[Code of Federal Regulations]
[Title 30, Volume 1]
[Revised as of July 1, 2002]
From the U.S. Government Printing Office via GPO Access
[CITE: 30CFR28.2]

[Page 147-148]
 
                       TITLE 30--MINERAL RESOURCES
 
  CHAPTER I--MINE SAFETY AND HEALTH ADMINISTRATION, DEPARTMENT OF LABOR
 
PART 28--FUSES FOR USE WITH DIRECT CURRENT IN PROVIDING SHORT-CIRCUIT PROTECTION FOR TRAILING CABLES IN COAL MINES--Table of Contents
 
                      Subpart A--General Provisions
 
Sec. 28.2  Approved fuses.

    (a) On and after the effective date of this part, fuses shall be 
considered to be approved for use with direct current in providing 
short-circuit protection for trailing cables in coal mines only where 
such fuses are: (1) The same in all respects as those fuses which have 
been approved after meeting the minimum requirements for performance and 
short-circuit protection prescribed

[[Page 148]]

in this Part 28; and (2) maintained in an approved condition.