[Code of Federal Regulations]
[Title 30, Volume 1]
[Revised as of July 1, 2002]
From the U.S. Government Printing Office via GPO Access
[CITE: 30CFR28.32]

[Page 151]
 
                       TITLE 30--MINERAL RESOURCES
 
  CHAPTER I--MINE SAFETY AND HEALTH ADMINISTRATION, DEPARTMENT OF LABOR
 
PART 28--FUSES FOR USE WITH DIRECT CURRENT IN PROVIDING SHORT-CIRCUIT PROTECTION FOR TRAILING CABLES IN COAL MINES--Table of Contents
 
                       Subpart D--Quality Control
 
Sec. 28.32  Proposed quality control plans; approval by MSHA.

    (a) Each proposed quality control plan submitted in accordance with 
this subpart shall be reviewed by MSHA to determine its effectiveness in 
insuring the quality of short-circuit protection provided by the fuse 
for which an approval is sought.
    (b) If MSHA determines that the proposed quality control plan 
submitted by the applicant will not insure adequate quality control, 
MSHA shall require the applicant to modify the procedures and testing 
requirements of the plan prior to approval of the plan and issuance of 
any certificate of approval.
    (c) Approved quality control plans shall constitute a part of and be 
incorporated into any certificate of approval issued by MSHA, and 
compliance with such plans by the applicant shall be a condition of 
approval.