[Code of Federal Regulations]
[Title 15, Volume 2]
[Revised as of January 1, 2002]
From the U.S. Government Printing Office via GPO Access
[CITE: 15CFR738.2]

[Page 238-240]
 
                  TITLE 15--COMMERCE AND FOREIGN TRADE
 
  CHAPTER VII--BUREAU OF EXPORT ADMINISTRATION, DEPARTMENT OF COMMERCE
 
PART 738--COMMERCE CONTROL LIST OVERVIEW AND THE COUNTRY CHART--Table of Contents
 
Sec. 738.2  Commerce Control List (CCL) structure.

    (a) Categories. The CCL is divided into 10 categories, numbered as 
follows:

0--Nuclear Materials, Facilities and Equipment and Miscellaneous
1--Materials, Chemicals, ``Microorganisms,'' and Toxins
2--Materials Processing
3--Electronics
4--Computers
5--Telecommunications and Information Security
6--Lasers and Sensors
7--Navigation and Avionics
8--Marine
9--Propulsion Systems, Space Vehicles and Related Equipment

    (b) Groups. Within each category, items are arranged by group. Each 
category contains the same five groups. Each Group is identified by the 
letters A through E, as follows:

A--Equipment, Assemblies and Components
B--Test, Inspection and Production Equipment
C--Materials
D--Software
E--Technology

    (c) Order of review. In order to classify your item against the CCL, 
you should begin with a review of the general characteristics of your 
item. This will usually guide you to the appropriate category on the 
CCL. Once the appropriate category is identified, you should match the 
particular characteristics and functions of your item to a specific 
ECCN. If the ECCN contains a list under the ``Items'' heading, you 
should review the list to determine within which subparagraph(s) your 
items are identified.
    (d) Entries. (1) Composition of an entry. Within each group, 
individual items are identified by an Export Control Classification 
Number (ECCN). Each number consists of a set of digits and a letter. The 
first digit identifies the general category within which the entry falls 
(e.g., 3A001). The letter immediately following this first digit 
identifies under which of the five groups the item is listed (e.g., 3 
A001). The second digit differentiates individual entries by identifying 
the type of controls associated with the items contained in the entry 
(e.g., 3A001). Listed below are the Reasons for Control associated with 
this second digit.

0: National Security reasons (including Dual Use and International 
          Munitions List) and Items on the NSG Dual Use Annex and 
          Trigger List
1: Missile Technology reasons
2: Nuclear Nonproliferation reasons
3: Chemical & Biological Weapons reasons
9: Anti-terrorism, Crime Control, Regional Stability, Short Supply, UN 
          Sanctions, etc.

    (i) Since Reasons for Control are not mutually exclusive, numbers 
are assigned in order of precedence. As an example, if an item is 
controlled for both

[[Page 239]]

National Security and Missile Technology reasons, the entry's third 
digit will be a ``0''. If the item is controlled only for Missile 
Technology the third digit will be ``1''.
    (ii) The numbers in either the second or third digit (e.g., 3A001) 
serve to differentiate between multilateral and unilateral entries. An 
entry with the number ``9'' as the second digit, identifies the entire 
entry as controlled for a unilateral concern (e.g., 2B991 for anti-
terrorism reasons). If the number ``9'' appears as the third digit, the 
item is controlled for unilateral purposes based on a proliferation 
concern (e.g., 2A292 is controlled for unilateral purposes based on 
nuclear nonproliferation concerns).
    (iii) The last digit within each entry (e.g., 3A001) is used for the 
sequential numbering of ECCNs to differentiate between entries on the 
CCL.
    (2) Reading an ECCN. A brief description is provided next to each 
ECCN. Following this description is the actual entry containing 
``License Requirements,'' ``License Exceptions,'' and ``List of Items 
Controlled'' sections. A brief description of each section and its use 
follows:
    (i) License Requirements. This section contains a separate line 
identifying all possible Reasons for Control in order of precedence, and 
two columns entitled ``Control(s)'' and ``Country Chart''.
    (A) The ``Controls'' header identifies all applicable Reasons for 
Control, in order of restrictiveness, and to what extent each applies 
(e.g., to the entire entry or only to certain subparagraphs). Those 
requiring licenses for a larger number of countries and/or items are 
listed first. As you read down the list the number of countries and/or 
items requiring a license declines. Since Reasons for Control are not 
mutually exclusive, items controlled within a particular ECCN may be 
controlled for more than one reason. The following is a list of all 
possible Reasons for Control:

AT  Anti-Terrorism
CB  Chemical & Biological Weapons
CC  Crime Control
CW  Chemical Weapons Convention
EI  Encryption Items
FC Firearms Convention
MT  Missile Technology
NS  National Security
NP  Nuclear Nonproliferation
RS  Regional Stability
SS  Short Supply
XP  Computers
SI  Significant Items

    (B) The ``Country Chart'' header identifies, for each applicable 
Reason for Control, a column name and number (e.g., CB Column 1). These 
column identifiers are used to direct you from the CCL to the 
appropriate column identifying the countries requiring a license. 
Consult part 742 of the EAR for an indepth discussion of the licensing 
requirements and policies applicable to each Country Chart column.
    (ii) License Exceptions. This section provides a brief eligibility 
statement for each ECCN-driven License Exception that may be applicable 
to your transaction, and should be consulted only AFTER you have 
determined a license is required based on an analysis of the entry and 
the Country Chart. The brief eligibility statement in this section is 
provided to assist you in deciding which ECCN-driven License Exception 
related to your particular item and destination you should explore prior 
to submitting an application. The term ``Yes'' (followed in some 
instances by the scope of Yes) appears next to each available ECCN-
driven License Exception. The term ``N/A'' will be noted for License 
Exceptions that are not available within a particular entry. If one or 
more License Exceptions appear to apply to your transaction, you must 
consult part 740 of the EAR to review the conditions and restrictions 
applicable to each available License Exception. The list of License 
Exceptions contained within each ECCN is not an all-exclusive list. 
Other License Exceptions, not based on particular ECCNs, may be 
available. Consult part 740 of the EAR to determine eligibility for non-
ECCN-driven License Exceptions.
    (iii) List of Items Controlled--(A) Units. The unit of measure 
applicable to each entry is identified in the ``Units'' header. Most 
measurements used in the CCL are expressed in metric units with an inch-
pound conversion where appropriate. Note that in some ECCNs the inch-
pound unit will be listed first. In instances where other units are in 
general usage or specified by law, these

[[Page 240]]

will be used instead of metric. Generally, when there is a difference 
between the metric and inch-pound figures, the metric standard will be 
used for classification and licensing purposes.
    (B) Related definitions. This header identifies, where appropriate, 
definitions or parameters that apply to all items controlled by the 
entry. The information provided in this section is unique to the entry, 
and hence not listed in the definitions contained in part 772 of the 
EAR.
    (C) Related controls. If another U.S. government agency or 
department has export licensing authority over items related to those 
controlled by an entry, a statement is included identifying the agency 
or department along with the applicable regulatory cite. An additional 
cross-reference may be included in instances where the scope of controls 
differs between a CCL entry and its corresponding entry on list 
maintained by the European Union. This information is provided to assist 
readers who use both lists.
    (D) Items. This header contains a positive list of all items 
controlled by a particular entry and must be reviewed to determine 
whether your item is controlled by that entry. In some entries, the list 
is contained within the entry heading. In these entries a note is 
included to direct you to the entry heading.

[61 FR 112756, Mar. 25, 1996, as amended at 61 FR 68579, Dec. 30, 1996; 
62 FR 25456, May 9, 1997; 64 FR 17970, Apr. 13, 1999; 27141, May 18, 
1999]