[Code of Federal Regulations]
[Title 30, Volume 2]
[Revised as of July 1, 2001]
From the U.S. Government Printing Office via GPO Access
[CITE: 30CFR250.110]

[Page 251]
 
                       TITLE 30--MINERAL RESOURCES
 
                CHAPTER II--MINERALS MANAGEMENT SERVICE,
                       DEPARTMENT OF THE INTERIOR
 
PART 250--OIL AND GAS AND SULPHUR OPERATIONS IN THE OUTER CONTINENTAL SHELF--Table of Contents
 
                           Subpart A--General
 
Sec. 250.110  What must I include in my welding plan?

    You must include all of the following in the Welding Plan that you 
prepare under Sec. 250.109:
    (a) Standards or requirements for welders;
    (b) How you will ensure that only qualified personnel weld;
    (c) Practices and procedures for safe welding that address:
    (1) Welding in designated safe areas;
    (2) Welding in undesignated areas, including wellbay;
    (3) Fire watches;
    (4) Maintenance of welding equipment; and
    (5) Plans showing all designated safe-welding areas.
    (d) How you will prevent spark-producing activities (i.e., grinding, 
abrasive blasting/cutting and arc-welding) in hazardous locations.