[Federal Register Volume 73, Number 30 (Wednesday, February 13, 2008)]
[Notices]
[Pages 8374-8375]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: E8-2624]
-----------------------------------------------------------------------
DEPARTMENT OF LABOR
Occupational Safety and Health Administration
[Docket No. OSHA-2008-0008]
Design of Cave-in Protection Systems; Extension of the Office of
Management and Budget's (OMB) Approval of Information Collection
(Paperwork) Requirements
AGENCY: Occupational Safety and Health Administration (OSHA), Labor.
ACTION: Request for public comment.
-----------------------------------------------------------------------
SUMMARY: OSHA solicits comments concerning its request for an extension
of the information collection requirements contained in 29 CFR
1926.652, Requirements for Protective Systems.
DATES: Comments must be submitted (postmarked, sent, or received) by
April 14, 2008.
ADDRESSES: Electronically: You may submit comments and attachments
electronically at http://www.regulations.gov, which is the Federal
eRulemaking Portal. Follow the instructions online for submitting
comments.
Facsimile: If your comments, including attachments, are not longer
than 10 pages, you may fax them to the OSHA Docket Office at (202) 693-
1648.
Mail, hand delivery, express mail, messenger, or courier service:
When using this method, you must submit three copies of your comments
and attachments to the OSHA Docket Office, OSHA Docket No. OSHA-2008-
0008, U.S. Department of Labor, Occupational Safety and Health
Administration, Room N-2625, 200 Constitution Avenue, NW., Washington,
DC 20210. Deliveries (hand, express mail, messenger, and courier
service) are accepted during the Department of Labor's and Docket
Office's normal business hours, 8:15 a.m. to 4:45 p.m., e.t.
Instructions: All submissions must include the Agency name and OSHA
docket number for the ICR (OSHA-2008-0008). All comments, including any
personal information you provide, are placed in the public docket
without change, and may be made available online at http://www.regulations.gov. For further information on submitting comments see
the ``Public Participation'' heading in the section of this notice
titled SUPPLEMENTARY INFORMATION.
Docket: To read or download comments or other material in the
docket, go to http://www.regulations.gov or the OSHA Docket Office at
the address above. All documents in the docket (including this Federal
Register notice) are listed in the http://www.regulations.gov index;
however, some information (e.g., copyrighted material) is not publicly
available to read or download through the Web site. All submissions,
including copyrighted material, are available for inspection and
copying at the OSHA Docket Office. You may also contact Michael Buchet
at the address below to obtain a copy of the ICR.
FOR FURTHER INFORMATION CONTACT: Michael Buchet, Directorate of
Construction, OSHA, U.S. Department of Labor, Room N-3468, 200
Constitution Avenue, NW., Washington, DC 20210; telephone (202) 693-
2020.
SUPPLEMENTARY INFORMATION:
I. Background
The Department of Labor, as part of its continuing effort to reduce
paperwork and respondent (i.e., employer) burden, conducts a
preclearance consultation program to provide the public with an
opportunity to comment on proposed and continuing information
collection requirements in accordance with the Paperwork Reduction Act
of 1995 (44 U.S.C. 3506(c)(2)(A)). This program ensures that
information is in the desired format, reporting burden (time and costs)
is minimal, collection instruments are clearly understood, and OSHA's
estimate of the information collection burden is accurate. The
Occupational Safety and Health Act of 1970 (the OSH Act) (29 U.S.C.
651, et seq.) authorizes information collection by employers as
necessary or appropriate for enforcement of the Act or for developing
information regarding the causes and prevention of occupational
injuries, illnesses, and accidents (29 U.S.C. 657). The OSH Act also
requires that OSHA obtain such information with minimum burden upon
employers, especially those operating small businesses, and to reduce
to the maximum extent feasible unnecessary duplication of efforts in
obtaining information (29 U.S.C. 657).
Paragraphs (b) and (c) of Sec. 1926.652 (``Requirements for
Protective Systems''; the ``Standard'') contain paperwork requirements
that impose burden hours or costs on employers. These paragraphs
require employers to use protective systems to prevent cave-ins during
excavation work; these systems include sloping the side of the trench,
benching the soil away from the excavation, or using a support system
or shield (such as a trench box). The Standard specifies allowable
configuration and slopes for excavations, and provides appendices to
assist employers in designing protective systems. However, paragraphs
(b)(3) and (b)(4) of the Standard permit employers to design sloping or
benching systems based on tabulated data (Option 1), or to use a design
approved by a registered professional engineer (Option 2).
Under Option 1, employers must provide the tabulated data in a
written form that also identifies the registered professional engineer
who approved the data and the parameters used to select the sloping or
benching system drawn from the data, as well as the limitations of the
data (including the magnitude and configuration of slopes determined to
be safe); the document must also provide any explanatory information
necessary to select the correct benching system based on the data.
Option 2
[[Page 8375]]
requires employers to develop a written design approved by a registered
professional engineer. The design information must include the
magnitude and configuration of the slopes determined to be safe, and
the identity of the registered professional engineer who approved the
design.
Paragraphs (c)(2), (c)(3), and (c)(4) allow employers to design
support systems, shield systems, and other protective systems based on
tabulated data provided by a system manufacturer (Option 3) or obtained
from other sources and approved by a registered professional engineer
(Option 4); they can also use a design approved by a registered
professional engineer (Option 5). If they select Option 3, employers
must complete a written form that provides the manufacturer's
specifications, recommendations, and limitations, as well as any
deviations approved by the manufacturer. The paperwork requirements of
Option 4 are the same as for Option 1. Option 5 requires a written form
that provides a plan indicting the sizes, types, and configurations of
the materials used in the protective system and the identity of the
registered professional engineer who approved the design.
Each of these provisions requires employers to maintain a copy of
the documents described in these options at the jobsite during
construction. After construction is complete, employers may store the
documents off-site provided they make them available to an OSHA
compliance officer on request. These documents provide both the
employer and the compliance officer with information needed to
determine if the selection and design of a protective system are
appropriate to the excavation work, thereby assuring employees of
maximum protection against cave-ins.
II. Special Issues for Comment
OSHA has a particular interest in comments on the following issues:
Whether the proposed information collection requirements
are necessary for the proper performance of the Agency's functions,
including whether the information is useful;
The accuracy of OSHA's estimate of the burden (time and
costs) of the information collection requirements, including the
validity of the methodology and assumptions used;
The quality, utility, and clarity of the information
collected; and
Ways to minimize the burden on employers who must comply;
for example, by using automated or other technological information
collection and transmission techniques.
III. Proposed Actions
The Agency is requesting that OMB extend its approval of the
information collection requirements contained in 29 CFR 1926.652,
Requirements for Protective Systems. The Agency will summarize the
comments submitted in response to this notice and will include this
summary in the request to OMB to extend the approval of the information
collection requirements contained in the Standard.
Type of Review: Extension of currently approved information
collection requirements.
Title: Design of Cave-in Protection System.
OMB Number: 1218-0137.
Affected Public: Business or other for-profits.
Number of Respondents: 20,000.
Frequency of Response: On occasion.
Total Responses: 20,000.
Average Time per Response: Two hours to obtain information on the
design of cave-in protection systems.
Estimated Total Burden Hours: 20,022 hours.
Estimated Cost (Operation and Maintenance): $815,400.
IV. Public Participation--Submission of Comments on this Notice and
Internet Access to Comments and Submissions
You may submit comments in response to this document as follows:
(1) Electronically at http://www.regulations.gov, which is the Federal
eRulemaking Portal; (2) by facsimile (FAX); or (3) by hard copy. All
comments, attachments, and other material must identify the Agency name
and the OSHA docket number for the ICR (Docket No. OSHA-2008-0008). You
may supplement electronic submissions by uploading document files
electronically. If you wish to mail additional materials in reference
to an electronic or facsimile submission, you must submit them to the
OSHA Docket Office (see the section of this notice titled ADDRESSES).
The additional materials must clearly identify your electronic comments
by your name, date, and the docket number so the Agency can attach them
to your comments.
Because of security procedures, the use of regular mail may cause a
significant delay in the receipt of comments. For information about
security procedures concerning the delivery of materials by hand,
express delivery, messenger, or courier service, please contact the
OSHA Docket Office at (202) 693-2350 (TTY (877) 889-5627).
Comments and submissions are posted without change at http://www.regulations.gov. Therefore, OSHA cautions commenters about
submitting personal information such as social security numbers and
date of birth. Although all submissions are listed in the http://www.regulations.gov index, some information (e.g., copyrighted
material) is not publicly available to read or download through this
Web site. All submissions, including copyrighted material, are
available for inspection and copying at the OSHA Docket Office.
Information on using the http://www.regulations.gov Web site to submit
comments and access the docket is available at the Web site's ``User
Tips'' link. Contact the OSHA Docket Office for information about
materials not available through the Web site, and for assistance in
using the Internet to locate docket submissions.
V. Authority and Signature
Edwin G. Foulke, Jr., Assistant Secretary of Labor for Occupational
Safety and Health, directed the preparation of this notice. The
authority for this notice is the Paperwork Reduction Act of 1995 (44
U.S.C. 3506, et seq.) and Secretary of Labor's Order No. 5-2007 (72 FR
31159).
Signed at Washington, DC, on February 7, 2008.
Edwin G. Foulke, Jr.,
Assistant Secretary of Labor for Occupational Safety and Health.
[FR Doc. E8-2624 Filed 2-12-08; 8:45 am]
BILLING CODE 4510-26-P