[Federal Register Volume 76, Number 68 (Friday, April 8, 2011)]
[Proposed Rules]
[Pages 19714-19716]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 2011-8409]
-----------------------------------------------------------------------
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
14 CFR Part 39
[Docket No. FAA-2011-0305; Directorate Identifier 2010-NM-186-AD]
RIN 2120-AA64
Airworthiness Directives; Airbus Model A320-214, -232, and -233
Airplanes
AGENCY: Federal Aviation Administration (FAA), DOT.
ACTION: Notice of proposed rulemaking (NPRM).
-----------------------------------------------------------------------
SUMMARY: We propose to adopt a new airworthiness directive (AD) for the
products listed above. This proposed AD results from mandatory
continuing airworthiness information (MCAI) originated by an aviation
authority of another country to identify and correct an unsafe
condition on an aviation product. The MCAI describes the unsafe
condition as:
* * * * *
Results from a design review done by AIRBUS for documentation
update have revealed that, on post-mod 38310 A320 aeroplanes only,
in case of emergency electrical configuration combined with a Green
and Yellow hydraulic system loss, during landing phase (nose landing
gear extended), the roll control would only be provided by the left
aileron.
This condition, if not corrected, could lead to an asymmetrical
landing configuration, resulting in reduced control of the
aeroplane.
* * * * *
The proposed AD would require actions that are intended to address the
unsafe condition described in the MCAI.
DATES: We must receive comments on this proposed AD by May 23, 2011.
ADDRESSES: You may send comments by any of the following methods:
Federal eRulemaking Portal: Go to http://www.regulations.gov. Follow the instructions for submitting comments.
Fax: (202) 493-2251.
Mail: U.S. Department of Transportation, Docket
Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New
Jersey Avenue, SE., Washington, DC 20590.
Hand Delivery: U.S. Department of Transportation, Docket
Operations, M-30, West Building Ground Floor, Room W12-40, 1200 New
Jersey Avenue, SE., Washington, DC, between 9 a.m. and 5 p.m., Monday
through Friday, except Federal holidays.
For service information identified in this proposed AD, contact
Airbus, Airworthiness Office--EAS, 1 Rond Point Maurice Bellonte, 31707
Blagnac
[[Page 19715]]
Cedex, France; telephone +33 5 61 93 36 96; fax +33 5 61 93 44 51; e-
mail: [email protected]; Internet http://www.airbus.com.
You may review copies of the referenced service information at the FAA,
Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton,
Washington. For information on the availability of this material at the
FAA, call 425-227-1221.
Examining the AD Docket
You may examine the AD docket on the Internet at http://www.regulations.gov; or in person at the Docket Operations office
between 9 a.m. and 5 p.m., Monday through Friday, except Federal
holidays. The AD docket contains this proposed AD, the regulatory
evaluation, any comments received, and other information. The street
address for the Docket Operations office (telephone (800) 647-5527) is
in the ADDRESSES section. Comments will be available in the AD docket
shortly after receipt.
FOR FURTHER INFORMATION CONTACT: Sanjay Ralhan, Aerospace Engineer,
International Branch, ANM-116, Transport Airplane Directorate, FAA,
1601 Lind Avenue, SW., Renton, Washington 98057-3356; telephone (425)
227-1405; fax (425) 227-1149.
SUPPLEMENTARY INFORMATION:
Comments Invited
We invite you to send any written relevant data, views, or
arguments about this proposed AD. Send your comments to an address
listed under the ADDRESSES section. Include ``Docket No. FAA-2011-0305;
Directorate Identifier 2010-NM-186-AD'' at the beginning of your
comments. We specifically invite comments on the overall regulatory,
economic, environmental, and energy aspects of this proposed AD. We
will consider all comments received by the closing date and may amend
this proposed AD based on those comments.
We will post all comments we receive, without change, to http://www.regulations.gov, including any personal information you provide. We
will also post a report summarizing each substantive verbal contact we
receive about this proposed AD.
Discussion
The European Aviation Safety Agency (EASA), which is the Technical
Agent for the Member States of the European Community, has issued EASA
Airworthiness Directive 2010-0149, dated July 21, 2010 (referred to
after this as ``the MCAI''), to correct an unsafe condition for the
specified products. The MCAI states:
In 2007, Airbus modification 38310 was introduced in production
to simplify the ELAC2 [elevator aileron computer] and Trimmable
Horizontal Stabiliser (THS) Motor 1 stand by power supply logic.
Results from a design review done by AIRBUS for documentation
update have revealed that, on post-mod 38310 A320 aeroplanes only,
in case of emergency electrical configuration combined with a Green
and Yellow hydraulic system loss, during landing phase (nose landing
gear extended), the roll control would only be provided by the left
aileron.
This condition, if not corrected, could lead to an asymmetrical
landing configuration, resulting in reduced control of the
aeroplane.
For the reasons described above, this [EASA] AD requires a
modification of the electrical installation of ELAC2 and THS Motor 1
power supply, restoring the aeroplane to the pre-mod 38310
configuration.
You may obtain further information by examining the MCAI in the AD
docket.
Relevant Service Information
Airbus has issued Mandatory Service Bulletin A320-27-1199, Revision
02, including Appendix 01, dated September 20, 2010. The actions
described in this service information are intended to correct the
unsafe condition identified in the MCAI.
FAA's Determination and Requirements of This Proposed AD
This product has been approved by the aviation authority of another
country, and is approved for operation in the United States. Pursuant
to our bilateral agreement with the State of Design Authority, we have
been notified of the unsafe condition described in the MCAI and service
information referenced above. We are proposing this AD because we
evaluated all pertinent information and determined an unsafe condition
exists and is likely to exist or develop on other products of the same
type design.
Differences Between This AD and the MCAI or Service Information
We have reviewed the MCAI and related service information and, in
general, agree with their substance. But we might have found it
necessary to use different words from those in the MCAI to ensure the
AD is clear for U.S. operators and is enforceable. In making these
changes, we do not intend to differ substantively from the information
provided in the MCAI and related service information.
We might also have proposed different actions in this AD from those
in the MCAI in order to follow FAA policies. Any such differences are
highlighted in a Note within the proposed AD.
Costs of Compliance
Based on the service information, we estimate that this proposed AD
would affect about 666 products of U.S. registry. We also estimate that
it would take about 35 work-hours per product to comply with the basic
requirements of this proposed AD. The average labor rate is $85 per
work-hour. Required parts would cost about $3,370 per product. Where
the service information lists required parts costs that are covered
under warranty, we have assumed that there will be no charge for these
costs. As we do not control warranty coverage for affected parties,
some parties may incur costs higher than estimated here. Based on these
figures, we estimate the cost of the proposed AD on U.S. operators to
be $4,225,770, or $6,345 per product.
Authority for This Rulemaking
Title 49 of the United States Code specifies the FAA's authority to
issue rules on aviation safety. Subtitle I, section 106, describes the
authority of the FAA Administrator. ``Subtitle VII: Aviation
Programs,'' describes in more detail the scope of the Agency's
authority.
We are issuing this rulemaking under the authority described in
``Subtitle VII, Part A, Subpart III, Section 44701: General
requirements.'' Under that section, Congress charges the FAA with
promoting safe flight of civil aircraft in air commerce by prescribing
regulations for practices, methods, and procedures the Administrator
finds necessary for safety in air commerce. This regulation is within
the scope of that authority because it addresses an unsafe condition
that is likely to exist or develop on products identified in this
rulemaking action.
Regulatory Findings
We determined that this proposed AD would not have federalism
implications under Executive Order 13132. This proposed AD would not
have a substantial direct effect on the States, on the relationship
between the national Government and the States, or on the distribution
of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify this proposed
regulation:
1. Is not a ``significant regulatory action'' under Executive Order
12866;
2. Is not a ``significant rule'' under the DOT Regulatory Policies
and Procedures (44 FR 11034, February 26, 1979); and
3. Will not have a significant economic impact, positive or
negative, on a substantial number of small entities
[[Page 19716]]
under the criteria of the Regulatory Flexibility Act.
We prepared a regulatory evaluation of the estimated costs to
comply with this proposed AD and placed it in the AD docket.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by
reference, Safety.
The Proposed Amendment
Accordingly, under the authority delegated to me by the
Administrator, the FAA proposes to amend 14 CFR part 39 as follows:
PART 39--AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 [Amended]
2. The FAA amends Sec. 39.13 by adding the following new AD:
Airbus: Docket No. FAA-2011-0305; Directorate Identifier 2010-NM-
186-AD.
Comments Due Date
(a) We must receive comments by May 23, 2011.
Affected ADs
(b) None.
Applicability
(c) This AD applies to Airbus Model A320-214, -232, and -233
airplanes, all manufacturer serial numbers on which Airbus
modification 38310 has been accomplished in production; certificated
in any category.
Subject
(d) Air Transport Association (ATA) of America Code 27: Flight
Controls.
Reason
(e) The mandatory continuing airworthiness information (MCAI)
states:
* * * * *
Results from a design review done by AIRBUS for documentation
update have revealed that, on post-mod 38310 A320 aeroplanes only,
in case of emergency electrical configuration combined with a Green
and Yellow hydraulic system loss, during landing phase (nose landing
gear extended), the roll control would only be provided by the left
aileron.
This condition, if not corrected, could lead to an asymmetrical
landing configuration, resulting in reduced control of the
aeroplane.
* * * * *
Compliance
(f) You are responsible for having the actions required by this
AD performed within the compliance times specified, unless the
actions have already been done.
Actions
(g) Within 24 months after the effective date of this AD, modify
the electrical installation of the elevator aileron computer and
trimmable horizontal stabilizer motor 1 power supply, in accordance
with the Accomplishment Instructions of Airbus Mandatory Service
Bulletin A320-27-1199, Revision 02, dated September 20, 2010.
Credit for Actions Accomplished in Accordance With Previous Service
Information
(h) Modifications done before the effective date of this AD in
accordance with Airbus Service Bulletin A320-27-1199, Revision 01,
dated March 4, 2010, are acceptable for compliance with the
requirements of paragraph (g) of this AD.
FAA AD Differences
Note 1: This AD differs from the MCAI and/or service information
as follows: No differences.
Other FAA AD Provisions
(i) The following provisions also apply to this AD:
(1) Alternative Methods of Compliance (AMOCs): The Manager,
International Branch, ANM-116, Transport Airplane Directorate, FAA,
has the authority to approve AMOCs for this AD, if requested using
the procedures found in 14 CFR 39.19. In accordance with 14 CFR
39.19, send your request to your principal inspector or local Flight
Standards District Office, as appropriate. If sending information
directly to the International Branch, sent it to ATTN: Sanjay
Ralhan, Aerospace Engineer, International Branch, ANM-116, Transport
Airplane Directorate, FAA, 1601 Lind Avenue, SW., Renton, Washington
98057-3356; telephone (425) 227-1405; fax (425) 227-1149.
Information may be e-mailed to: [email protected].
Before using any approved AMOC, notify your appropriate principal
inspector, or lacking a principal inspector, the manager of the
local flight standards district office/certificate holding district
office. The AMOC approval letter must specifically reference this
AD.
(2) Airworthy Product: For any requirement in this AD to obtain
corrective actions from a manufacturer or other source, use these
actions if they are FAA-approved. Corrective actions are considered
FAA-approved if they are approved by the State of Design Authority
(or their delegated agent). You are required to assure the product
is airworthy before it is returned to service.
Related Information
(j) Refer to MCAI European Aviation Safety Agency (EASA)
Airworthiness Directive 2010-0149, dated July 21, 2010; and Airbus
Mandatory Service Bulletin A320-27-1199, Revision 02, dated
September 20, 2010; for related information.
Issued in Renton, Washington, on March 25, 2011.
Ali Bahrami,
Manager, Transport Airplane Directorate, Aircraft Certification
Service.
[FR Doc. 2011-8409 Filed 4-7-11; 8:45 am]
BILLING CODE 4910-13-P