[Federal Register: January 22, 2007 (Volume 72, Number 13)]
[Notices]
[Page 2681-2682]
From the Federal Register Online via GPO Access [wais.access.gpo.gov]
[DOCID:fr22ja07-60]
-----------------------------------------------------------------------
ENVIRONMENTAL PROTECTION AGENCY
[EPA-HQ-OECA-2006-0433, FRL-8271-8]
Agency Information Collection Activities; Submission to OMB for
Review and Approval; Comment Request; NESHAP for Plastic Parts and
Products Surface (Renewal); EPA ICR Number 2044.03; OMB Control Number
2060-0537
AGENCY: Environmental Protection Agency.
ACTION: Notice.
-----------------------------------------------------------------------
SUMMARY: In compliance with the Paperwork Reduction Act (PRA) (44
U.S.C. 3501 et seq.), this document announces that an Information
Collection Request (ICR) has been forwarded to the Office of Management
and Budget (OMB) for review and approval. This is a request to renew an
existing approved collection. The ICR which is abstracted below
describes the nature of the information collection and its estimated
burden and cost.
DATES: Additional comments may be submitted on or before February 21,
2007.
ADDRESSES: Submit your comments, referencing docket ID number EPA-HQ-
OECA-2006-0433, to (1) EPA online using http://www.regulations.gov (our preferred method), by e-mail to docket.oeca@epa.gov, or by mail to: EPA
Docket Center (EPA/DC), Environmental Protection Agency, Enforcement
and Compliance Docket and Information Center, mail code 2201T, 1200
Pennsylvania Avenue, NW., Washington, DC 20460, and (2) OMB at: Office
of Information and Regulatory Affairs, Office of Management and Budget
(OMB), Attention: Desk Officer for EPA, 725 17th Street, NW.,
Washington, DC 20503.
FOR FURTHER INFORMATION CONTACT: Leonard Lazarus, Compliance Assessment
and Media Programs Division (CAMPD), Office of Compliance, (2223A),
Environmental
[[Page 2682]]
Protection Agency, 1200 Pennsylvania Avenue, NW., Washington, DC 20460;
telephone number: (202) 564-6369; fax number: (202) 564-0050; e-mail
address: lazarus.leonard@epa.gov.
SUPPLEMENTARY INFORMATION: EPA has submitted the following ICR to OMB
for review and approval according to the procedures prescribed in 5 CFR
1320.12. On June 21, 2006 (71 FR 35652), EPA sought comments on this
ICR pursuant to 5 CFR 1320.8(d). EPA received no comments. Any
additional comments on this ICR should be submitted to EPA and OMB
within 30 days of this notice.
EPA has established a public docket for this ICR under docket ID
number EPA-HQ-OECA-2006-0433, which is available for online viewing at
http://www.regulations.gov, in person viewing at the Enforcement and
Compliance Docket and Information Center in the EPA Docket Center (EPA/
DC), EPA West, Room 3334, 1301 Constitution Avenue, NW., Washington,
DC. The EPA/DC Public Reading Room is open from 8 a.m. to 4:30 p.m.,
Monday through Friday, excluding legal holidays. The telephone number
for the Reading Room is (202) 566-1744, and the telephone number for
the Enforcement and Compliance Docket and Information Center Docket is
(202) 566-1514.
Use EPA's electronic docket and comment system at http://www.regulations.gov
, to submit or view public comments, access the
index listing of the contents of the docket, and to access those
documents in the docket that are available electronically. Once in the
system, select ``docket search,'' then key in the docket ID number
identified above. Please note that EPA's policy is that public
comments, whether submitted electronically or in paper, will be made
available for public viewing at http://www.regulations.gov as EPA
receives them and without change, unless the comment contains
copyrighted material, CBI, or other information whose public disclosure
is restricted by statute. For further information about the electronic
docket, go to http://www.regulations.gov.
Title: NESHAP for Plastic Parts and Products Surface Coating
(Renewal).
ICR Numbers: EPA ICR Number 2044.03, OMB Control Number 2060-0537.
ICR Status: This ICR is scheduled to expire on January 31, 2007.
Under OMB regulations, the Agency may continue to conduct or sponsor
the collection of information while this submission is pending at OMB.
An Agency may not conduct or sponsor, and a person is not required to
respond to, a collection of information, unless it displays a currently
valid OMB control number. The OMB control numbers for EPA's regulations
in title 40 of the CFR, after appearing in the Federal Register when
approved, are listed in 40 CFR part 9, are displayed either by
publication in the Federal Register or by other appropriate means, such
as on the related collection instrument or form, if applicable. The
display of OMB control numbers in certain EPA regulations is
consolidated in 40 CFR part 9.
Abstract: Respondents are owners, or operators of plastic parts and
products surface coating operations. Owners, or operators of the
affected facilities described must make initial reports when a source
becomes subject to the standard, conduct and report on a performance
test, demonstrate and report on continuous monitor performance, and
maintain records of the occurrence and duration of any startup,
shutdown, or malfunction in the operation of an affected facility.
Semiannual reports of excess emissions are required. These
notifications, reports, and records are essential in determining
compliance and are required, in general, of all sources subject to
National Emission Standards for Hazardous Air Pollutants (NESHAP). Any
owner, or operator subject to the provisions of this part shall
maintain a file of these measurements and retain the file for at least
five years following the date of such measurements, maintenance
reports, and records. All reports are sent to the delegated state, or
local authority. In the event that there is no such delegated
authority, the reports are sent directly to the EPA regional office.
An agency may not conduct, or sponsor, and a person is not required
to respond to, a collection of information unless it displays a
currently valid OMB control number. The OMB control numbers for EPA's
regulations in 40 CFR are listed in 40 CFR part 9 and are identified on
the form and/or instrument, if applicable.
Burden Statement: The annual public reporting and recordkeeping
burden for this collection of information is estimated to average 77
hours per response. Burden means the total time, effort, or financial
resources expended by persons to generate, maintain, retain, or
disclose or provide information to or for a Federal agency. This
includes the time needed to review instructions; develop, acquire,
install, and utilize technology and systems for the purposes of
collecting, validating, and verifying information, processing and
maintaining information, and disclosing and providing information;
adjust the existing ways to comply with any previously applicable
instructions and requirements which have subsequently changed; train
personnel to be able to respond to a collection of information; search
data sources; complete and review the collection of information; and
transmit or otherwise disclose the information.
Respondents/Affected Entities: Owners or operators of plastic parts
and products surface coating operations.
Estimated Number of Respondents: 828.
Frequency of Response: Initially, Semiannually, On Occasion.
Estimated Total Annual Hour Burden: 321,393.
Estimated Total Annual Cost: $ 27,220,752, includes $16,000
capital/startup costs and $248,400 annualized O&M costs.
Changes in the Estimates: There is an increase of 278,860 hours in
the total estimated burden currently identified in the OMB Inventory of
Approved ICR Burdens. The increase in burden reflects the need for
facilities to be in compliance with the rule requirements prior to the
date of this ICR, and a revision in the number of facilities subject to
the NESHAP. The increase in Operations and Maintenance cost is due to
installation and maintenance of equipment used to verify compliance
with the rule requirements.
Dated: January 12, 2007.
Oscar Morales,
Director, Collection Strategies Division.
[FR Doc. E7-817 Filed 1-19-07; 8:45 am]
BILLING CODE 6560-50-P