram air turbine (RAT) tests during which a deployed RAT failed to
pressurize the blue hydraulic circuit of the RAT system. We are
issuing this AD to prevent failure of the RAT system during an in-
flight emergency, which could lead to loss of hydraulic and
electrical power and reduced controllability of the airplane.
Compliance
(e) You are responsible for having the actions required by this
AD performed within the compliance times specified, unless the
actions have already been done.
RAT System Bleeding/Functional Test
(f) For airplanes on which maintenance has been performed on the
blue hydraulic circuit as of the effective date of this AD: Within 3
days or 20 flight hours after the effective date of this AD,
whichever occurs first, bleed accumulated air from, or perform a
ground functional test of, the RAT system; by accomplishing all the
actions specified in Airbus All Operators Telex (AOT) A320-29A1112,
Revision 01, dated April 8, 2004. Thereafter, bleed the blue
hydraulic circuit as specified in the AOT within 3 days or 20 flight
hours after performing any maintenance on the blue hydraulic
circuit.
(g) For airplanes on which maintenance has not been performed on
the blue hydraulic circuit as of the effective date of this AD:
Bleed the blue hydraulic circuit as specified in the AOT within 3
days or 20 flight hours after performing any maintenance on the blue
hydraulic circuit.
Replacement of AGCM and Reducer
(h) Within 35 months after the effective date of this AD,
replace the AGCM with a modified and reidentified AGCM; and replace
the reducer with a new reducer as applicable; in accordance with the
Accomplishment Instructions of Airbus Service Bulletin A320-29-1111,
dated June 29, 2004. Replacing the AGCM, and the reducer as
applicable, ends the actions required by paragraphs (f) and (g) of
this AD.
Note 1: Airbus Service Bulletin A320-29-1111 refers to Hamilton
Sundstrand Service Bulletin ERPS13GCM-29-5, dated June 29, 2004, as
an additional source of service information for modifying and
reidentifying the AGCM.
Alternative Methods of Compliance (AMOCs)
(i) The Manager, International Branch, ANM-116, Transport
Airplane Directorate, FAA, has the authority to approve AMOCs for
this AD, if requested in accordance with the procedures found in 14
CFR 39.19.
Related Information
(j) French airworthiness directive F-2004-150, dated September
1, 2004, also addresses the subject of this AD.
Issued in Renton, Washington, on February 28, 2005.
Ali Bahrami,
Manager, Transport Airplane Directorate, Aircraft Certification
Service.
[FR Doc. 05-4408 Filed 3-7-05; 8:45 am]
BILLING CODE 4910-13-P