[Federal Register Volume 74, Number 115 (Wednesday, June 17, 2009)]
[Notices]
[Pages 28696-28698]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: E9-14231]
-----------------------------------------------------------------------
ENVIRONMENTAL PROTECTION AGENCY
[FRL-8914-7]
Office of Research and Development; Ambient Air Monitoring
Reference and Equivalent Methods: Designation of Four New Equivalent
Methods
AGENCY: Environmental Protection Agency.
[[Page 28697]]
ACTION: Notice of the designation of four new equivalent methods for
monitoring ambient air quality.
-----------------------------------------------------------------------
SUMMARY: Notice is hereby given that the Environmental Protection
Agency (EPA) has designated, in accordance with 40 CFR Part 53, four
new equivalent methods for measuring concentrations of PM2.5
in the ambient air.
FOR FURTHER INFORMATION CONTACT: Surender Kaushik, Human Exposure and
Atmospheric Sciences Division (MD-D205-03), National Exposure Research
Laboratory, U.S. EPA, Research Triangle Park, North Carolina 27711.
Phone: (919) 541-5691, e-mail: [email protected].
SUPPLEMENTARY INFORMATION: In accordance with regulations at 40 CFR
Part 53, the EPA evaluates various methods for monitoring the
concentrations of those ambient air pollutants for which EPA has
established National Ambient Air Quality Standards (NAAQSs) as set
forth in 40 CFR Part 50. Monitoring methods that are determined to meet
specific requirements for adequacy are designated by the EPA as either
reference methods or equivalent methods (as applicable), thereby
permitting their use under 40 CFR Part 58 by States and other agencies
for determining compliance with the NAAQSs.
The EPA hereby announces the designation of four new equivalent
methods for measuring concentrations of PM2.5 in the ambient
air. These designations are made under the provisions of 40 CFR Part
53, as amended on October 17, 2006 (71 FR 61271).
Two of the new equivalent methods for PM2.5 are
automated methods (analyzers) utilizing the measurement principle based
on filter sample collection and analysis by an inertial micro-balance
that provides direct mass measurements in near real time. Separation of
the PM2.5 particle size range is by a cyclone in the first
method and by a virtual impactor in the second method. These two newly
designated equivalent methods are identified as follows:
EQPM-0609-181, ``Thermo Scientific TEOM[supreg] 1400a Ambient
Particular Monitor with Series 8500C FDMS\TM\,'' configured for
PM2.5 with the US EPA PM10 inlet specified in 40
CFR Part 50, Appendix L, Figs. L-2 thru L-19, followed by a BGI Inc.
Very Sharp Cut Cyclone (VSCC\TM\) particle size separator, operated
with a total actual flow of 16.67/min., loaded with Series FDMS (Filter
Dynamics Measurement System) 8500 module operating software and an FDMS
kit, and operated with firmware version 3.20 and later, according to
the Thermo Scientific TEOM[supreg] 1400a Ambient Particular Monitor
with Series 8500C FDMS\TM\ operating manual.
EQPM-0609-182, ``Thermo Scientific TEOM[supreg] 1405-DF Dichotomous
Ambient Particular Monitor with FDMS[supreg],'' configured for dual
filter sampling of fine (PM2.5) and coarse particles using
the US EPA PM10 inlet specified in 40 CFR Part 50, Appendix
L, Figs. L-2 thru L-19 and a virtual impactor, with a total flow rate
of 16.67 L/min, fine sample flow of 3 L/min, and coarse sample flow
rate of 1.67 L/min, and operating with firmware version 1.50 and later,
operated with or without external enclosures, and operated in
accordance with the Thermo Scientific TEOM[supreg] 1405-DF Dichotomous
Ambient Particulate Monitor Instruction Manual (designated for
PM2.5 measurements only).
The other two new equivalent methods for PM2.5 are
automated methods (analyzers) utilizing the measurement principle based
on cyclonic separation of the PM2.5 particle size range with
filter sample collection and analysis by beta attenuation. The newly
designated equivalent methods are identified as follows:
EQPM-0609-183, ``Thermo Scientific FH62C14-DHS Continuous Ambient
Particle Monitor'' operated at a flow rate of 16.67 liters per minute
for 24-hour average measurements configured for PM2.5 with a
louvered PM10 size selective inlet as specified in 40 CFR
Part 50, Appendix L, Figs. L-2 through L-19, a PM2.5 BGI
Inc. Very Sharp Cut Cyclone (VSCC\TM\) particle size separator, inlet
connector, sample tube, DHS heater with 35% RH threshold, mass foil
kit, GF10 filter tape, 8-hour filter change, and operational
calibration and servicing as outlined in the FH62C14-DHS Continuous
Ambient Particulate Monitor operating manual.
EQPM-0609-184, ``Thermo Scientific Model 5030 SHARP Monitor'' operated
at a flow rate of 16.67 liters per minute for 24-hour average
measurements configured for PM2.5 with a louvered
PM10 size selective inlet as specified in 40 CFR Part 50,
Appendix L, Figs. L-2 through L-19, a PM2.5 BGI Inc. Very
Sharp Cut Cyclone (VSCC\TM\) particle size separator, inlet connector,
sample tube, DHS heater with 35% RH threshold, mass foil kit, GF10
filter tape, nephelometer zeroing kit, 8-hour filter change, and
operational calibration and servicing as outlined in the Model 5030
SHARP instructional manual.
Applications for equivalent method determinations for these
candidate methods were received by the EPA on June 30, 2008 and July
14, 2008. The monitors are commercially available from the applicant,
Thermo Fisher Scientific, Air Quality Instruments, Environmental
Instruments Division, 27 Forge Parkway, Franklin, MA 02038.
Test analyzers representative of these methods have been tested in
accordance with the applicable test procedures specified in 40 CFR Part
53 (as amended on October 17, 2006). After reviewing the results of
those tests and other information submitted by the applicant in the
respective applications, EPA has determined, in accordance with Part
53, that these methods should be designated as equivalent methods. The
information submitted by the applicant in the respective applications
will be kept on file, either at EPA's National Exposure Research
Laboratory, Research Triangle Park, North Carolina 27711 or in an
approved archive storage facility, and will be available for inspection
(with advance notice) to the extent consistent with 40 CFR Part 2
(EPA's regulations implementing the Freedom of Information Act).
As designated equivalent methods, these methods are acceptable for
use by states and other air monitoring agencies under the requirements
of 40 CFR Part 58, Ambient Air Quality Surveillance. For such purposes,
each method must be used in strict accordance with the operation or
instruction manual associated with the method and subject to any
specifications and limitations (e.g., configuration or operational
settings) specified in the applicable designated method description
(see the identifications of the methods above).
Use of the method should also be in general accordance with the
guidance and recommendations of applicable sections of the ``Quality
Assurance Handbook for Air Pollution Measurement Systems, Volume I,''
EPA/600/R-94/038a and ``Quality Assurance Handbook for Air Pollution
Measurement Systems, Volume II, Ambient Air Quality Monitoring
Program'' EPA-454/B-08-003, December, 2008 (available at http://www.epa.gov/ttn/amtic/qabook.html). Vendor modifications of a
designated equivalent method used for purposes of Part 58 are permitted
only with prior approval of the EPA, as provided in Part
[[Page 28698]]
53. Provisions concerning modification of such methods by users are
specified under Section 2.8 (Modifications of Methods by Users) of
Appendix C to 40 CFR Part 58.
In general, a method designation applies to any sampler or analyzer
which is identical to the sampler or analyzer described in the
application for designation. In some cases, similar samplers or
analyzers manufactured prior to the designation may be upgraded or
converted (e.g., by minor modification or by substitution of the
approved operation or instruction manual) so as to be identical to the
designated method and thus achieve designated status. The manufacturer
should be consulted to determine the feasibility of such upgrading or
conversion.
Part 53 requires that sellers of designated reference or equivalent
method analyzers or samplers comply with certain conditions. These
conditions are specified in 40 CFR 53.9.
Aside from occasional breakdowns or malfunctions, consistent or
repeated noncompliance with any of these conditions should be reported
to: Director, Human Exposure and Atmospheric Sciences Division (MD-
E205-01), National Exposure Research Laboratory, U.S. Environmental
Protection Agency, Research Triangle Park, North Carolina 27711.
Designation of these new equivalent methods is intended to assist
the States in establishing and operating their air quality surveillance
systems under 40 CFR Part 58. Questions concerning the commercial
availability or technical aspects of the method should be directed to
the applicant.
Dated: June 1, 2009.
Jewel F. Morris,
Acting Director, National Exposure Research Laboratory.
[FR Doc. E9-14231 Filed 6-16-09; 8:45 am]
BILLING CODE 6560-50-P