[Code of Federal Regulations]
[Title 30, Volume 1]
[Revised as of July 1, 2002]
From the U.S. Government Printing Office via GPO Access
[CITE: 30CFR46.6]

[Page 203-204]
 
                       TITLE 30--MINERAL RESOURCES
 
  CHAPTER I--MINE SAFETY AND HEALTH ADMINISTRATION, DEPARTMENT OF LABOR
 
 PART 46--TRAINING AND RETRAINING OF MINERS ENGAGED IN SHELL DREDGING OR EMPLOYED AT SAND, GRAVEL, SURFACE STONE, SURFACE CLAY, COLLOIDAL PHOSPHATE, OR SURFACE 
LIMESTONE MINES.--Table of Contents
 
Sec. 46.6  Newly hired experienced miner training.

    (a) Except as provided in paragraph (f) of this section, you must 
provide each newly hired experienced miner with training as prescribed 
by paragraphs (b) and (c).

----------------------------------------------------------------------------------------------------------------

----------------------------------------------------------------------------------------------------------------
(b) Before a newly hired experienced miner begins work   You must provide the miner with training in the
 at the mine--                                            following subjects, which must also address site-
                                                          specific hazards:
                                                         (1) An introduction to the work environment, including
                                                          a visit and tour of the mine, or portions of the mine
                                                          that are representative of the entire mine (walkaround
                                                          training). The method of mining or operation utilized
                                                          must be explained and observed;
                                                         (2) Instruction on the recognition and avoidance of
                                                          electrical hazards and other hazards present at the
                                                          mine, such as traffic patterns and control, mobile
                                                          equipment (e.g., haul trucks and front-end loaders),
                                                          and loose or unstable ground conditions;
                                                         (3) A review of the emergency medical procedures,
                                                          escape and emergency evacuation plans, in effect at
                                                          the mine, and instruction on the firewarning signals
                                                          and firefighting procedures;
                                                         (4) Instruction on the health and safety aspects of the
                                                          tasks to be assigned, including the safe work
                                                          procedures of such tasks, and the mandatory health and
                                                          safety standards pertinent to such tasks;
                                                         (5) Instruction on the statutory rights of miners and
                                                          their representatives under the Act;

[[Page 204]]


                                                         (6) A review and description of the line of authority
                                                          of supervisors and miners' representatives and the
                                                          responsibilities of such supervisors and miners'
                                                          representatives; and
                                                         (7) An introduction to your rules and procedures for
                                                          reporting hazards.
----------------------------------------------------------------------------------------------------------------
(c) No later than 60 calendar days after a newly hired   You must provide the miner with an instruction and
 experienced miner begins work at the mine--              demonstration on the use, care, and maintenance of
                                                          self-rescue and respiratory devices, if used at the
                                                          mine.
----------------------------------------------------------------------------------------------------------------

    (d) Practice under the close observation of a competent person may 
be used to fulfill the requirement for training on the health and safety 
aspects of an assigned task in paragraph (b)(4) of this section, if 
hazard recognition training specific to the assigned task is given 
before the miner performs the task.
    (e) In addition to subjects specified in paragraphs (b) and (c) of 
this section, you may provide training on any other subjects that 
promote occupational health and safety for miners.
    (f) You are not required to provide a newly hired experienced miner 
who returns to the same mine, following an absence of 12 months or less, 
with the training specified in paragraphs (b) and (c) of this section. 
Instead you must provide such miner with training on any changes at the 
mine that occurred during the miner's absence that could adversely 
affect the miner's health or safety. This training must be given before 
the miner begins work at the mine. If the miner missed any part of 
annual refresher training under Sec. 46.8 of this part during the 
absence, you must provide the miner with the missed training no later 
than 90 calendar days after the miner begins work at the mine.

    Effective Date Note: At 67 FR 42382, June 21, 2002, Sec. 46.6 was 
amended by revising paragraph (b)(4), effective September 23, 2002. For 
the convenience of the user, the revised text is set forth as follows:

Sec. 46.6  Newly hired experienced miner training.

                                * * * * *

    (b) * * *
    (4) Instruction on the health and safety aspects of the tasks to be 
assigned, including the safe work procedures of such tasks, the 
mandatory health and safety standards pertinent to such tasks, 
information about the physical and health hazards of chemicals in the 
miner's work area, the protective measures a miner can take against 
these hazards, and the contents of the mine's HazCom program;

                                * * * * *