[Federal Register Volume 75, Number 102 (Thursday, May 27, 2010)] [Notices] [Pages 29752-29753] From the Federal Register Online via the Government Publishing Office [www.gpo.gov] [FR Doc No: 2010-12767] ----------------------------------------------------------------------- ENVIRONMENTAL PROTECTION AGENCY [EPA-HQ-OECA-2009-0403; FRL-9155-8] Agency Information Collection Activities; Submission to OMB for Review and Approval; Comment Request; NESHAP for Metal Can Manufacturing Surface Coating (Renewal), EPA ICR Number 2079.04, OMB Control Number 2060-0541 AGENCY: Environmental Protection Agency (EPA). ACTION: Notice. ----------------------------------------------------------------------- SUMMARY: In compliance with the Paperwork Reduction Act (44 U.S.C. 3501 et seq.), this document announces that an Information Collection Request (ICR) has been forwarded to the Office of Management and Budget (OMB) for review and approval. This is a request to renew an existing approved collection. The ICR which is abstracted below describes the nature of the collection and the estimated burden and cost. DATES: Additional comments may be submitted on or before June 28, 2010. ADDRESSES: Submit your comments, referencing docket ID number EPA-HQ- OECA-2009-0403, to (1) EPA online using http://www.regulations.gov (our preferred method), or by email to [email protected], or by mail to: EPA Docket Center (EPA/DC), Environmental Protection Agency, Enforcement and Compliance Docket and Information Center, mail code 28221T, 1200 Pennsylvania Avenue, NW., Washington, DC 20460, and (2) OMB at: Office of Information and Regulatory Affairs, Office of Management and Budget (OMB), Attention: Desk Officer for EPA, 725 17th Street, NW., Washington, DC 20503. FOR FURTHER INFORMATION CONTACT: Robert C. Marshall, Jr., Office of Compliance, Mail Code: 2223A, Environmental Protection Agency, 1200 Pennsylvania Avenue, NW., Washington, DC 20460; telephone number: (202) 564-7021; fax number: (202) 564-0050; e-mail address: [email protected]. SUPPLEMENTARY INFORMATION: EPA has submitted the following ICR to OMB for review and approval according to the procedures prescribed in 5 CFR 1320.12. On July 8, 2009 (74 FR 32583), EPA sought comments on this ICR pursuant to 5 CFR 1320.8(d). EPA received no comments. Any additional comments on this ICR should be submitted to EPA and OMB within 30 days of this notice. EPA has established a public docket for this ICR under docket ID number EPA-HQ-OECA-2009-0403, which is available for public viewing online at http://www.regulations.gov, in person viewing at the Enforcement and Compliance Docket in the EPA Docket Center (EPA/DC), EPA West, Room 3334, 1301 Constitution Avenue, NW., Washington, DC. The EPA Docket Center Public Reading Room is open from 8:30 a.m. to 4:30 p.m., Monday through Friday, excluding legal holidays. The telephone number for the Reading Room is (202) 566-1744, and the telephone number for the Enforcement and Compliance Docket is (202) 566-1752. Use EPA's electronic docket and comment system at http://www.regulations.gov, to submit or view public comments, access the index listing of the contents of the docket, and to access those documents in the docket that are available electronically. Once in the system, select ``docket search,'' then key in the docket ID number identified above. Please note that EPA's policy is that public comments, whether submitted electronically or in paper, will be made available for public viewing at http://www.regulations.gov, as EPA receives them and without change, unless the comment contains copyrighted material, Confidential Business Information (CBI), or other information whose public disclosure is restricted by statute. For further information about the electronic docket, go to http://www.regulations.gov. Title: NESHAP for Metal Can Manufacturing Surface Coating (Renewal). ICR Numbers: EPA ICR Number 2079.04, OMB Control Number 2060-0541. ICR Status: This ICR is scheduled to expire on July 31, 2010. Under OMB regulations, the Agency may continue to conduct or sponsor the collection of information while this submission is pending at OMB. An agency may not conduct or sponsor, and a person is not required to respond to, a collection of information unless it displays a currently valid OMB control number. The OMB control numbers for EPA's regulations in title 40 of the CFR, after appearing in the Federal Register when approved, are listed in 40 CFR part 9, and displayed either by publication in the Federal Register or by other appropriate means, such as on the related collection instrument or form, if applicable. The display of OMB control numbers in certain EPA regulations is consolidated in 40 CFR part 9. Abstract: The affected entities are subject to the General Provisions of the NESHAP for Metal Can Manufacturing Surface Coating at 40 CFR part 63, [[Page 29753]] subpart A, and any changes, or additions, to the Provisions specified at 40 CFR part 63, subpart KKKK. Owners or operators of the affected facilities must submit a one- time-only report of any physical or operational changes, initial performance tests, and periodic reports and results. Owners or operators are also required to maintain records of the occurrence and duration of any startup, shutdown, or malfunction in the operation of an affected facility, or any period during which the monitoring system is inoperative. Reports, at a minimum, are required semiannually. Burden Statement: The annual public reporting and recordkeeping burden for this collection of information is estimated to average 91 hours per response. Burden means the total time, effort, or financial resources expended by persons to generate, maintain, retain, or disclose or provide information to or for a Federal agency. This includes the time needed to review instructions; develop, acquire, install, and utilize technology and systems for the purposes of collecting, validating, and verifying information, processing and maintaining information, and disclosing and providing information; adjust the existing ways to comply with any previously applicable instructions and requirements which have subsequently changed; train personnel to be able to respond to a collection of information; search data sources; complete and review the collection of information; and transmit or otherwise disclose the information. Respondents/Affected Entities: Metal can manufacturing surface coating. Estimated Number of Respondents: 71. Frequency of Response: Initially, occasionally, and semiannually. Estimated Total Annual Hour Burden: 27,517. Estimated Total Annual Cost: $2,687,973, which includes $2,602,773 in labor costs, no capital/startup costs, and $85,200 in operation and maintenance (O&M) costs. Changes in the Estimates: There is no change in the labor hours in this ICR compared to the previous ICR. This is due to two considerations: (1) The regulations have not changed over the past three years and are not anticipated to change over the next three years; and (2) the growth rate for the respondents is very low, negative or non-existent. Therefore, the labor hours in the previous ICR reflect the current burden to the respondents and are reiterated in this ICR. There is an increase in both respondent and Agency costs due to labor rate increases from 2003 to the most recently available rates. Dated: May 21, 2010. John Moses, Director, Collection Strategies Division. [FR Doc. 2010-12767 Filed 5-26-10; 8:45 am] BILLING CODE 6560-50-P