[Federal Register: February 24, 2009 (Volume 74, Number 35)]
[Rules and Regulations]
[Page 8148-8150]
From the Federal Register Online via GPO Access [wais.access.gpo.gov]
[DOCID:fr24fe09-3]
=======================================================================
-----------------------------------------------------------------------
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
14 CFR Part 39
[Docket No. FAA-2008-1078 Directorate Identifier 2008-CE-051-AD;
Amendment 39-15814; AD 2009-04-08]
RIN 2120-AA64
Airworthiness Directives; BURKHART GROB LUFT--UND RAUMFAHRT GmbH
& CO KG G103 Series Gliders
AGENCY: Federal Aviation Administration (FAA), Department of
Transportation (DOT).
ACTION: Final rule.
-----------------------------------------------------------------------
SUMMARY: We are adopting a new airworthiness directive (AD) for the
products listed above. This AD results from mandatory continuing
airworthiness information (MCAI) issued by an aviation authority of
another country to identify and correct an unsafe condition on an
aviation product. The MCAI describes the unsafe condition as:
The Luftfahrt-Bundesamt received a report from the Grob Company
that a bolt in the airbrake control was found failed during a pre-
flight inspection on a G 103C TWIN III ACRO. During an extensive
investigation (metallurgical investigation) a double sided fatigue
crack was found as root cause. As the bolt is insignificantly
stressed by cyclic bending the crack was probably caused by mean
stress supported by a bolt torque exceeding the limit.
The actions specified by this airworthiness directive are
intended to prevent further bolt cracking which can result in
airbrake as well as elevator failure (elevator control is on the
same pedestal) and reduced controllability of the power glider.
We are issuing this AD to require actions to correct the unsafe
condition on these products.
DATES: This AD becomes effective March 31, 2009.
On March 31, 2009, the Director of the Federal Register approved
the incorporation by reference of certain publications listed in this
AD.
ADDRESSES: You may examine the AD docket on the Internet at http://
www.regulations.gov or in person at Document Management Facility, U.S.
Department of Transportation, Docket Operations, M-30, West Building
Ground Floor, Room W12-140, 1200 New Jersey Avenue, SE., Washington, DC
20590.
FOR FURTHER INFORMATION CONTACT: Greg Davison, Glider Program Manager,
FAA, Small Airplane Directorate, 901 Locust, Room 301, Kansas City,
Missouri 64106; telephone: (816) 329-4130; fax: (816) 329-4090.
SUPPLEMENTARY INFORMATION:
Discussion
We issued a notice of proposed rulemaking (NPRM) to amend 14 CFR
part 39 to include an AD that would apply to the specified products.
That NPRM was published in the Federal Register on October 9, 2008 (73
FR 59571). That NPRM proposed to correct an unsafe condition for the
specified products. The MCAI states:
The Luftfahrt-Bundesamt received a report from the Grob Company
that a bolt in the airbrake control was found failed during a pre-
flight inspection on a G 103C TWIN III ACRO. During an extensive
investigation (metallurgical investigation) a double sided fatigue
crack was found as root cause. As the bolt is insignificantly
stressed by cyclic bending the crack was probably caused by mean
stress supported by a bolt torque exceeding the limit.
The actions specified by this airworthiness directive are
intended to prevent further bolt cracking which can result in
airbrake as well as elevator failure (elevator control is on the
same pedestal) and reduced controllability of the power glider.
Comments
We gave the public the opportunity to participate in developing
this AD. We received no comments on the NPRM or on the determination of
the cost to the public.
Conclusion
We reviewed the available data and determined that air safety and
the public interest require adopting the AD as proposed.
Differences Between This AD and the MCAI or Service Information
We have reviewed the MCAI and related service information and, in
general, agree with their substance. But we might have found it
necessary to use different words from those in the MCAI to ensure the
AD is clear for U.S. operators and is enforceable. In making these
changes, we do not intend to differ substantively from the information
provided in the MCAI and related service information.
We might also have required different actions in this AD from those
in the MCAI in order to follow FAA policies. Any such differences are
highlighted in a Note within the AD.
Costs of Compliance
Based on the service information, we estimate that this AD will
affect 129 products of U.S. registry. We also estimate that it will
take about 1 work-hour per product to comply with basic requirements of
this AD. The average labor rate is $80 per work-hour.
[[Page 8149]]
Required parts will cost about $15 per product.
Based on these figures, we estimate the cost of this AD to the U.S.
operators to be $12,255 or $95 per product.
Authority for This Rulemaking
Title 49 of the United States Code specifies the FAA's authority to
issue rules on aviation safety. Subtitle I, section 106, describes the
authority of the FAA Administrator. ``Subtitle VII: Aviation
Programs,'' describes in more detail the scope of the Agency's
authority.
We are issuing this rulemaking under the authority described in
``Subtitle VII, Part A, Subpart III, Section 44701: General
requirements.'' Under that section, Congress charges the FAA with
promoting safe flight of civil aircraft in air commerce by prescribing
regulations for practices, methods, and procedures the Administrator
finds necessary for safety in air commerce. This regulation is within
the scope of that authority because it addresses an unsafe condition
that is likely to exist or develop on products identified in this
rulemaking action.
Regulatory Findings
We determined that this AD will not have federalism implications
under Executive Order 13132. This AD will not have a substantial direct
effect on the States, on the relationship between the national
government and the States, or on the distribution of power and
responsibilities among the various levels of government.
For the reasons discussed above, I certify this AD:
(1) Is not a ``significant regulatory action'' under Executive
Order 12866;
(2) Is not a ``significant rule'' under DOT Regulatory Policies and
Procedures (44 FR 11034, February 26, 1979); and
(3) Will not have a significant economic impact, positive or
negative, on a substantial number of small entities under the criteria
of the Regulatory Flexibility Act.
We prepared a regulatory evaluation of the estimated costs to
comply with this AD and placed it in the AD Docket.
Examining the AD Docket
You may examine the AD docket on the Internet at http: //
www.regulations.gov; or in person at the Docket Management Facility
between 9 a.m. and 5 p.m., Monday through Friday, except Federal
holidays. The AD docket contains the NPRM, the regulatory evaluation,
any comments received, and other information. The street address for
the Docket Office (telephone (800) 647-5527) is in the ADDRESSES
section. Comments will be available in the AD docket shortly after
receipt.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by
reference, Safety.
Adoption of the Amendment
0
Accordingly, under the authority delegated to me by the Administrator,
the FAA amends 14 CFR part 39 as follows:
PART 39--AIRWORTHINESS DIRECTIVES
0
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 [Amended]
0
2. The FAA amends Sec. 39.13 by adding the following new AD:
2009-04-08 BURKHART GROB LUFT--UND RAUMFAHRT GmbH & CO KG: Amendment
39-15814; Docket No. FAA-2008-1078; Directorate Identifier 2008-CE-
051-AD.
Effective Date
(a) This airworthiness directive (AD) becomes effective March
31, 2009.
Affected ADs
(b) None.
Applicability
(c) This AD applies to the following models and serial numbers
(SNs) gliders, certificated in any category:
(1) G103 TWIN II, SNs 3730 through 3878;
(2) G103A TWIN II ACRO, SNs 3730 through 34078 (K);
(3) G103C TWIN III ACRO, SNs 34101 through 34203; and
(4) G 103 C TWIN III SL, SNs 35001 through 35051.
Subject
(d) Air Transport Association of America (ATA) Code 27: Flight
Controls.
Reason
(e) The mandatory continuing airworthiness information (MCAI)
states:
``The Luftfahrt-Bundesamt received a report from the Grob
Company that a bolt in the airbrake control was found failed during
a pre-flight inspection on a G 103C TWIN III ACRO. During an
extensive investigation (metallurgical investigation) a double sided
fatigue crack was found as root cause. As the bolt is
insignificantly stressed by cyclic bending the crack was probably
caused by mean stress supported by a bolt torque exceeding the
limit.
``The actions specified by this airworthiness directive are
intended to prevent further bolt cracking which can result in
airbrake as well as elevator failure (elevator control is on the
same pedestal) and reduced controllability of the power glider.''
The MCAI requires replacement of bolt LN9037-M6x60 from the airbrake
bell crank 103B-4437 with a new bolt with a new locking nut and
tightening the bolt to a specific torque; check of all parts of the
airbrake bell crank and the attachment parts for any damage and
replacement of any damaged parts; check of the airbrake locking
force of the left-hand and right-hand wing for a specific force
value range and that the locking is clearly noticeable; and check of
the airbrake locking force at the operating lever in the front
cockpit with the wings rigged for a specific force value range.
Actions and Compliance
(f) Unless already done, within 60 days after March 31, 2009
(the effective date of this AD), do the following actions following
Grob Aerospace Service Bulletin No. MSB 315-76/1 and No. 869-27/1
(same document), dated June 23, 2008:
(1) Remove bolt LN9037-M6x60 from the airbrake bell crank 103B-
4437 and install a new bolt LN9037-M6x60 with the new locking nut
LN9348-M6 and torque the bolt to 6.4 Nm (4.7 lbs.ft).
(2) Inspect all parts of the airbrake bell crank including the
attachment parts for any damage and, before further flight, replace
any damaged parts.
(3) Inspect the airbrake locking force of the left-hand (LH) and
right-hand (RH) wing using a spring balance. The force must be equal
for the LH and RH wing (guidance value: 10 2 daN, (22.5
4.5 lbs)) and the locking must be clearly noticeable.
(4) Inspect the airbrake locking force at the operating lever in
the front cockpit with the wings rigged. The guidance value is 10
2 daN, (22.5 4.5 lbs). It must not exceed
15-20 daN (33.7-45.0 lbs).
FAA AD Differences
Note: This AD differs from the MCAI and/or service information
as follows: No differences.
Other FAA AD Provisions
(g) The following provisions also apply to this AD:
(1) Alternative Methods of Compliance (AMOCs): The Manager,
Standards Office, FAA, has the authority to approve AMOCs for this
AD, if requested using the procedures found in 14 CFR 39.19. Send
information to ATTN: Greg Davison, Glider Program Manager, FAA,
Small Airplane Directorate, 901 Locust, Room 301, Kansas City,
Missouri 64106; telephone: (816) 329-4130; fax: (816) 329-4090.
Before using any approved AMOC on any airplane to which the AMOC
applies, notify your appropriate principal inspector (PI) in the FAA
Flight Standards District Office (FSDO), or lacking a PI, your local
FSDO.
(2) Airworthy Product: For any requirement in this AD to obtain
corrective actions from a manufacturer or other source, use these
actions if they are FAA-approved. Corrective actions are considered
FAA-approved if they are approved by the State of Design Authority
(or their delegated agent). You are required to assure the product
is airworthy before it is returned to service.
(3) Reporting Requirements: For any reporting requirement in
this AD, under the
[[Page 8150]]
provisions of the Paperwork Reduction Act (44 U.S.C. 3501 et seq.),
the Office of Management and Budget (OMB) has approved the
information collection requirements and has assigned OMB Control
Number 2120-0056.
Related Information
(h) Refer to MCAI Federal Republic of Germany Luftfahrt-
Bundesamt AD D-2008-231, dated July 11, 2008; and AD D-2008-232,
dated July 11, 2008; and Grob Aerospace Service Bulletin No. MSB
315-76/1 and No. 869-27/1 (same document), dated June 23, 2008, for
related information.
Material Incorporated by Reference
(i) You must use Grob Aerospace Service Bulletin No. MSB 315-76/
1 and No. 869-27/1 (same document), dated June 23, 2008, to do the
actions required by this AD, unless the AD specifies otherwise.
(1) The Director of the Federal Register approved the
incorporation by reference of this service information under 5
U.S.C. 552(a) and 1 CFR part 51.
(2) For service information identified in this AD, contact GROB
Luft-und Raumfahrt, Lettenbachstrasse 9, D-86874 Tussenhausen-
Mattsies, Germany; telephone: + 011 49 8268 998139; facsimile: + 011
49 8268 998200; E-mail: productsupport@grob-aerospace.de; Internet:
http://www.grob-aerospace.net.
(3) You may review copies of the service information
incorporated by reference for this AD at the FAA, Central Region,
Office of the Regional Counsel, 901 Locust, Kansas City, Missouri
64106. For information on the availability of this material at the
Central Region, call (816) 329-3768.
(4) You may also review copies of the service information
incorporated by reference for this AD at the National Archives and
Records Administration (NARA). For information on the availability
of this material at NARA, call (202) 741-6030, or go to: http://
www.archives.gov/federal_register/code_of_federal_regulations/
ibr_locations.html.
Issued in Kansas City, Missouri, on February 6, 2009.
Kim Smith,
Manager, Small Airplane Directorate, Aircraft Certification Service.
[FR Doc. E9-3116 Filed 2-23-09; 8:45 am]
BILLING CODE 4910-13-P