[Code of Federal Regulations] [Title 30, Volume 2] [Revised as of July 1, 2001] From the U.S. Government Printing Office via GPO Access [CITE: 30CFR250.102] [Page 245] TITLE 30--MINERAL RESOURCES CHAPTER II--MINERALS MANAGEMENT SERVICE, DEPARTMENT OF THE INTERIOR PART 250--OIL AND GAS AND SULPHUR OPERATIONS IN THE OUTER CONTINENTAL SHELF--Table of Contents Subpart A--General Sec. 250.102 What does this part do? (a) 30 CFR part 250 contains the regulations of the MMS Offshore program that govern oil, gas, and sulphur exploration, development, and production operations on the OCS. When you conduct operations on the OCS, you must submit requests, applications, and notices, or provide supplemental information for MMS approval. (b) The following table of general references shows where to look for information about these processes. Table--Where To Find Information for Conducting Operations ------------------------------------------------------------------------ For information about Refer to ------------------------------------------------------------------------ (1) Abandoning wells........................ Sec. 250.701. (2) Applications for Permit to Drill........ Sec. 250.414. (3) Development and Production Plans (DPP).. Sec. 250.204. (4) Downhole commingling.................... Sec. 250.1106. (5) Exploration Plans (EP).................. Sec. 250.203. (6) Flaring................................. Sec. 250.1105. (7) Gas measurement......................... Sec. 250.1203. (8) Off-lease geological and geophysical 30 CFR 251. permits. (9) Oil spill financial responsibility 30 CFR 253. coverage. (10) Oil and gas production safety systems... Sec. 250.802. (11) Oil spill response plans................ 30 CFR 254. (12) Oil and gas well-completion operations.. Sec. 250.513. (13) Oil and gas well-workover operations.... Sec. 250.613. (14) Platforms and structures................ Sec. 250.901. (15) Pipelines............................... Sec. 250.1009. (16) Pipeline right-of-way................... Sec. 250.1010. (17) Sulphur operations...................... Sec. 250.1604. (18) Training................................ Sec. 250.1500. (19) Unitization............................. Sec. 250.1300. ------------------------------------------------------------------------