[Code of Federal Regulations]
[Title 32, Volume 4]
[Revised as of July 1, 2002]
From the U.S. Government Printing Office via GPO Access
[CITE: 32CFR650.85]

[Page 317-319]
 
                       TITLE 32--NATIONAL DEFENSE
 
              CHAPTER V--DEPARTMENT OF THE ARMY (CONTINUED)
 
PART 650--ENVIRONMENTAL PROTECTION AND ENHANCEMENT (AR 200-1)--Table of Contents
 
                   Subpart D--Air Pollution Abatement
 
Sec. 650.85  Responsibilities.

    (a) The Chief of Engineers will--(1) Publish the basic policies and 
procedures for the identification, reporting, and programming of 
projects to control and monitor air pollutants emitted by Army fixed 
facilities and mobile sources, including aircraft and watercraft (DAEN-
ZCE).
    (2) Report requirements for projects to control sources of air 
pollution and

[[Page 318]]

the installation of air quality monitoring systems in accordance with 
this regulation and DOD Instruction 4120.14.
    (3) Process requests for exemption from compliance in accordance 
with the provisions of the Clean Air Act and Executive Order 11752.
    (4) Include in the Army R&D Program such research as may be needed 
or required for the development of technology to control Army-unique air 
pollutants.
    (5) Perform technical review and evaluation of remedial projects for 
the control of existing sources of air pollution at fixed facilities and 
insure that provisions are made for air pollution control in the design 
of new structures and facilities.
    (6) Coordinate the requirement of the adoption of new air emission 
standards for the Army fixed facilities with The Surgeon General.
    (7) Provide technical advice and assistance for the control of air 
pollution in the operation and maintenance of fixed facilities.
    (8) Ensure all new construction or major modifications are reviewed 
by the applicable US EPA Regional Office to ensure compliance with the 
State Implementation Plan.
    (b) The Deputy Chief of Staff for Logistics will issue implementing 
policies, procedures and instructions for the control of air pollution 
which pertain to the maintenance, repair and modification of mobile 
sources including vehicles, aircraft and watercraft.
    (c) The Deputy Chief of Staff for Research, Development and 
Acquisition will--(1) Conduct research and development programs designed 
to provide low-pollution, high efficiency engines for Army vehicles, 
mobile power sources, aircraft, and watercraft; and for the development 
of clean burning fuels.
    (2) Incorporate air pollution controls, where required, in the 
development of new equipment and weapons systems to the maximum extent 
possible without degrading the operational capabilities to an 
unacceptable level.
    (3) Insure that mobile equipment and engines developed for the Army 
comply with applicable current and projected Federal emission standards 
to the extent that priority defense and national security requirements 
permit.
    (d) The Surgeon General, will--(1) Monitor the health and welfare 
aspects of the air pollution control program within the Department of 
the Army.
    (2) Issue health and medical policy guidance on air pollution 
control and abatement.
    (3) Consult with COE and appropriate commanders in the establishment 
of air pollution control standards which are unique to the Army.
    (4) Provide staff assistance and guidance on the health and 
environmental aspects of management of hazardous and toxic air 
pollutants.
    (5) Provide support to the basic Army R&D Program in terms of 
identification/designation of R&D needs.
    (6) Review proposed Federal, State, interstate and local emission/
ambient air quality standards and coordinate DA input to the standard-
setting process.
    (e) Major Army commanders will--(1) Develop a program, consistent 
with this regulation and DOD guidelines to control and monitor air 
pollutant emissions from fixed and mobile facilities to comply with 
applicable Federal, State, interstate and local emission standards and 
ambient air quality standards.
    (2) Ensure that personnel having responsibilities for controlling 
air pollution emissions (e.g. equipment operators and mechanics, heating 
plant operators, etc.) are properly trained to perform such duties. 
Further, provide training in the inspection, test and maintenance of 
pollution control devices and emissions measurement equipment.
    (f) Commanding General, US Army Materiel Development and Readiness 
Command. In addition to responsibilities assigned in paragraph (e) of 
this section, the Commanding General, US Army Materiel Development and 
Readiness Command will--(1) Require that Army materiel equipped with 
internal combustion engines meet air emission standards in effect at the 
time of manufacture as required by Federal or State regulations.
    (2) Ensure that the manufacture, shipment, operation, maintenance 
and final disposition of the materiel can be

[[Page 319]]

accomplished with a minimum emission of air pollutants.
    (3) Provide in technical publications appropriate information and 
instructions on air pollution controls for engine driven equipment and 
on maintenance and monitoring procedures for minimizing pollutant 
emissions.
    (g) Commanding General, US Health Services Command will--(1) Assist 
The Surgeon General in fulfilling his responsibilities for the health 
and welfare aspects of the air pollution control programs.
    (2) Provide personnel for conducting field investigations and 
special studies on sources of air pollution and for recommending 
measures required to protect health and welfare, and to comply with 
stationary or mobile emission standards or ambient air quality standards 
(Sec. 650.92).
    (h) Installation and activity commanders will--(1) Monitor air 
emission sources within their installations or under their control and 
identify air emission sources requiring remedial action to ensure 
compliance with emission standards and ambient air quality standards.
    (2) Program remedial projects and funds to control and monitor air 
emission sources and ambient air quality to insure compliance with 
emission standards and ambient air quality standards.
    (3) Cooperate with representatives of Federal, State and regional 
agencies in the formulation and execution of the Installation Master 
Plan, projects, and operations to ensure conformance with the State 
Implementation Plan. This includes conformance with new source emission 
standards; new source review procedures for Federal facilities; air 
pollutant control strategies such as transportation control plans, vapor 
recovery systems, and air pollution emergency episode plans; and the 
requirement to obtain a consent agreement for sources not in compliance 
with applicable air pollutant emission standards.
    (4) Monitor the operation of motor vehicles to permit compliance 
with applicable Federal or State emission standards; or in the absence 
of applicable standards, to minimize smoke emissions.
    (5) Continue mechanic and operator training programs in the 
prevention, control and abatement of pollution from mobile equipment.