[Code of Federal Regulations]
[Title 40, Volume 12]
[Revised as of July 1, 2002]
From the U.S. Government Printing Office via GPO Access
[CITE: 40CFR68.170]

[Page 188]
 
                   TITLE 40--PROTECTION OF ENVIRONMENT
 
               CHAPTER I--ENVIRONMENTAL PROTECTION AGENCY
 
PART 68--CHEMICAL ACCIDENT PREVENTION PROVISIONS--Table of Contents
 
                     Subpart G--Risk Management Plan
 
Sec. 68.170  Prevention program/Program 2.

    (a) For each Program 2 process, the owner or operator shall provide 
in the RMP the information indicated in paragraphs (b) through (k) of 
this section. If the same information applies to more than one covered 
process, the owner or operator may provide the information only once, 
but shall indicate to which processes the information applies.
    (b) The five- or six-digit NAICS code that most closely corresponds 
to the process.
    (c) The name(s) of the chemical(s) covered.
    (d) The date of the most recent review or revision of the safety 
information and a list of Federal or state regulations or industry-
specific design codes and standards used to demonstrate compliance with 
the safety information requirement.
    (e) The date of completion of the most recent hazard review or 
update.
    (1) The expected date of completion of any changes resulting from 
the hazard review;
    (2) Major hazards identified;
    (3) Process controls in use;
    (4) Mitigation systems in use;
    (5) Monitoring and detection systems in use; and
    (6) Changes since the last hazard review.
    (f) The date of the most recent review or revision of operating 
procedures.
    (g) The date of the most recent review or revision of training 
programs;
    (1) The type of training provided--classroom, classroom plus on the 
job, on the job; and
    (2) The type of competency testing used.
    (h) The date of the most recent review or revision of maintenance 
procedures and the date of the most recent equipment inspection or test 
and the equipment inspected or tested.
    (i) The date of the most recent compliance audit and the expected 
date of completion of any changes resulting from the compliance audit.
    (j) The date of the most recent incident investigation and the 
expected date of completion of any changes resulting from the 
investigation.
    (k) The date of the most recent change that triggered a review or 
revision of safety information, the hazard review, operating or 
maintenance procedures, or training.

[61 FR 31726, June 20, 1996, as amended at 64 FR 980, Jan. 6, 1999]