[Federal Register Volume 76, Number 84 (Monday, May 2, 2011)]
[Rules and Regulations]
[Pages 24358-24360]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 2011-10138]
-----------------------------------------------------------------------
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
14 CFR Part 39
[Docket No. FAA-2010-1207; Directorate Identifier 2010-NM-140-AD;
Amendment 39-16680; AD 2011-09-18]
RIN 2120-AA64
Airworthiness Directives; Dassault-Aviation Model FALCON 7X
Airplanes
AGENCY: Federal Aviation Administration (FAA), Department of
Transportation (DOT).
ACTION: Final rule.
-----------------------------------------------------------------------
SUMMARY: We are adopting a new airworthiness directive (AD) for the
products listed above. This AD results from mandatory continuing
airworthiness information (MCAI) originated by an aviation authority of
another country to identify and correct an unsafe condition on an
aviation product. The MCAI describes the unsafe condition as:
Following investigation of an in service event, it has been
determined that in case a short circuit occurs on a weight-on-wheels
(WOW) proximity sensor wiring, both circuit breakers that supply
power to that wiring will trip, causing simultaneous de-power of all
WOW proximity sensors of that part of the system. The loss of the
corresponding WOW information would lead to untimely inhibition of
warnings that could compromise the pilot capacity to react to
abnormal or failure landing conditions.
* * * * *
We are issuing this AD to require actions to correct the unsafe
condition on these products.
DATES: This AD becomes effective June 6, 2011.
The Director of the Federal Register approved the incorporation by
reference of a certain publication listed in this AD as of June 6,
2011.
ADDRESSES: You may examine the AD docket on the Internet at http://www.regulations.gov or in person at the U.S. Department of
Transportation, Docket Operations, M-30, West Building Ground Floor,
Room W12-140, 1200 New Jersey Avenue, SE., Washington, DC.
FOR FURTHER INFORMATION CONTACT: Tom Rodriguez, Aerospace Engineer,
International Branch, ANM-116, Transport Airplane Directorate, FAA,
1601 Lind Avenue, SW., Renton, Washington 98057-3356; telephone (425)
227-1137; fax (425) 227-1149.
SUPPLEMENTARY INFORMATION:
Discussion
We issued a notice of proposed rulemaking (NPRM) to amend 14 CFR
part 39 to include an AD that would apply to the specified products.
That NPRM was published in the Federal Register on December 30, 2010
(75 FR 82327). That NPRM proposed to correct an unsafe condition for
the specified products. The MCAI states:
Following investigation of an in service event, it has been
determined that in case a short circuit occurs on a weight-on-wheels
(WOW) proximity sensor wiring, both circuit breakers that supply
power to that wiring will trip, causing simultaneous de-power of all
WOW proximity sensors of that part of the system. The loss of the
corresponding WOW information would lead to untimely inhibition of
warnings that could compromise the pilot capacity to react to
abnormal or failure landing conditions.
This AD requires the modification of the WOW System to improve
its robustness against short circuit of the proximity sensors wiring
by adding dedicated fuses to each
[[Page 24359]]
WOW proximity sensor, in accordance with Dassault Aviation Service
Bulletin (SB) F7X-065.
You may obtain further information by examining the MCAI in the AD
docket.
Comments
We gave the public the opportunity to participate in developing
this AD. We received no comments on the NPRM or on the determination of
the cost to the public.
Conclusion
We reviewed the available data and determined that air safety and
the public interest require adopting the AD as proposed.
Differences Between This AD and the MCAI or Service Information
We have reviewed the MCAI and related service information and, in
general, agree with their substance. But we might have found it
necessary to use different words from those in the MCAI to ensure the
AD is clear for U.S. operators and is enforceable. In making these
changes, we do not intend to differ substantively from the information
provided in the MCAI and related service information.
We might also have required different actions in this AD from those
in the MCAI in order to follow our FAA policies. Any such differences
are highlighted in a NOTE within the AD.
Costs of Compliance
We estimate that this AD will affect 21 products of U.S. registry.
We also estimate that it will take about 9 work-hours per product to
comply with the basic requirements of this AD. The average labor rate
is $85 per work-hour. Required parts will cost about $0 per product.
Where the service information lists required parts costs that are
covered under warranty, we have assumed that there will be no charge
for these parts. As we do not control warranty coverage for affected
parties, some parties may incur costs higher than estimated here. Based
on these figures, we estimate the cost of this AD to the U.S. operators
to be $16,065, or $765 per product.
Authority for This Rulemaking
Title 49 of the United States Code specifies the FAA's authority to
issue rules on aviation safety. Subtitle I, section 106, describes the
authority of the FAA Administrator. ``Subtitle VII: Aviation
Programs,'' describes in more detail the scope of the Agency's
authority.
We are issuing this rulemaking under the authority described in
``Subtitle VII, Part A, Subpart III, Section 44701: General
requirements.'' Under that section, Congress charges the FAA with
promoting safe flight of civil aircraft in air commerce by prescribing
regulations for practices, methods, and procedures the Administrator
finds necessary for safety in air commerce. This regulation is within
the scope of that authority because it addresses an unsafe condition
that is likely to exist or develop on products identified in this
rulemaking action.
Regulatory Findings
This AD will not have federalism implications under Executive Order
13132. This AD will not have a substantial direct effect on the States,
on the relationship between the national government and the States, or
on the distribution of power and responsibilities among the various
levels of government.
For the reasons discussed above, I certify that this AD:
1. Is not a ''significant regulatory action'' under Executive Order
12866;
2. Is not a ''significant rule'' under the DOT Regulatory Policies
and Procedures (44 FR 11034, February 26, 1979); and
3. Will not have a significant economic impact, positive or
negative, on a substantial number of small entities under the criteria
of the Regulatory Flexibility Act.
We prepared a regulatory evaluation of the estimated costs to
comply with this AD and placed it in the AD docket.
Examining the AD Docket
You may examine the AD docket on the Internet at http://www.regulations.gov; or in person at the Docket Operations office
between 9 a.m. and 5 p.m., Monday through Friday, except Federal
holidays. The AD docket contains the NPRM, the regulatory evaluation,
any comments received, and other information. The street address for
the Docket Operations office (telephone (800) 647-5527) is in the
ADDRESSES section. Comments will be available in the AD docket shortly
after receipt.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by
reference, Safety.
Adoption of the Amendment
Accordingly, under the authority delegated to me by the
Administrator, the FAA amends 14 CFR part 39 as follows:
PART 39--AIRWORTHINESS DIRECTIVES
0
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 [Amended]
0
2. The FAA amends Sec. 39.13 by adding the following new AD:
2011-09-18 Dassault-Aviation: Amendment 39-16680. Docket No. FAA-
2010-1207; Directorate Identifier 2010-NM-140-AD.
Effective Date
(a) This airworthiness directive (AD) becomes effective June 6,
2011.
Affected ADs
(b) None.
Applicability
(c) This AD applies to Dassault-Aviation Model FALCON 7X
airplanes, certificated in any category; except those having
incorporated modification M1031.
Subject
(d) Air Transport Association (ATA) of America Code 32: Landing
Gear.
Reason
(e) The mandatory continuing airworthiness information (MCAI)
states:
Following investigation of an in service event, it has been
determined that in case a short circuit occurs on a weight-on-wheels
(WOW) proximity sensor wiring, both circuit breakers that supply
power to that wiring will trip, causing simultaneous de-power of all
WOW proximity sensors of that part of the system. The loss of the
corresponding WOW information would lead to untimely inhibition of
warnings that could compromise the pilot capacity to react to
abnormal or failure landing conditions.
* * * * *
Compliance
(f) You are responsible for having the actions required by this
AD performed within the compliance times specified, unless the
actions have already been done.
Installation
(g) Within 27 months after the effective date of this AD, or
within 1,800 flight hours after the effective date of this AD,
whichever occurs first, install dedicated fuses on WOW proximity
sensors, in accordance with the Accomplishment Instructions of
Dassault Mandatory Service Bulletin 7X-065, dated July 24, 2009.
FAA AD Differences
Note 1: This AD differs from the MCAI and/or service information
as follows: No differences.
Other FAA AD Provisions
(h) The following provisions also apply to this AD:
(1) Alternative Methods of Compliance (AMOCs): The Manager,
International
[[Page 24360]]
Branch, ANM-116, Transport Airplane Directorate, FAA, has the
authority to approve AMOCs for this AD, if requested using the
procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19,
send your request to your principal inspector or local Flight
Standards District Office, as appropriate. If sending information
directly to the International Branch, send it to ATTN: Tom
Rodriguez, Aerospace Engineer, International Branch, ANM-116,
Transport Airplane Directorate, FAA, 1601 Lind Avenue, SW., Renton,
Washington 98057-3356; telephone (425) 227-1137; fax (425) 227-1149.
Information may be e-mailed to: [email protected].
Before using any approved AMOC, notify your appropriate principal
inspector, or lacking a principal inspector, the manager of the
local flight standards district office/certificate holding district
office. The AMOC approval letter must specifically reference this
AD.
(2) Airworthy Product: For any requirement in this AD to obtain
corrective actions from a manufacturer or other source, use these
actions if they are FAA-approved. Corrective actions are considered
FAA-approved if they are approved by the State of Design Authority
(or their delegated agent). You are required to assure the product
is airworthy before it is returned to service.
Related Information
(i) Refer to MCAI European Aviation Safety Agency Airworthiness
Directive 2010-0031, dated March 3, 2010; and Dassault Mandatory
Service Bulletin 7X-065, dated July 24, 2009; for related
information.
Material Incorporated by Reference
(j) You must use Dassault Mandatory Service Bulletin 7X-065,
dated July 24, 2009, to do the actions required by this AD, unless
the AD specifies otherwise.
(1) The Director of the Federal Register approved the
incorporation by reference of this service information under 5
U.S.C. 552(a) and 1 CFR part 51.
(2) For service information identified in this AD, contact
Dassault Falcon Jet, P.O. Box 2000, South Hackensack, New Jersey
07606; telephone 201-440-6700; Internet http://www.dassaultfalcon.com.
(3) You may review copies of the service information at the FAA,
Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton,
Washington. For information on the availability of this material at
the FAA, call 425-227-1221.
(4) You may also review copies of the service information that
is incorporated by reference at the National Archives and Records
Administration (NARA). For information on the availability of this
material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal_register/code_of_federal_regulations/ibr_locations.html.
Issued in Renton, Washington, on April 20, 2011.
Kalene C. Yanamura,
Acting Manager, Transport Airplane Directorate, Aircraft Certification
Service.
[FR Doc. 2011-10138 Filed 4-29-11; 8:45 am]
BILLING CODE 4910-13-P