[Federal Register Volume 73, Number 119 (Thursday, June 19, 2008)] [Notices] [Pages 34927-34929] From the Federal Register Online via the Government Publishing Office [www.gpo.gov] [FR Doc No: E8-13891] ----------------------------------------------------------------------- ENVIRONMENTAL PROTECTION AGENCY [EPA-HQ-OECA-2007-0065; FRL-8683-2] Agency Information Collection Activities; Submission to OMB for Review and Approval; Comment Request; NESHAP for Metal Coil Surface Coating Plants (Renewal), EPA ICR Number 1957.05, OMB Control Number 2060-0487 AGENCY: Environmental Protection Agency (EPA). [[Page 34928]] ACTION: Notice. ----------------------------------------------------------------------- SUMMARY: In compliance with the Paperwork Reduction Act (44 U.S.C. 3501 et seq.), this document announces that an Information Collection Request (ICR) has been forwarded to the Office of Management and Budget (OMB) for review and approval. This is a request to renew an existing approved collection. The ICR which is abstracted below describes the nature of the collection and the estimated burden and cost. DATES: Additional comments may be submitted on or before July 21, 2008. ADDRESSES: Submit your comments, referencing docket ID number EPA-HQ- OECA-2007-0065, to (1) EPA online using http://www.regulations.gov (our preferred method), or by e-mail to [email protected], or by mail to: EPA Docket Center (EPA/DC), Environmental Protection Agency, Enforcement and Compliance Docket and Information Center, mail code 2201T, 1200 Pennsylvania Avenue, NW., Washington, DC 20460, and (2) OMB at: Office of Information and Regulatory Affairs, Office of Management and Budget (OMB), Attention: Desk Officer for EPA, 725 17th Street, NW., Washington, DC 20503. FOR FURTHER INFORMATION CONTACT: Learia Williams, Compliance Assessment and Media Programs Division, Office of Compliance, Mail Code 2223A, Environmental Protection Agency, 1200 Pennsylvania Avenue, NW., Washington, DC 20460; telephone number: (202) 564-4113; fax number: (202) 564-0050; e-mail address: [email protected]. SUPPLEMENTARY INFORMATION: EPA has submitted the following ICR to OMB for review and approval according to the procedures prescribed in 5 CFR 1320.12. On March 9, 2007 (72 FR 10735), EPA sought comments on this ICR pursuant to 5 CFR 1320.8(d). EPA received no comments. Any additional comments on this ICR should be submitted to EPA and OMB within 30 days of this notice. EPA has established a public docket for this ICR under docket ID number EPA-HQ-OECA-2007-0065, which is available for public viewing online at http://www.regulations.gov, in person viewing at the Enforcement and Compliance Docket in the EPA Docket Center (EPA/DC), EPA West, Room 3334, 1301 Constitution Avenue, NW., Washington, DC. The EPA Docket Center Public Reading Room is open from 8:30 a.m. to 4:30 p.m., Monday through Friday, excluding legal holidays. The telephone number for the Reading Room is (202) 566-1744, and the telephone number for the Enforcement and Compliance Docket is (202) 566-1927. Use EPA's electronic docket and comment system at http://www.regulations.gov, to submit or view public comments, access the index listing of the contents of the docket, and to access those documents in the docket that are available electronically. Once in the system, select ``docket search,'' then key in the docket ID number identified above. Please note that EPA's policy is that public comments, whether submitted electronically or in paper, will be made available for public viewing at http://www.regulations.gov, as EPA receives them and without change, unless the comment contains copyrighted material, Confidential Business Information (CBI), or other information whose public disclosure is restricted by statute. For further information about the electronic docket, go to www.regulations.gov. Title: NESHAP for Metal Coil Surface Coating Plants (Renewal). ICR Numbers: EPA ICR Number 1957.05, OMB Control Number 2060-0487 ICR Status: The National Emission Standards for Hazardous Air Pollutants (NESHAP) for Metal Coil Surface Coating Plants were proposed (65 FR 44616) on July 18, 2000, promulgated (67 FR 39812) on June 10, 2002, and amended (68 FR 12592) on March 17, 2003. These standards apply to each facility operating a coil coating line and that is a major source of hazardous air pollutants (HAPs). This coating line coats metal coil of thicknesses less than, greater than, or equal to 0.15 millimeters (0.006 inches) thick. Abstract: Owners or operators must submit notification reports upon construction or reconstruction of any metal coil surface coating plant. Semiannual reports for periods of operation during which the emission limitation has exceeded, or reports certifying that no exceedances have occurred, also are required. Owners and operators must submit notification reports upon the construction, reconstruction, or modification of any metal coil surface coating plant. Also, required is a one-time-only initial notification for new and reconstructed sources. Owners or operators of metal coil surface coating plants subject to the rule must maintain a file of these measurements, and retain the file for at least five years following the date of such measurements, maintenance reports, and records. All reports are sent to the delegated state or local authority. In the event that there is no such delegated authority, the reports are sent directly to the EPA regional office. This information is being collected to assure compliance with 40 CFR part 63, subpart SSSS, as authorized in section 112 and 114(a) of the Clean Air Act. The required information consists of emissions data and other information that have been determined to be private. An Agency may not conduct or sponsor, and a person is not required to respond to, a collection of information unless it displays a currently valid OMB Control Number. The OMB Control Number for EPA's regulations listed in 40 CFR part 9 and 48 CFR chapter 15, are identified on the form and/or instrument, if applicable. Burden Statement: The annual public reporting and recordkeeping burden for this collection of information estimated to average 119 hours per response. Burden means the total time, effort, or financial resources expended by persons to generate, maintain, retain, or disclose and provide information to or for a Federal agency. This includes the time needed to review instructions; develop, acquire, install, and utilize technology and systems for the purposes of collecting, validating, and verifying information, processing and maintaining information, and disclosing and providing information. All existing ways will have to adjust to comply with any previously applicable instructions and requirements that have subsequently changed; train personnel to be able to respond to a collection of information; search data sources; complete and review the collection of information; and transmit or otherwise disclose the information. Respondents/Affected Entities: Metal coil surface coating plants. Estimated Number of Respondents: 89. Frequency of Response: Weekly, annually, semiannually, initially and occasionally. Estimated Total Annual Hour Burden: 19,901. Estimated Total Annual Cost: $1,588,365 for labor costs, inclusive, plus O&M costs of $3,648 and $00.00 for annualized capital costs. Changes in the Estimates: There is no change in the labor hours or cost in this ICR compared to the previous ICR. This is due to two considerations. First, the regulations have not changed over the past three years and are not anticipated to change over the next three years. Secondly, the growth rate for the industry is very low, negative or non-existent, so there is no significant change in the overall burden. It should be noted that the previous ICR rounded the burden cost down to the nearest one [[Page 34929]] thousand. In this ICR, the exact cost figure is reported which results in an apparent increase in the cost when, in fact, no increase has occurred. Since there are no changes in the regulatory requirements and there is no significant industry growth, the labor hours and cost figures in the previous ICR was used in this ICR, and there is no change in burden to industry. Dated: June 5, 2008. Sara Hisel-McCoy, Director, Collection Strategies Division. [FR Doc. E8-13891 Filed 6-18-08; 8:45 am] BILLING CODE 6560-50-P