[Code of Federal Regulations]
[Title 30, Volume 1]
[Revised as of July 1, 2002]
From the U.S. Government Printing Office via GPO Access
[CITE: 30CFR18.13]

[Page 93]
 
                       TITLE 30--MINERAL RESOURCES
 
  CHAPTER I--MINE SAFETY AND HEALTH ADMINISTRATION, DEPARTMENT OF LABOR
 
PART 18--ELECTRIC MOTOR-DRIVEN MINE EQUIPMENT AND ACCESSORIES--Table of Contents
 
                      Subpart A--General Provisions
 
Sec. 18.13  Certification plate.

    Each certified component shall be identified by a certification 
plate attached to the component in a manner acceptable to MSHA. The 
method of attachment shall not impair any explosion-proof 
characteristics of the component. The plate shall be of serviceable 
material, acceptable, to MSHA, and shall contain the following:

Certified as complying with the applicable requirements of 30 CFR part 
--------.
Certification No.--------.


The blank spaces shall be filled with appropriate designations. 
Inclusion of the information on a company name plate will be permitted 
provided the plate is made of material acceptable to MSHA.