[Federal Register: November 27, 2007 (Volume 72, Number 227)]
[Proposed Rules]
[Page 66089-66091]
From the Federal Register Online via GPO Access [wais.access.gpo.gov]
[DOCID:fr27no07-38]
-----------------------------------------------------------------------
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
14 CFR Part 39
[Docket No. FAA-2007-0249; Directorate Identifier 2007-CE-088-AD]
RIN 2120-AA64
Airworthiness Directives; Alpha Aviation Design Limited Model
R2160 Airplanes
AGENCY: Federal Aviation Administration (FAA), Department of
Transportation (DOT).
ACTION: Notice of proposed rulemaking (NPRM).
-----------------------------------------------------------------------
SUMMARY: We propose to adopt a new airworthiness directive (AD) for the
products listed above that would supersede an existing AD. This
proposed AD results from mandatory continuing airworthiness information
(MCAI) originated by an aviation authority of another country to
identify and correct an unsafe condition on an aviation product. The
MCAI describes the unsafe condition as distortion of the rudder bars
due to rudder control forces during aerobatic operation and nose wheel
steering reaction forces. Rudder bar distortion could result in reduced
control or loss of control. The proposed AD would require actions that
are intended to address the unsafe condition described in the MCAI.
DATES: We must receive comments on this proposed AD by December 27,
2007.
ADDRESSES: You may send comments by any of the following methods:
Federal eRulemaking Portal: Go to http://www.regulations.gov.
Follow the instructions for submitting comments.
Fax: (202) 493-2251.
Mail: U.S. Department of Transportation, Docket
Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New
Jersey Avenue, SE., Washington, DC 20590.
Hand Delivery: U.S. Department of Transportation, Docket
Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New
Jersey Avenue, SE., Washington, DC 20590, between 9 a.m. and 5 p.m.,
Monday through Friday, except Federal holidays.
Examining the AD Docket
You may examine the AD docket on the Internet at http://www.regulations.gov
; or in person at the Docket Management Facility,
U.S. Department of Transportation, Docket Operations, M-30, West
Building Ground Floor, Room W12-140, 1200 New Jersey Avenue, SE.,
Washington, DC 20590.
Docket Management Facility between 9 a.m. and 5 p.m., Monday
through Friday, except Federal holidays. The AD docket contains this
proposed AD, the regulatory evaluation, any comments received, and
other information. The street address for the Docket Office (telephone
(800) 647-5527) is in the ADDRESSES section. Comments will be available
in the AD docket shortly after receipt.
FOR FURTHER INFORMATION CONTACT: Karl Schletzbaum, Aerospace Engineer,
FAA, Small Airplane Directorate, 901 Locust, Room 301, Kansas City,
Missouri 64106; telephone: (816) 329-4146; fax: (816) 329-4090.
SUPPLEMENTARY INFORMATION:
Comments Invited
We invite you to send any written relevant data, views, or
arguments about this proposed AD. Send your comments to an address
listed under the ADDRESSES section. Include ``Docket No. FAA-2007-0249;
Directorate Identifier 2007-CE-088-AD'' at the beginning of your
comments. We specifically invite comments on the overall regulatory,
economic, environmental, and energy aspects of this proposed AD. We
will consider all comments received by the closing date and may amend
this
[[Page 66090]]
proposed AD because of those comments.
We will post all comments we receive, without change, to http://regulations.gov
, including any personal information you provide. We
will also post a report summarizing each substantive verbal contact we
receive about this proposed AD.
Discussion
In 1987, we issued AD 87-08-01, Amendment 39-5601, and in 1999, we
issued AD 99-01-04, Amendment 39-10971. Those two ADs required actions
intended to address an unsafe condition on the products listed above.
We since determined that it is necessary to expand the airplane
applicability of AD 99-01-04 to require rudder bar replacement on Alpha
Aviation Design Limited Model R2160 airplanes, serial numbers 1 through
378. The requirement to replace the rudder bars makes the inspection
requirement of AD 87-08-01 no longer necessary.
The Civil Aviation Authority, which is the aviation authority for
New Zealand, has issued AD DCA/R2000/23B, dated October 25, 2007
(referred to after this as ``the MCAI''), to correct an unsafe
condition for the specified products. The MCAI states that rudder
control forces during aerobatic operation and nose wheel steering
reaction forces may cause rudder bar distortion. Rudder bar distortion
could result in reduced control or loss of control.
The MCAI requires you to replace the left and right rudder bars
with reinforced rudder bars.
You may obtain further information by examining the MCAI in the AD
docket.
Relevant Service Information
Alpha Aviation has issued Service Bulletin AA-SB-27-003, dated
October 19, 2007. The actions described in this service information are
intended to correct the unsafe condition identified in the MCAI.
FAA's Determination and Requirements of the Proposed AD
This product has been approved by the aviation authority of another
country, and is approved for operation in the United States. Pursuant
to our bilateral agreement with this State of Design Authority, they
have notified us of the unsafe condition described in the MCAI and
service information referenced above. We are proposing this AD because
we evaluated all information and determined the unsafe condition exists
and is likely to exist or develop on other products of the same type
design.
Differences Between This Proposed AD and the MCAI or Service
Information
We have reviewed the MCAI and related service information and, in
general, agree with their substance. But we might have found it
necessary to use different words from those in the MCAI to ensure the
AD is clear for U.S. operators and is enforceable. In making these
changes, we do not intend to differ substantively from the information
provided in the MCAI and related service information.
We might also have proposed different actions in this AD from those
in the MCAI in order to follow FAA policies. Any such differences are
highlighted in a NOTE within the proposed AD.
Costs of Compliance
Based on the service information, we estimate that this proposed AD
would affect about 9 products of U.S. registry. We also estimate that
it would take about 3 work-hours per product to comply with the basic
requirements of this proposed AD. The average labor rate is $80 per
work-hour. Required parts would cost about $657 per product.
Based on these figures, we estimate the cost of the proposed AD on
U.S. operators to be $8,073, or $897 per product.
Authority for This Rulemaking
Title 49 of the United States Code specifies the FAA's authority to
issue rules on aviation safety. Subtitle I, section 106, describes the
authority of the FAA Administrator. ``Subtitle VII: Aviation
Programs,'' describes in more detail the scope of the Agency's
authority.
We are issuing this rulemaking under the authority described in
``Subtitle VII, Part A, Subpart III, Section 44701: General
requirements.'' Under that section, Congress charges the FAA with
promoting safe flight of civil aircraft in air commerce by prescribing
regulations for practices, methods, and procedures the Administrator
finds necessary for safety in air commerce. This regulation is within
the scope of that authority because it addresses an unsafe condition
that is likely to exist or develop on products identified in this
rulemaking action.
Regulatory Findings
We determined that this proposed AD would not have federalism
implications under Executive Order 13132. This proposed AD would not
have a substantial direct effect on the States, on the relationship
between the national Government and the States, or on the distribution
of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify this proposed
regulation:
1. Is not a ``significant regulatory action'' under Executive Order
12866;
2. Is not a ``significant rule'' under the DOT Regulatory Policies
and Procedures (44 FR 11034, February 26, 1979); and
3. Will not have a significant economic impact, positive or
negative, on a substantial number of small entities under the criteria
of the Regulatory Flexibility Act.
We prepared a regulatory evaluation of the estimated costs to
comply with this proposed AD and placed it in the AD docket.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Safety.
The Proposed Amendment
Accordingly, under the authority delegated to me by the
Administrator, the FAA proposes to amend 14 CFR part 39 as follows:
PART 39--AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 [Amended]
2. The FAA amends Sec. 39.13 by removing Amendment 39-5601 and
Amendment 39-10971, and adding the following new AD:
Alpha Aviation Design Limited: Docket No. FAA-2007-0249; Directorate
Identifier 2007-CE-088-AD.
Comments Due Date
(a) We must receive comments by December 27, 2007.
Affected ADs
(b) This AD supersedes AD 87-08-01, Amendment 39-5601; and AD
99-01-04, Amendment 39-10971.
Applicability
(c) This AD applies to Model R2160 airplanes, serial numbers 1
through 378, that:
(1) Are certificated in any category; and
(2) Have not installed the improved design rudder bars part
number (P/N) 27.40.31.010 and P/N 27.40.31.020 following either
Avions Pierre Robin Service Bulletin No. 143, dated September 8,
1995, or Alpha Aviation Service Bulletin AA-SB-27-003, dated October
19, 2007.
Subject
(d) Air Transport Association of America (ATA) Code 27: Flight
Controls.
[[Page 66091]]
Reason
(e) The mandatory continuing airworthiness information (MCAI)
states that rudder control forces during aerobatic operation and
nose wheel steering reaction forces may cause rudder bar distortion.
Rudder bar distortion could result in reduced or loss of control.
The MCAI requires you to replace the left and right rudder bars with
reinforced rudder bars.
Restatement of Requirements of AD 99-01-04
(f) For airplanes with serial numbers 250 through 378: Unless
already done, within the next 50 hours time-in-service (TIS) after
March 12, 1999 (the effective date of AD 99-01-04) replace the left
and right rudder bars, part number (P/N) 27.23.01.010 (left) and P/N
27.23.01.020 (right), with the reinforced rudder bars, P/N
27.40.31.010 (left) and P/N 27.40.31.020 (right) or FAA-equivalent
part numbers, following Alpha Aviation Service Bulletin AA-SB-27-
003, dated October 19, 2007.
New Requirements of This AD: Actions and Compliance
(g) For airplanes with serial numbers 1 through 249: Unless
already done, within the next 50 hours TIS after the effective date
of this AD or within the next 3 months after the effective date of
this AD, whichever occurs first, replace the left and right rudder
bars, P/N 27.23.05.010 (left) and P/N 27.23.05.020 (right), with the
reinforced rudder bars, P/N 27.40.31.010 (left) and P/N 27.40.31.020
(right) or FAA-equivalent part numbers, following Alpha Aviation
Service Bulletin AA-SB-27-003, dated October 19, 2007.
FAA AD Differences
Note: This AD differs from the MCAI and/or service information
as follows: No differences.
Other FAA AD Provisions
(h) The following provisions also apply to this AD:
(1) Alternative Methods of Compliance (AMOCs): The Manager,
Standards Office, FAA, has the authority to approve AMOCs for this
AD, if requested using the procedures found in 14 CFR 39.19. Send
information to ATTN: Karl Schletzbaum, Aerospace Engineer, FAA,
Small Airplane Directorate, 901 Locust, Room 301, Kansas City,
Missouri 64106; telephone: (816) 329-4146; fax: (816) 329-4090.
Before using any approved AMOC on any airplane to which the AMOC
applies, notify your appropriate principal inspector (PI) in the FAA
Flight Standards District Office (FSDO), or lacking a PI, your local
FSDO.
(2) Airworthy Product: For any requirement in this AD to obtain
corrective actions from a manufacturer or other source, use these
actions if they are FAA-approved. Corrective actions are considered
FAA-approved if they are approved by the State of Design Authority
(or their delegated agent). You are required to assure the product
is airworthy before it is returned to service.
(3) Reporting Requirements: For any reporting requirement in
this AD, under the provisions of the Paperwork Reduction Act (44
U.S.C. 3501 et seq.), the Office of Management and Budget (OMB) has
approved the information collection requirements and has assigned
OMB Control Number 2120-0056.
Related Information
(i) Refer to New Zealand Civil Aviation Authority AD DCA/R2000/
23B, dated October 25, 2007; and Alpha Aviation Service Bulletin AA-
SB-27-003, dated October 19, 2007, for related information.
Issued in Kansas City, Missouri, on November 20, 2007.
Kim Smith,
Manager, Small Airplane Directorate, Aircraft Certification Service.
[FR Doc. E7-23017 Filed 11-26-07; 8:45 am]
BILLING CODE 4910-13-P