[Federal Register Volume 76, Number 108 (Monday, June 6, 2011)]
[Proposed Rules]
[Pages 32845-32846]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 2011-13367]
Federal Register / Vol. 76, No. 108 / Monday, June 6, 2011 / Proposed
Rules
[[Page 32845]]
-----------------------------------------------------------------------
DEPARTMENT OF DEFENSE
Defense Acquisition Regulations System
48 CFR Part 252
RIN 0750-AH21
Defense Federal Acquisition Regulation Supplement; Definition of
``Qualifying Country End Product'' (DFARS Case 2011-D028)
AGENCY: Defense Acquisition Regulations System, Department of Defense
(DoD).
ACTION: Proposed rule.
-----------------------------------------------------------------------
SUMMARY: DoD is issuing a proposed rule to amend the definition of
``qualifying country end product'' by eliminating the component test
for qualifying country end products that are commercially available
off-the-shelf items.
DATES: Comments on the proposed rule should be submitted in writing to
the address shown below on or before August 5, 2011, to be considered
in the formation of the final rule.
ADDRESSES: Submit comments identified by DFARS Case 2011-D028, using
any of the following methods:
[cir] Regulations.gov: http://www.regulations.gov.
Submit comments via the Federal eRulemaking portal by inputting
``DFARS Case 2011-D028'' under the heading ``Enter keyword or ID'' and
selecting ``Search.'' Select the link ``Submit a Comment'' that
corresponds with ``DFARS Case 2011-D028.'' Follow the instructions
provided at the ``Submit a Comment'' screen. Please include your name,
company name (if any), and ``DFARS Case 2011-D028'' on your attached
document.
[cir] E-mail: [email protected]. Include DFARS Case 2011-D028 in the
subject line of the message.
[cir] Fax: 703-602-0350.
[cir] Mail: Defense Acquisition Regulations System, Attn: Amy G.
Williams, OUSD (AT&L) DPAP/DARS, Room 3B855, 3060 Defense Pentagon,
Washington, DC 20301-3060.
Comments received generally will be posted without change to http://www.regulations.gov, including any personal information provided. To
confirm receipt of your comment(s), please check http://www.regulations.gov approximately two to three days after submission to
verify posting (except allow 30 days for posting of comments submitted
by mail).
SUPPLEMENTARY INFORMATION:
I. Background
This rule proposes to amend the definition of ``qualifying country
end product'' to remove the component test for qualifying country end
products that are commercially available off-the-shelf items.
Under the Buy American Act, there is a two-part test to define a
domestic end product. The product must be manufactured in the United
States and there is a formula based on the cost of foreign components
compared to the cost of all components. Under FAR Case 2000-305, the
component test was waived for the acquisition of commercially available
off-the-shelf (COTS) items (see FAR 25.001(c)(1)). Likewise, the
component test for the DFARS definition of ``domestic end product'' was
waived by the interim rule of DFARS Case 2008-D009 (74 FR 2422, January
15, 2009) and final rule published December 24, 2009 (74 FR 68384).
These changes were based on a determination signed by the Administrator
for Federal Procurement Policy on February 14, 2008, regarding laws
applicable to the acquisition of COTS items. According to the
determination, the component test of the Buy American Act (41 U.S.C.
chapter 83) does not apply to COTS items.
The definition of ``qualifying country end product'' is not
statutory, but it was modeled after the definition of ``domestic end
product'' as a matter of policy. Therefore, it is within the authority
of DoD to change this definition as a matter of policy, to waive the
component test for qualifying country end products that are COTS items,
so that it will not be necessary to try to track the origin of
components of COTS items that are manufactured in a qualifying country,
in order to determine that an end product is a qualifying country end
product.
II. Executive Orders 12866 and 13563
Executive Orders (E.O.s) 12866 and 13563 direct agencies to assess
all costs and benefits of available regulatory alternatives and, if
regulation is necessary, to select regulatory approaches that maximize
net benefits (including potential economic, environmental, public
health and safety effects, distributive impacts, and equity). E.O.
13563 emphasizes the importance of quantifying both costs and benefits,
of reducing costs, of harmonizing rules, and of promoting flexibility.
This is a significant regulatory action and, therefore, was subject to
review under section 6(b) of E.O. 12866, Regulatory Planning and
Review, dated September 30, 1993. This rule is not a major rule under 5
U.S.C. 804.
III. Regulatory Flexibility Act
DoD does not expect this rule to have a significant impact on a
substantial number of small entities within the meaning of the
Regulatory Flexibility Act, 5 U.S.C. 601, et seq., because the rule
only affects manufacturers of COTS items in qualifying countries,
removing an administrative burden for the qualifying country
manufacturer and the Government personnel acquiring the items. The
Regulatory Flexibility Act is intended to protect small entities in the
United States, not foreign entities, regardless of size. For the
definition of ``small business'', the Regulatory Flexibility Act refers
to the Small Business Act, which in turn allows the SBA Administrator
to specify detailed definitions or standards. 5 U.S.C. 601(3) and 15
U.S.C. 632(a). The SBA regulations at 13 CFR 121.105 discuss who is a
small business: '' (a)(1) Except for small agricultural cooperatives, a
business concern eligible for assistance from SBA as a small business
is a business entity organized for profit, with a place of business
located in the United States, and which operates primarily within the
United States or which makes a significant contribution to the U.S.
economy through payment of taxes or use of American products, materials
or labor.'' The comparable change has already been enacted for the
benefit of U.S. manufacturers of COTS items in the DFARS which aligns
with the FAR. Therefore, an initial regulatory flexibility analysis has
not been performed. DoD invites comments from small business concerns
and other interested parties on the expected impact of this rule on
small entities.
DoD will also consider comments from small entities concerning the
existing regulations in subparts affected by this rule in accordance
with 5 U.S.C. 610. Interested parties must submit such comments
separately and should cite 5 U.S.C. 610 (DFARS Case 2011-D029) in
correspondence.
V. Paperwork Reduction Act
The rule does not contain any information collection requirements
that require the approval of the Office of Management and Budget under
the Paperwork Reduction Act (44 U.S.C. chapter 35).
[[Page 32846]]
List of Subjects in 48 CFR Part 252
Government procurement.
Ynette R. Shelkin,
Editor, Defense Acquisition Regulations System.
Therefore, 48 CFR part 252 is proposed to be amended as follows:
PART 252--SOLICITATION PROVISIONS AND CONTRACT CLAUSES
1. The authority citation for 48 CFR part 252 continues to read as
follows:
Authority: 41 U.S.C. 1303 and 48 CFR chapter 1.
2. Amend section 252.212-7001 by revising the clause date, and
paragraphs (b)(5)(i), (b)(11)(i), (b)(14)(i), (b)(20), and (b)(21) to
read as as follows:
252.212-7001 Contract terms and conditions required to implement
statutes or executive orders applicable to defense acquisitions of
commercial items.
* * * * *
CONTRACT TERMS AND CONDITIONS REQUIRED TO IMPLEMENT STATUTES OR
EXECUTIVE ORDERS APPLICABLE TO DEFENSE ACQUISITIONS OF COMMERCIAL ITEMS
(DATE)
* * * * *
(b) * * *
(5)(i)--------252.225-7001, Buy American Act and Balance of
Payments Program (DATE) (41 U.S.C. chapter 83, E.O. 10582).
* * * * *
(11)(i)--------252.225-7021, Trade Agreements (DATE) (19 U.S.C.
2501-2518 and 19 U.S.C. 3301 note)
* * * * *
(14)(i)-------- 252.225-7036, Buy American Act--Free Trade
Agreements--Balance of Payments Program (DATE) (41 U.S.C. chapter 83
and 19 U.S.C. 3301 note)
* * * * *
(20)--------252.237-7010, Prohibition on Interrogation of
Detainees by Contractor Personnel (NOV 2010) (Section 1038 of Pub.
L. 111-84).
(21)--------252.237-7019, Training for Contractor Personnel
Interacting with Detainees (SEP 2006) (Section 1092 of Public Law
108-375).
* * * * *
3. Amend section 252.225-7001 by revising the clause date,
paragraph (a)(8), and paragraph (b) to read as follows:
252.225-7001 Buy American Act and Balance of Payments Program.
* * * * *
BUY AMERICAN ACT AND BALANCE OF PAYMENTS PROGRAM (DATE)
(a) * * *
(8) Qualifying country end product means--
(i) An unmanufactured end product mined or produced in a
qualifying country; or
(ii) An end product manufactured in a qualifying country if--
(A) The cost of the following types of components exceeds 50
percent of the cost of all its components:
(1) Components mined, produced, or manufactured in a qualifying
country.
(2) Components mined, produced, or manufactured in the United
States.
(3) Components of foreign origin of a class or kind for which
the Government has determined that sufficient and reasonably
available commercial quantities of a satisfactory quality are not
mined, produced, or manufactured in the United States; or
(B) The end product is a COTS item.
* * * * *
(b) This clause implements the Buy American Act (41 U.S.C.
chapter 83). In accordance with 41 U.S.C. 1907, the component test
of the Buy American Act is waived for an end product that is a COTS
item (see section 12.505(a)(1) of the Federal Acquisition
Regulation). Unless otherwise specified, this clause applies to all
line items in the contract.
* * * * *
4. Amend section 252.225-7021 by revising the clause date and
paragraph (a)(10) to read as follows:
252.225-7021 Trade agreements.
* * * * *
TRADE AGREEMENTS (DATE)
(a) * * *
(10) Qualifying country end product means--
(i) An unmanufactured end product mined or produced in a
qualifying country; or
(ii) An end product manufactured in a qualifying country if--
(A) The cost of the following types of components exceeds 50
percent of the cost of all its components:
(1) Components mined, produced, or manufactured in a qualifying
country.
(2) Components mined, produced, or manufactured in the United
States.
(3) Components of foreign origin of a class or kind for which
the Government has determined that sufficient and reasonably
available commercial quantities of a satisfactory quality are not
mined, produced, or manufactured in the United States; or
(B) The end product is a COTS item.
* * * * *
5. Amend section 252.225-7036 by revising the clause date and
paragraph (a)(13) to read as follows:
252.225-7036 Buy American Act--Free Trade Agreements--Balance of
Payments Program.
* * * * *
BUY AMERICAN ACT--FREE TRADE AGREEMENTS--BALANCE OF PAYMENTS PROGRAM
(DATE)
(a) * * *
(13) Qualifying country end product means--
(i) An unmanufactured end product mined or produced in a
qualifying country; or
(ii) An end product manufactured in a qualifying country if--
(A) The cost of the following types of components exceeds 50
percent of the cost of all its components:
(1) Components mined, produced, or manufactured in a qualifying
country.
(2) Components mined, produced, or manufactured in the United
States.
(3) Components of foreign origin of a class or kind for which
the Government has determined that sufficient and reasonably
available commercial quantities of a satisfactory quality are not
mined, produced, or manufactured in the United States; or
(B) The end product is a COTS item.
* * * * *
[FR Doc. 2011-13367 Filed 6-3-11; 8:45 am]
BILLING CODE 5001-08-P