[Code of Federal Regulations]
[Title 47, Volume 1]
[Revised as of October 1, 2002]
From the U.S. Government Printing Office via GPO Access
[CITE: 47CFR15.203]

[Page 727-728]
 
                       TITLE 47--TELECOMMUNICATION
 
              CHAPTER I--FEDERAL COMMUNICATIONS COMMISSION
 
PART 15--RADIO FREQUENCY DEVICES--Table of Contents
 
                    Subpart C--Intentional Radiators
 
Sec.  15.203  Antenna requirement.

    An intentional radiator shall be designed to ensure that no antenna 
other than that furnished by the responsible party shall be used with 
the device. The use of a permanently attached antenna or of an antenna 
that uses a unique coupling to the intentional radiator shall be 
considered sufficient to comply with the provisions of this section. The 
manufacturer may design the unit so that a broken antenna can be 
replaced by the user, but the use of a standard antenna jack or 
electrical connector is prohibited. This requirement does not apply to 
carrier current devices or to devices operated under the provisions of 
Sec.  15.211, Sec.  15.213, Sec.  15.217, Sec.  15.219, or Sec.  15.221. 
Further, this requirement does not apply to intentional radiators that 
must be professionally installed, such as perimeter protection systems 
and some field disturbance sensors, or to other intentional radiators 
which, in accordance

[[Page 728]]

with Sec.  15.31(d), must be measured at the installation site. However, 
the installer shall be responsible for ensuring that the proper antenna 
is employed so that the limits in this part are not exceeded.

[54 FR 17714, Apr. 25, 1989, as amended at 55 FR 28762, July 13, 1990]