[Code of Federal Regulations]
[Title 24, Volume 5]
[Revised as of April 1, 2001]
From the U.S. Government Printing Office via GPO Access
[CITE: 24CFR3282.7]

[Page 199-201]
 
                 TITLE 24--HOUSING AND URBAN DEVELOPMENT
 
 CHAPTER XX--OFFICE OF ASSISTANT SECRETARY FOR HOUSING--FEDERAL HOUSING 
        COMMISSIONER, DEPARTMENT OF HOUSING AND URBAN DEVELOPMENT
 
PART 3282--MANUFACTURED HOME PROCEDURAL AND ENFORCEMENT REGULATIONS--Table of Contents
 
                           Subpart A--General
 
Sec. 3282.7  Definitions.

    The terms Department, HUD, and Secretary are defined in 24 CFR part 
5.
    (a) Act means the National Manufactured Housing Construction and 
Safety Standards Act of 1974, title VI of the Housing and Community 
Development Act of 1974 (42 U.S.C. 5401 et seq.)
    (b) Add-on means any structure (except a structure designed or 
produced as an integral part of a manufactured home) which, when 
attached to the basic manufactured home unit, increases the area, either 
living or storage, of the manufactured home.
    (c) Alteration means the replacement, addition, and modification, or 
removal of any equipment or installation after sale by a manufacturer to 
a dealer or distributor but prior to sale by a dealer to a purchaser 
which may affect the construction, fire safety, occupancy, plumbing, 
heat-producing or electrical system. It includes any modification made 
in the manufactured home which may affect the compliance of the home 
with the standards, but it does not include the repair or replacement of 
a component or appliance requiring plug-in to an electrical receptacle 
where the replaced item is of the same configuration and rating as the 
one being replaced. It also does not include the addition of an 
appliance requiring plug-in to an electrical receptacle, which appliance 
was not provided with the manufactured home by the manufacturer, if the 
rating of the appliance does not exceed the rating of the receptacle to 
which it is connected.
    (d) Certification label see label.
    (e) Certification report means the report prepared by an IPIA (see 
definition z) for each manufactured home manufacturing plant under 
Sec. 3282.203 in which the IPIA provides a complete description of the 
initial comprehensive inspection of the plant, an evaluation of the 
quality assurance program under the approved quality assurance manual, 
and the identity of the DAPIA (see definition z) which approved the 
designs and quality assurance manual used in the plant. Where 
appropriate under Sec. 3282.362(b)(5), the certification report may be 
made by a DAPIA.
    (f) Component means any part, material or appliance which is built 
in as an integral part of the manufactured home during the manufacturing 
process.
    (g) Cost information means information submitted by a manufacturer 
under section 607 of the Act with respect to alleged cost increases 
resulting from action by the Secretary, in such form as to permit the 
public and the Secretary to make an informed judgment on the validity of 
the manufacturer's statements. Such term includes both the 
manufacturer's cost and the cost to retail purchasers.
    (h) Date of manufacture means the date on which the label required 
by Sec. 3282.205(c) is affixed to the manufactured home.
    (i) Dealer means any person engaged in the sale, leasing, or 
distribution of new manufactured homes primarily to persons who in good 
faith purchase or lease a manufactured home for purposes other than 
resale.
    (j) Defect means a failure to comply with an applicable Federal 
manufactured home safety and construction standard that renders the 
manufactured home or any part or component thereof not fit for the 
ordinary use for which it was intended, but does not result in an 
unreasonable risk of injury or death to occupants of the affected 
manufactured home. See related definitions of imminent safety hazard 
(definition q), noncompliance (definition x), and serious defect 
(definition ff).

[[Page 200]]

    (k) Design means drawings, specifications, sketches and the related 
engineering calculations, tests and data in support of the 
configurations, structures and systems to be incorporated in 
manufactured homes manufactured in a plant.
    (l) Director means the Director of the Manufactured Housing 
Standards Division.
    (m) Distributor means any person engaged in the sale and 
distribution of manufactured homes for resale.
    (n) Failure to conform means an imminent safety hazard related to 
the standards, a serious defect, defect, or noncompliance and is used as 
a substitute for all of those terms.
    (o) [Reserved]
    (p) Imminent safety hazard means a hazard that presents an imminent 
and unreasonable risk of death or severe personal injury that may or may 
not be related to failure to comply with an applicable Federal 
manufactured home construction or safety standard. See related 
definitions of defect (definition j), noncompliance (paragraph x) and 
serious defect (paragraph ff).
    (q) Joint monitoring team means a monitoring inspection team 
composed of personnel provided by the various State Administrative 
Agencies, or by HUD or its contract agent, operating under a contract 
with HUD for the purpose of monitoring, or otherwise aiding in the 
enforcement of the Federal standards.
    (r) Label or certification label means the approved form of 
certification by the manufacturer that, under Sec. 3282.362(c)(2)(i), is 
permanently affixed to each transportable section of each manufactured 
home manufactured for sale to a purchaser in the United States.
    (s) (Same as Sec. 3280.2(a)(13).)
    (t) Manufacturer means any person engaged in manufacturing or 
assembling manufactured homes, including any person engaged in importing 
manufactured homes for resale.
    (u) (Same as Sec. 3280.2(a)(16).)
    (v) Manufactured home construction means all activities relating to 
the assembly and manufacture of a manufactured home including but not 
limited to those relating to durability, quality, and safety.
    (w) Manufactured home safety means the performance of a manufactured 
home in such a manner that the public is protected against any 
unreasonable risk of the occurrence of accidents due to the design or 
construction of such manufactured home, or any unreasonable risk of 
death or injury to the user or to the public if such accidents do occur.
    (x) Noncompliance means a failure of a manufactured home to comply 
with a Federal manufactured home construction or safety standard that 
does not constitute a defect, serious defect, or imminent safety hazard. 
See related definitions or defect (definition j), imminent safety hazard 
(definition q), and serious defect (definition ff).
    (y) Owner means any person purchasing a manufactured home from any 
other person after the first purchase of the manufactured home, in good 
faith, for purposes other than resale.
    (z) Primary Inspection Agency (PIA) means a State/or private 
organization that has been accepted by the Secretary in accordance with 
the requirement of subpart H of this part. There are two types of PIA:
    (1) Design Approval PIA (DAPIA), which evaluates and approves or 
disapproves manufactured home designs and quality control procedures, 
and
    (2) Production Inspection PIA (IPIA), which evaluates the ability of 
manufactured home manufacturing plants to follow approved quality 
control procedures and provides ongoing surveillance of the 
manufacturing process. Organizations may act as one or both of these 
types.
    (aa) Purchaser means the first person purchasing a manufactured home 
in good faith for purposes other than resale.
    (bb) Quality Assurance Manual means a manual, prepared by each 
manufacturer for its manufacturing plants and approved by a DAPIA which 
contains: a statement of the manufacturer's quality assurance program, a 
chart of the organization showing, by position, all personnel 
accountable for quality assurance, a list of tests and test equipment 
required, a station-by-station description of the manufacturing process, 
a list of inspections required at each station, and a list by title of 
personnel

[[Page 201]]

in the manufacturer's organization to be held responsible for each 
inspection. Where necessary, the quality assurance manual used in a 
particular plant shall contain information specific to that plant.
    (cc) To red tag means to affix a notice to a manufactured home which 
has been found to contain an imminent safety hazard or a failure to 
conform with any applicable standard. A red tag is the notice so affixed 
to the manufactured home.
    (dd) [Reserved]
    (ee) Secretary's agent means a party operating as an independent 
contractor under a contract with HUD.
    (ff) Serious defect means any failure to comply with an applicable 
Federal manufactured home construction and safety standard that renders 
the manufactured home or any part thereof not fit for the ordinary use 
for which it was intended and which results in an unreasonable risk of 
injury or death to occupants of the affected manufactured home.
    (gg) Standards means the Federal manufactured home construction and 
safety standards promulgated under section 604 of the Act, 42 U.S.C. 
5403, as part 3280 of these regulations.
    (hh) State includes each of the several States, the District of 
Columbia, the Commonwealth of Puerto Rico, Guam, the Virgin Islands, the 
Canal Zone, and American Samoa.
    (ii) State Administrative Agency (SAA) means an agency of a State 
which has been approved or conditionally approved to carry out the State 
plan for enforcement of the standards pursuant to section 623 of the 
Act, 42 U.S.C. 5422, and subpart G of this part.
    (jj) State plan application means the application of any State 
organization which is submitted to the Secretary for approval as a State 
Administrative Agency under subpart G.
    (kk) System means a set or arrangement of materials or components 
related or connected as to form an operating entity, i.e., heating, 
ventilating and air-conditioning systems, evaporative coolers.
    (ll) [Reserved]
    (mm) United States District Courts means the Federal district courts 
of the United States and the United States courts of the Commonwealth of 
Puerto Rico, Guam, the Virgin Islands, the Canal Zone, and American 
Samoa.
    (nn) (Same as Sec. 3280.2(a)(22).)

[41 FR 19852, May 13, 1976, as amended at 41 FR 24971, June 21, 1976; 47 
FR 28093, June 29, 1982; 61 FR 5216, Feb. 9, 1996; 61 FR 10859, Mar. 15, 
1996]