[Federal Register Volume 75, Number 5 (Friday, January 8, 2010)]
[Notices]
[Pages 1053-1054]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 2010-148]


-----------------------------------------------------------------------

ENVIRONMENTAL PROTECTION AGENCY

[EPA-HQ-OECA-2009-0417; FRL-9101-4]


Agency Information Collection Activities; Submission to OMB for 
Review and Approval; Comment Request; NSPS for Surface Coating of 
Plastic Parts for Business Machines, EPA ICR Number 1093.09, OMB 
Control Number 2060-0162

AGENCY: Environmental Protection Agency (EPA).

ACTION: Notice.

-----------------------------------------------------------------------

SUMMARY: In compliance with the Paperwork Reduction Act (44 U.S.C. 3501 
et seq.), this document announces that an Information Collection 
Request (ICR) has been forwarded to the Office of Management and Budget 
(OMB) for review and approval. This is a request to renew an existing 
approved collection. The ICR which is abstracted below describes the 
nature of the collection and the estimated burden and cost.

DATES: Additional comments may be submitted on or before February 8, 
2010.

ADDRESSES: Submit your comments, referencing docket ID number EPA-HQ-
OECA-2009-0417, to (1) EPA online using www.regulations.gov (our 
preferred method), or by e-mail to [email protected], or by mail to: 
EPA Docket Center (EPA/DC), Environmental Protection Agency, 
Enforcement and Compliance Docket and Information Center, mail code 
2801T, 1200 Pennsylvania Avenue, NW., Washington, DC 20460, and (2) OMB 
at: Office of Information and Regulatory Affairs, Office of Management 
and

[[Page 1054]]

Budget (OMB), Attention: Desk Officer for EPA, 725 17th Street, NW., 
Washington, DC 20503.

FOR FURTHER INFORMATION CONTACT: John Schaefer, Office of Air Quality 
Planning and Standards, Sector Policies and Programs Division (D243-
05), Measurement Policy Group, Environmental Protection Agency, 
Research Triangle Park, North Carolina, 27711; telephone number: (919) 
541-0296; fax number: (919) 541-3207; e-mail address: 
[email protected].

SUPPLEMENTARY INFORMATION: EPA has submitted the following ICR to OMB 
for review and approval according to the procedures prescribed in 5 CFR 
1320.12. On July 8, 2009 (74 FR 32580), EPA sought comments on this ICR 
pursuant to 5 CFR 1320.8(d). EPA received no comments. Any additional 
comments on this ICR should be submitted to EPA and OMB within 30 days 
of this notice.
    EPA has established a public docket for this ICR under docket ID 
number EPA-HQ-OECA-2009-0417, which is available for public viewing 
online at http://www.regulations.gov, in person viewing at the 
Enforcement and Compliance Docket in the EPA Docket Center (EPA/DC), 
EPA West, Room 3334, 1301 Constitution Avenue, NW., Washington, DC. The 
EPA Docket Center Public Reading Room is open from 8:30 a.m. to 4:30 
p.m., Monday through Friday, excluding legal holidays. The telephone 
number for the Reading Room is (202) 566-1744, and the telephone number 
for the Enforcement and Compliance Docket is (202) 566-1752.
    Use EPA's electronic docket and comment system at http://www.regulations.gov, to submit or view public comments, access the 
index listing of the contents of the docket, and to access those 
documents in the docket that are available electronically. Once in the 
system, select ``docket search,'' then key in the docket ID number 
identified above. Please note that EPA's policy is that public 
comments, whether submitted electronically or in paper, will be made 
available for public viewing at http://www.regulations.gov, as EPA 
receives them and without change, unless the comment contains 
copyrighted material, confidential business information (CBI), or other 
information whose public disclosure is restricted by statute. For 
further information about the electronic docket, go to 
www.regulations.gov.
    Title: NSPS for Surface Coating of Plastic Parts for Business 
Machines
    ICR Numbers: EPA ICR Number 1093.09, OMB Control Number 2060-0162.
    ICR Status: This ICR is scheduled to expire on January 31, 2010. 
Under OMB regulations, the Agency may continue to conduct or sponsor 
the collection of information while this submission is pending at OMB. 
An Agency may not conduct or sponsor, and a person is not required to 
respond to, a collection of information unless it displays a currently 
valid OMB control number. The OMB control numbers for EPA's regulations 
in title 40 of the CFR, after appearing in the Federal Register when 
approved, are listed in 40 CFR part 9, and displayed either by 
publication in the Federal Register or by other appropriate means, such 
as on the related collection instrument or form, if applicable. The 
display of OMB control numbers in certain EPA regulations is 
consolidated in 40 CFR part 9.
    Abstract: The New Source Performance Standards (NSPS) for Surface 
Coating of Plastic Parts for Business Machines were promulgated on 
January 29, 1988. These standards apply to each spray booth that 
applies prime coats, color coats, texture coats or touch-up coats in 
industrial surface coating operations that apply coatings to plastic 
parts for use in the manufacture of business machines.
    Affected sources are required to complete initial notifications, 
performance tests, and periodic reports. Owners or operators are also 
required to maintain records of the occurrence and duration of any 
startup, shutdown, or malfunction in the operation of an affected 
facility, or any period during which the monitoring system is 
inoperative. These notifications, reports, and records are essential in 
determining compliance; and are required, in general, of all sources 
subject to NSPS.
    Burden Statement: The annual public reporting and recordkeeping 
burden for this collection of information is estimated to average 35 
hours per response. Burden means the total time, effort, or financial 
resources expended by persons to generate, maintain, retain, or 
disclose or provide information to or for a Federal agency. This 
includes the time needed to review instructions; develop, acquire, 
install, and utilize technology and systems for the purposes of 
collecting, validating, and verifying information, processing and 
maintaining information, and disclosing and providing information; 
adjust the existing ways to comply with any previously applicable 
instructions and requirements which have subsequently changed; train 
personnel to be able to respond to a collection of information; search 
data sources; complete and review the collection of information; and 
transmit or otherwise disclose the information.
    Respondents/Affected Entities: Business machine manufacturers.
    Estimated Number of Respondents: 10.
    Frequency of Response: Initially, quarterly, and semiannually.
    Estimated Total Annual Hour Burden: 978.
    Estimated Total Annual Cost: $92,296 in labor costs and $0 in 
capital/startup costs or operation and maintenance (O&M) costs.
    Changes in the Estimates: There is a decrease estimated burden 
currently identified in the OMB Inventory of Approved ICR Burdens. This 
decrease was due to a change in the adjustments to the estimates to 
correct a mathematical error.

    Dated: December 24, 2009.
Richard T. Westlund,
Acting Director, Collection Strategies Division.
[FR Doc. 2010-148 Filed 1-7-10; 8:45 am]
BILLING CODE 6560-50-P