[Federal Register: March 14, 2005 (Volume 70, Number 48)]
[Rules and Regulations]
[Page 12402-12403]
From the Federal Register Online via GPO Access [wais.access.gpo.gov]
[DOCID:fr14mr05-2]
-----------------------------------------------------------------------
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
14 CFR Part 39
[Docket No. FAA-2004-19542; Directorate Identifier 2003-NM-282-AD;
Amendment 39-14005; AD 2005-05-16]
RIN 2120-AA64
Airworthiness Directives; Airbus Model A300 B4-622R and A300 F4-
622R Airplanes
AGENCY: Federal Aviation Administration (FAA), Department of
Transportation (DOT).
ACTION: Final rule.
-----------------------------------------------------------------------
SUMMARY: The FAA is adopting a new airworthiness directive (AD) for
certain Airbus Model A300 B4-622R and A300 F4-622R airplanes. This AD
requires doing a one-time inspection to determine if lower guide
fittings for the forward doors are installed in the correct positions,
and corrective action if necessary. This AD is prompted by reports that
lower guide fittings for the forward doors were found installed in the
wrong positions at frames 14 and 16A. We are issuing this AD to prevent
difficulty opening the forward doors, which could impede an emergency
evacuation and result in injury to passengers or crewmembers.
DATES: This AD becomes effective April 18, 2005.
The incorporation by reference of a certain publication listed in
the AD is approved by the Director of the Federal Register as of April
18, 2005.
ADDRESSES: For service information identified in this AD, contact
Airbus, 1 Rond Point Maurice Bellonte, 31707 Blagnac Cedex, France.
Docket: The AD docket contains the proposed AD, comments, and any
final disposition. You can examine the AD docket on the Internet at
http://dms.dot.gov, or in person at the Docket Management Facility
office between 9 a.m. and 5 p.m., Monday through Friday, except Federal
holidays. The Docket Management Facility office (telephone (800) 647-
5227) is located on the plaza level of the Nassif Building at the U.S.
Department of Transportation, 400 Seventh Street, SW., room PL-401,
Washington, DC. This docket number is FAA-2004-19542; the directorate
identifier for this docket is 2004-NM-282-AD.
FOR FURTHER INFORMATION CONTACT: Dan Rodina, Aerospace Engineer,
International Branch, ANM-116, FAA, Transport Airplane Directorate,
1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (425)
227-2125; fax (425) 227-1149.
SUPPLEMENTARY INFORMATION: The FAA proposed to amend 14 CFR Part 39
with an AD for certain Airbus Model A300 B4-622R and A300 F4-622R
airplanes. That action, published in the Federal Register on November
5, 2004 (69 FR 64504), proposed to require doing a one-time inspection
to determine if lower guide fittings for the forward doors are
installed in the correct positions, and corrective action if necessary.
Comments
We provided the public the opportunity to participate in the
development of this AD. No comments have been submitted on the proposed
AD or on the determination of the cost to the public.
Conclusion
We have carefully reviewed the available data and determined that
air safety and the public interest require adopting the AD as proposed.
Costs of Compliance
This AD will affect about 25 airplanes of U.S. registry. The
required actions
[[Page 12403]]
will take about 2 work hours per airplane, at an average labor rate of
$65 per work hour. Based on these figures, the estimated cost of the AD
for U.S. operators is $3,250, or $130 per airplane.
Authority for this Rulemaking
Title 49 of the United States Code specifies the FAA's authority to
issue rules on aviation safety. Subtitle I, Section 106, describes the
authority of the FAA Administrator. Subtitle VII, Aviation Programs,
describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in
Subtitle VII, Part A, Subpart III, Section 44701, ``General
requirements.'' Under that section, Congress charges the FAA with
promoting safe flight of civil aircraft in air commerce by prescribing
regulations for practices, methods, and procedures the Administrator
finds necessary for safety in air commerce. This regulation is within
the scope of that authority because it addresses an unsafe condition
that is likely to exist or develop on products identified in this
rulemaking action.
Regulatory Findings
We have determined that this AD will not have federalism
implications under Executive Order 13132. This AD will not have a
substantial direct effect on the States, on the relationship between
the national government and the States, or on the distribution of power
and responsibilities among the various levels of government.
For the reasons discussed above, I certify that this AD:
(1) Is not a ``significant regulatory action'' under Executive
Order 12866;
(2) Is not a ``significant rule'' under DOT Regulatory Policies and
Procedures (44 FR 11034, February 26, 1979); and
(3) Will not have a significant economic impact, positive or
negative, on a substantial number of small entities under the criteria
of the Regulatory Flexibility Act.
We prepared a regulatory evaluation of the estimated costs to
comply with this AD. See the ADDRESSES section for a location to
examine the regulatory evaluation.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by
reference, Safety.
Adoption of the Amendment
0
Accordingly, under the authority delegated to me by the Administrator,
the FAA amends 14 CFR part 39 as follows:
PART 39--AIRWORTHINESS DIRECTIVES
0
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 [Amended]
0
2. The FAA amends Sec. 39.13 by adding the following new airworthiness
directive (AD):
2005-05-16 Airbus: Amendment 39-14005. Docket No. FAA-2004-19542;
Directorate Identifier 2003-NM-282-AD.
Effective Date
(a) This AD becomes effective April 18, 2005.
Affected ADs
(b) None.
Applicability
(c) This AD applies to Airbus Model A300 B4-622R airplanes,
serial numbers 0797 and 0836 inclusive; and Model A300 F4-622R
airplanes, serial numbers 0805 through 0828 inclusive; certificated
in any category.
Unsafe Condition
(d) This AD was prompted by reports that lower guide fittings
for the forward doors were found installed in the wrong positions at
frames 14 and 16A. We are issuing this AD to prevent difficulty
opening the forward doors, which could impede an emergency
evacuation and result in injury to passengers or crewmembers.
Compliance
(e) You are responsible for having the actions required by this
AD performed within the compliance times specified, unless the
actions have already been done.
Inspection and Corrective Action
(f) Within 600 flight hours after the effective date of this AD,
do a one-time detailed inspection to determine if lower guide
fittings for the forward doors are installed in the correct
positions, in accordance with the Accomplishment Instructions of
Airbus Service Bulletin A300-53-6140, Revision 01, dated November
24, 2003.
(1) If the lower guide fittings are installed in the correct
positions: No further action is required by this AD.
(2) If any lower guide fitting is not installed in the correct
position: Before further flight, re-install the lower guide fitting
in the correct position, or replace the lower guide fitting with a
new, improved guide fitting, as applicable, in accordance with the
service bulletin.
Note 1: For the purposes of this AD, a detailed inspection is:
``An intensive examination of a specific item, installation, or
assembly to detect damage, failure, or irregularity. Available
lighting is normally supplemented with a direct source of good
lighting at an intensity deemed appropriate. Inspection aids such as
mirror, magnifying lenses, etc., may be necessary. Surface cleaning
and elaborate procedures may be required.''
Actions Accomplished In Accordance With Previous Issue of Service
Bulletin
(g) Inspections and corrective actions accomplished before the
effective date of this AD in accordance with Airbus Service Bulletin
A300-53-6140, dated June 12, 2003, are considered acceptable for
compliance with the corresponding actions specified in this AD.
No Reporting Requirement
(h) The Accomplishment Instructions of Airbus Service Bulletin
A300-53-6140, Revision 01, dated November 24, 2003, describe
procedures for reporting inspection findings to the manufacturer.
This AD does not require this reporting.
Alternative Methods of Compliance (AMOCs)
(i) The Manager, International Branch, ANM-116, Transport
Airplane Directorate, FAA, has the authority to approve AMOCs for
this AD, if requested in accordance with the procedures found in 14
CFR 39.19.
Related Information
(j) French airworthiness directive 2003-292(B), dated August 6,
2003, also addresses the subject of this AD.
Material Incorporated by Reference
(k) You must use Airbus Service Bulletin A300-53-6140, Revision
01, dated November 24, 2003, excluding Appendix 01, to perform the
actions that are required by this AD, unless the AD specifies
otherwise. The Director of the Federal Register approves the
incorporation by reference of this document in accordance with 5
U.S.C. 552(a) and 1 CFR part 51. For copies of the service
information, contact Airbus, 1 Rond Point Maurice Bellonte, 31707
Blagnac Cedex, France. For information on the availability of this
material at the National Archives and Records Administration (NARA),
call (202) 741-6030, or go to http://www.archives.gov/federal_register/code_of_federal_regulations/ibr_locations.html
.
You may view the AD docket at the Docket Management Facility,
U.S. Department of Transportation, 400 Seventh Street SW., room PL-
401, Nassif Building, Washington, DC.
Issued in Renton, Washington, on March 2, 2005.
Ali Bahrami,
Manager, Transport Airplane Directorate, Aircraft Certification
Service.
[FR Doc. 05-4828 Filed 3-11-05; 8:45 am]
BILLING CODE 4910-13-P