[Federal Register Volume 75, Number 133 (Tuesday, July 13, 2010)] [Proposed Rules] [Pages 39869-39871] From the Federal Register Online via the Government Publishing Office [www.gpo.gov] [FR Doc No: 2010-17062] [[Page 39869]] ----------------------------------------------------------------------- DEPARTMENT OF TRANSPORTATION Federal Aviation Administration 14 CFR Part 39 [Docket No. FAA-2010-0697; Directorate Identifier 2010-NM-102-AD] RIN 2120-AA64 Airworthiness Directives; Airbus Model A330-200 and A330-300 Series Airplanes AGENCY: Federal Aviation Administration (FAA), DOT. ACTION: Notice of proposed rulemaking (NPRM). ----------------------------------------------------------------------- SUMMARY: We propose to adopt a new airworthiness directive (AD) for the products listed above. This proposed AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as: An A330 experienced an uncommanded engine1 in flight spool down, which occurred while applying fuel gravity feed procedure, in response to low pressure indications from all fuel boost pumps, in both left and right wings. The investigations revealed that the wing tank pressure switches P/N (part number) HTE69000-1 had frozen due to water accumulated in their external part, causing spurious low pressure indications. As per procedure, the main pumps are then switched off, increasing the level of unavailable fuel. This, in combination with very low fuel quantities or another independent trapped fuel failure scenarios, can lead to fuel starvation on the affected engine(s). The proposed AD would require actions that are intended to address the unsafe condition described in the MCAI. DATES: We must receive comments on this proposed AD by August 27, 2010. ADDRESSES: You may send comments by any of the following methods: Federal eRulemaking Portal: Go to http://www.regulations.gov. Follow the instructions for submitting comments. Fax: (202) 493-2251. Mail: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue, SE., Washington, DC 20590. Hand Delivery: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-40, 1200 New Jersey Avenue, SE., Washington, DC, between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. For service information identified in this proposed AD, contact Airbus SAS--Airworthiness Office--EAL, 1 Rond Point Maurice Bellonte, 31707 Blagnac Cedex, France; telephone +33 5 61 93 36 96; fax +33 5 61 93 45 80, e-mail [email protected]; Internet http://www.airbus.com. You may review copies of the referenced service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington. For information on the availability of this material at the FAA, call 425-227-1221. Examining the AD Docket You may examine the AD docket on the Internet at http://www.regulations.gov; or in person at the Docket Operations office between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this proposed AD, the regulatory evaluation, any comments received, and other information. The street address for the Docket Operations office (telephone (800) 647-5527) is in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt. FOR FURTHER INFORMATION CONTACT: Vladimir Ulyanov, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue, SW., Renton, Washington 98057-3356; telephone (425) 227-1138; fax (425) 227-1149. SUPPLEMENTARY INFORMATION: Comments Invited We invite you to send any written relevant data, views, or arguments about this proposed AD. Send your comments to an address listed under the ADDRESSES section. Include ``Docket No. FAA-2010-0697; Directorate Identifier 2010-NM-102-AD'' at the beginning of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of this proposed AD. We will consider all comments received by the closing date and may amend this proposed AD based on those comments. We have lengthened the 30-day comment period for proposed ADs that address MCAI originated by aviation authorities of other countries to provide adequate time for interested parties to submit comments. The comment period for these proposed ADs is now typically 45 days, which is consistent with the comment period for domestic transport ADs. We will post all comments we receive, without change, to http://www.regulations.gov, including any personal information you provide. We will also post a report summarizing each substantive verbal contact we receive about this proposed AD. Discussion The European Aviation Safety Agency (EASA), which is the Technical Agent for the Member States of the European Community, has issued EASA Airworthiness Directive 2010-0018, dated February 4, 2010 (referred to after this as ``the MCAI''), to correct an unsafe condition for the specified products. The MCAI states: An A330 experienced an uncommanded engine 1 in flight spool down, which occurred while applying fuel gravity feed procedure, in response to low pressure indications from all fuel boost pumps, in both left and right wings. The investigations revealed that the wing tank pressure switches P/N (part number) HTE69000-1 had frozen due to water accumulated in their external part, causing spurious low pressure indications. As per procedure, the main pumps are then switched off, increasing the level of unavailable fuel. This, in combination with very low fuel quantities or another independent trapped fuel failure scenarios, can lead to fuel starvation on the affected engine(s). This condition, if not corrected, could lead to a potential unsafe condition. This AD requires the replacement of all four wing tank fuel pressure switches associated to main pumps by new ones with a more robust design preventing water accumulation and freezing. You may obtain further information by examining the MCAI in the AD docket. Relevant Service Information Airbus issued Mandatory Service Bulletin A330-28-3111, Revision 02, dated March 24, 2010. The actions described in this service information are intended to correct the unsafe condition identified in the MCAI. FAA's Determination and Requirements of This Proposed AD This product has been approved by the aviation authority of another country, and is approved for operation in the United States. Pursuant to our bilateral agreement with the State of Design Authority, we have been notified of the unsafe condition described in the MCAI and service information referenced above. We are proposing this AD because we evaluated all pertinent information and determined an unsafe condition exists and is likely to exist or develop on other products of the same type design. Differences Between This AD and the MCAI or Service Information We have reviewed the MCAI and related service information and, in [[Page 39870]] general, agree with their substance. But we might have found it necessary to use different words from those in the MCAI to ensure the AD is clear for U.S. operators and is enforceable. In making these changes, we do not intend to differ substantively from the information provided in the MCAI and related service information. We might also have proposed different actions in this AD from those in the MCAI in order to follow FAA policies. Any such differences are highlighted in a NOTE within the proposed AD. Costs of Compliance Based on the service information, we estimate that this proposed AD would affect about 48 products of U.S. registry. We also estimate that it would take about 7 work-hours per product to comply with the basic requirements of this proposed AD. The average labor rate is $85 per work-hour. Required parts would cost about $0 per product. Where the service information lists required parts costs that are covered under warranty, we have assumed that there will be no charge for these costs. As we do not control warranty coverage for affected parties, some parties may incur costs higher than estimated here. Based on these figures, we estimate the cost of the proposed AD on U.S. operators to be $28,560, or $595 per product. Authority for This Rulemaking Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. ``Subtitle VII: Aviation Programs,'' describes in more detail the scope of the Agency's authority. We are issuing this rulemaking under the authority described in ``Subtitle VII, Part A, Subpart III, Section 44701: General requirements.'' Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action. Regulatory Findings We determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government. For the reasons discussed above, I certify this proposed regulation: 1. Is not a ``significant regulatory action'' under Executive Order 12866; 2. Is not a ``significant rule'' under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and 3. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. We prepared a regulatory evaluation of the estimated costs to comply with this proposed AD and placed it in the AD docket. List of Subjects in 14 CFR Part 39 Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety. The Proposed Amendment Accordingly, under the authority delegated to me by the Administrator, the FAA proposes to amend 14 CFR part 39 as follows: PART 39--AIRWORTHINESS DIRECTIVES 1. The authority citation for part 39 continues to read as follows: Authority: 49 U.S.C. 106(g), 40113, 44701. Sec. 39.13 [Amended] 2. The FAA amends Sec. 39.13 by adding the following new AD: Airbus: Docket No. FAA-2010-0697; Directorate Identifier 2010-NM- 102-AD. Comments Due Date (a) We must receive comments by August 27, 2010. Affected ADs (b) None. Applicability (c) This AD applies to Airbus Model A330-201, -202, -203, -223, -243, -301, -302, -303, -321, -322, -323, -341, -342, and -343 airplanes, certificated in any category, all manufacturer serial numbers, equipped with part number (P/N) HTE69000-1 wing tank pressure switches installed at Functional Item Number (FIN) locations 74QA1, 74QA2, 75QA1 or 75QA2. Subject (d) Air Transport Association (ATA) of America Code 28: Fuel. Reason (e) The mandatory continuing airworthiness information (MCAI) states: An A330 experienced an uncommanded engine 1 in flight spool down, which occurred while applying fuel gravity feed procedure, in response to low pressure indications from all fuel boost pumps, in both left and right wings. The investigations revealed that the wing tank pressure switches P/N HTE69000-1 had frozen due to water accumulated in their external part, causing spurious low pressure indications. As per procedure, the main pumps are then switched off, increasing the level of unavailable fuel. This, in combination with very low fuel quantities or another independent trapped fuel failure scenarios, can lead to fuel starvation on the affected engine(s). Compliance (f) You are responsible for having the actions required by this AD performed within the compliance times specified, unless the actions have already been done. Actions (g) Within 5 years after the effective date of this AD, replace the wing tank main pump pressure switches having P/N HTE69000-1 in accordance with the Accomplishment Instructions of Airbus Mandatory Service Bulletin A330-28-3111, Revision 02, dated March 24, 2010. (h) Actions accomplished before the effective date of this AD according to Airbus Mandatory Service Bulletin A330-28-3111, dated August 12, 2009; or Revision 01, dated December 4, 2009; are considered acceptable for compliance with the corresponding actions specified in this AD. FAA AD Differences Note 1: This AD differs from the MCAI and/or service information as follows: No differences. Other FAA AD Provisions (i) The following provisions also apply to this AD: (1) Alternative Methods of Compliance (AMOCs): The Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Vladimir Ulyanov, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue SW., Renton, Washington 98057-3356; telephone (425) 227-1138; fax (425) 227-1149. Before using any approved AMOC on any airplane to which the AMOC applies, notify your principal maintenance inspector (PMI) or principal avionics inspector (PAI), as appropriate, or lacking a principal inspector, your local Flight Standards District Office. The AMOC approval letter must specifically reference this AD. (2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service. [[Page 39871]] (3) Reporting Requirements: For any reporting requirement in this AD, under the provisions of the Paperwork Reduction Act (44 U.S.C. 3501 et seq.), the Office of Management and Budget (OMB) has approved the information collection requirements and has assigned OMB Control Number 2120-0056. Related Information (j) Refer to MCAI European Aviation Safety Agency Airworthiness Directive 2010-0018, dated February 4, 2010; and Airbus Mandatory Service Bulletin A330-28-3111, Revision 02, dated March 24, 2010; for related information. Issued in Renton, Washington, on June 29, 2010. Ali Bahrami, Manager, Transport Airplane Directorate, Aircraft Certification Service. [FR Doc. 2010-17062 Filed 7-12-10; 8:45 am] BILLING CODE 4910-13-P