[Federal Register Volume 75, Number 199 (Friday, October 15, 2010)]
[Proposed Rules]
[Pages 63420-63422]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 2010-25921]
=======================================================================
-----------------------------------------------------------------------
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
14 CFR Part 39
[Docket No. FAA-2010-0959; Directorate Identifier 2010-NM-119-AD]
RIN 2120-AA64
Airworthiness Directives; Bombardier, Inc. Model BD-700-1A10 and
BD-700-1A11 Airplanes
AGENCY: Federal Aviation Administration (FAA), DOT.
ACTION: Notice of proposed rulemaking (NPRM).
-----------------------------------------------------------------------
SUMMARY: We propose to adopt a new airworthiness directive (AD) for the
products listed above. This proposed AD results from mandatory
continuing airworthiness information (MCAI) originated by an aviation
authority of another country to identify and correct an unsafe
condition on an aviation product. The MCAI describes the unsafe
condition as:
There have been two in-service reports of main landing gear
(MLG) tire failure on landing, during which a flailing tire tread
caused damage to No. 2 and No. 3 hydraulic system lines in the wing
auxiliary spar area on the left side of the aircraft. This damage
resulted in the loss of supply pressure to the inboard and outboard
brakes, as the only remaining braking source available was the No. 3
hydraulic system accumulator. The degradation of the brake system
performance could adversely affect the aircraft during landing.
* * * * *
[[Page 63421]]
The unsafe condition is loss of braking capability, which could reduce
the ability of the flightcrew to safely land the airplane. The proposed
AD would require actions that are intended to address the unsafe
condition described in the MCAI.
DATES: We must receive comments on this proposed AD by November 29,
2010.
ADDRESSES: You may send comments by any of the following methods:
Federal eRulemaking Portal: Go to http://www.regulations.gov. Follow the instructions for submitting comments.
Fax: (202) 493-2251.
Mail: U.S. Department of Transportation, Docket
Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New
Jersey Avenue, SE., Washington, DC 20590.
Hand Delivery: U.S. Department of Transportation, Docket
Operations, M-30, West Building Ground Floor, Room W12-40, 1200 New
Jersey Avenue, SE., Washington, DC, between 9 a.m. and 5 p.m., Monday
through Friday, except Federal holidays.
For service information identified in this proposed AD, contact
Bombardier, Inc., 400 C[ocirc]te-Vertu Road West, Dorval, Qu[eacute]bec
H4S 1Y9, Canada; telephone 514-855-5000; fax 514-855-7401; e-mail
[email protected]; Internet http://www.bombardier.com. You
may review copies of the referenced service information at the FAA,
Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton,
Washington. For information on the availability of this material at the
FAA, call 425-227-1221.
Examining the AD Docket
You may examine the AD docket on the Internet at http://www.regulations.gov; or in person at the Docket Operations office
between 9 a.m. and 5 p.m., Monday through Friday, except Federal
holidays. The AD docket contains this proposed AD, the regulatory
evaluation, any comments received, and other information. The street
address for the Docket Operations office (telephone (800) 647-5527) is
in the ADDRESSES section. Comments will be available in the AD docket
shortly after receipt.
FOR FURTHER INFORMATION CONTACT: Christopher Alfano, Aerospace
Engineer, Airframe and Mechanical Systems Branch, ANE-171, FAA, New
York Aircraft Certification Office, 1600 Stewart Avenue, Suite 410,
Westbury, New York 11590; telephone (516) 228-7340; fax (516) 794-5531.
SUPPLEMENTARY INFORMATION:
Comments Invited
We invite you to send any written relevant data, views, or
arguments about this proposed AD. Send your comments to an address
listed under the ADDRESSES section. Include ``Docket No. FAA-2010-0959;
Directorate Identifier 2010-NM-119-AD'' at the beginning of your
comments. We specifically invite comments on the overall regulatory,
economic, environmental, and energy aspects of this proposed AD. We
will consider all comments received by the closing date and may amend
this proposed AD based on those comments.
We will post all comments we receive, without change, to http://www.regulations.gov, including any personal information you provide. We
will also post a report summarizing each substantive verbal contact we
receive about this proposed AD.
Discussion
Transport Canada Civil Aviation (TCCA), which is the aviation
authority for Canada, has issued Canadian Airworthiness Directive CF-
2010-10, dated March 26, 2010 (referred to after this as ``the MCAI''),
to correct an unsafe condition for the specified products. The MCAI
states:
There have been two in-service reports of main landing gear
(MLG) tire failure on landing, during which a flailing tire tread
caused damage to No. 2 and No. 3 hydraulic system lines in the wing
auxiliary spar area on the left side of the aircraft. This damage
resulted in the loss of supply pressure to the inboard and outboard
brakes, as the only remaining braking source available was the No. 3
hydraulic system accumulator. The degradation of the brake system
performance could adversely affect the aircraft during landing.
This directive mandates the relocation of the No. 2 and No. 3
hydraulic system lines in the wing auxiliary spar area on the left
side of the aircraft, together with a modification to the left wing
rib and debris shield, in order to prevent damage to the hydraulic
lines in the event of a MLG tire failure. The debris shield on the
right side is also modified for part commonality.
The unsafe condition is loss of braking capability, which could reduce
the ability of the flightcrew to safely land the airplane. You may
obtain further information by examining the MCAI in the AD docket.
Relevant Service Information
Bombardier, Inc. has issued Service Bulletins 700-29-021 and 700-
1A11-29-004, both Revision 01, both dated January 25, 2010. The actions
described in this service information are intended to correct the
unsafe condition identified in the MCAI.
FAA's Determination and Requirements of This Proposed AD
This product has been approved by the aviation authority of another
country, and is approved for operation in the United States. Pursuant
to our bilateral agreement with the State of Design Authority, we have
been notified of the unsafe condition described in the MCAI and service
information referenced above. We are proposing this AD because we
evaluated all pertinent information and determined an unsafe condition
exists and is likely to exist or develop on other products of the same
type design.
Differences Between This AD and the MCAI or Service Information
We have reviewed the MCAI and related service information and, in
general, agree with their substance. But we might have found it
necessary to use different words from those in the MCAI to ensure the
AD is clear for U.S. operators and is enforceable. In making these
changes, we do not intend to differ substantively from the information
provided in the MCAI and related service information.
We might also have proposed different actions in this AD from those
in the MCAI in order to follow FAA policies. Any such differences are
highlighted in a NOTE within the proposed AD.
Costs of Compliance
Based on the service information, we estimate that this proposed AD
would affect about 115 products of U.S. registry. We also estimate that
it would take about 40 work-hours per product to comply with the basic
requirements of this proposed AD. The average labor rate is $85 per
work-hour. Required parts would cost about $4,855 per product. Where
the service information lists required parts costs that are covered
under warranty, we have assumed that there will be no charge for these
costs. As we do not control warranty coverage for affected parties,
some parties may incur costs higher than estimated here. Based on these
figures, we estimate the cost of the proposed AD on U.S. operators to
be $949,325, or $8,255 per product.
Authority for This Rulemaking
Title 49 of the United States Code specifies the FAA's authority to
issue rules on aviation safety. Subtitle I, section 106, describes the
authority of the FAA Administrator. ``Subtitle VII: Aviation
Programs,'' describes in more detail the scope of the Agency's
authority.
[[Page 63422]]
We are issuing this rulemaking under the authority described in
``Subtitle VII, Part A, Subpart III, Section 44701: General
requirements.'' Under that section, Congress charges the FAA with
promoting safe flight of civil aircraft in air commerce by prescribing
regulations for practices, methods, and procedures the Administrator
finds necessary for safety in air commerce. This regulation is within
the scope of that authority because it addresses an unsafe condition
that is likely to exist or develop on products identified in this
rulemaking action.
Regulatory Findings
We determined that this proposed AD would not have federalism
implications under Executive Order 13132. This proposed AD would not
have a substantial direct effect on the States, on the relationship
between the national Government and the States, or on the distribution
of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify this proposed
regulation:
1. Is not a ``significant regulatory action'' under Executive Order
12866;
2. Is not a ``significant rule'' under the DOT Regulatory Policies
and Procedures (44 FR 11034, February 26, 1979); and
3. Will not have a significant economic impact, positive or
negative, on a substantial number of small entities under the criteria
of the Regulatory Flexibility Act.
We prepared a regulatory evaluation of the estimated costs to
comply with this proposed AD and placed it in the AD docket.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by
reference, Safety.
The Proposed Amendment
Accordingly, under the authority delegated to me by the
Administrator, the FAA proposes to amend 14 CFR part 39 as follows:
PART 39--AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 [Amended]
2. The FAA amends Sec. 39.13 by adding the following new AD:
Bombardier, Inc.: Docket No. FAA-2010-0959; Directorate Identifier
2010-NM-119-AD.
Comments Due Date
(a) We must receive comments by November 29, 2010.
Affected ADs
(b) None.
Applicability
(c) This AD applies to Bombardier, Inc. Model BD-700-1A10 and
BD-700-1A11 airplanes, serial numbers 9002 through 9401 inclusive,
certificated in any category.
Subject
(d) Air Transport Association (ATA) of America Code 29:
Hydraulic power.
Reason
(e) The mandatory continuing airworthiness information (MCAI)
states:
There have been two in-service reports of main landing gear
(MLG) tire failure on landing, during which a flailing tire tread
caused damage to No. 2 and No. 3 hydraulic system lines in the wing
auxiliary spar area on the left side of the aircraft. This damage
resulted in the loss of supply pressure to the inboard and outboard
brakes, as the only remaining braking source available was the No. 3
hydraulic system accumulator. The degradation of the brake system
performance could adversely affect the aircraft during landing.
* * * * *
The unsafe condition is loss of braking capability, which could
reduce the ability of the flightcrew to safely land the airplane.
Compliance
(f) You are responsible for having the actions required by this
AD performed within the compliance times specified, unless the
actions have already been done.
Actions
(g) Within 30 months after the effective date of this AD,
relocate the No. 2 and No. 3 hydraulic system lines in the wing
auxiliary spar area on the left side of the aircraft, and modify the
left wing rib and left and right debris shields, in accordance with
the Accomplishment Instructions of Bombardier Service Bulletin 700-
29-021 (for Model BD-700-1A10 airplanes) or 700-1A11-29-004 (for
Model BD-700-1A11 airplanes), both Revision 01, both dated January
25, 2010, as applicable.
Credit for Actions Accomplished in Accordance With Previous Service
Information
(h) Actions accomplished before the effective date of this AD in
accordance with Bombardier Service Bulletin 700-29-021 or 700-1A11-
29-004, both dated April 3, 2009, as applicable, are considered
acceptable for compliance with the corresponding actions specified
in this AD.
FAA AD Differences
Note 1: This AD differs from the MCAI and/or service information
as follows: No differences.
Other FAA AD Provisions
(i) The following provisions also apply to this AD:
(1) Alternative Methods of Compliance (AMOCs): The Manager, New
York Aircraft Certification Office (ACO), ANE-170, FAA, has the
authority to approve AMOCs for this AD, if requested using the
procedures found in 14 CFR 39.19. Send information to ATTN: Program
Manager, Continuing Operational Safety, FAA, New York ACO, 1600
Stewart Avenue, Suite 410, Westbury, New York, 11590; telephone 516-
228-7300; fax 516-794-5531. Before using any approved AMOC on any
airplane to which the AMOC applies, notify your principal
maintenance inspector (PMI) or principal avionics inspector (PAI),
as appropriate, or lacking a principal inspector, your local Flight
Standards District Office. The AMOC approval letter must
specifically reference this AD.
(2) Airworthy Product: For any requirement in this AD to obtain
corrective actions from a manufacturer or other source, use these
actions if they are FAA-approved. Corrective actions are considered
FAA-approved if they are approved by the State of Design Authority
(or their delegated agent). You are required to assure the product
is airworthy before it is returned to service.
(3) Reporting Requirements: For any reporting requirement in
this AD, under the provisions of the Paperwork Reduction Act (44
U.S.C. 3501 et seq.), the Office of Management and Budget (OMB) has
approved the information collection requirements and has assigned
OMB Control Number 2120-0056.
Related Information
(j) Refer to MCAI Canadian Airworthiness Directive CF-2010-10,
dated March 26, 2010; and Bombardier Service Bulletins 700-29-021
and 700-1A11-29-004, both Revision 01, both dated January 25, 2010;
for related information.
Issued in Renton, Washington, on October 6, 2010.
Ali Bahrami,
Manager, Transport Airplane Directorate, Aircraft Certification
Service.
[FR Doc. 2010-25921 Filed 10-14-10; 8:45 am]
BILLING CODE 4910-13-P