[Code of Federal Regulations] [Title 47, Volume 1] [Revised as of October 1, 2002] From the U.S. Government Printing Office via GPO Access [CITE: 47CFR15.37] [Page 691-693] TITLE 47--TELECOMMUNICATION CHAPTER I--FEDERAL COMMUNICATIONS COMMISSION PART 15--RADIO FREQUENCY DEVICES--Table of Contents Subpart A--General Sec. 15.37 Transition provisions for compliance with the rules. Equipment may be authorized, manufactured and imported under the rules in effect prior to June 23, 1989, in accordance with the following schedules: (a) For all intentional and unintentional radiators, except for receivers: [[Page 692]] Radio frequency equipment verified by the responsible party or for which an application for a grant of equipment authorization is submitted to the Commission on or after June 23, 1992, shall comply with the regulations specified in this part. Radio frequency equipment that is manufactured or imported on or after June 23, 1994, shall comply with the regulations specified in this part. (b) For receivers: Receivers subject to the regulations in this part that are manufactured or imported on or after June 23, 1999, shall comply with the regulations specified in this part. However, if a receiver is associated with a transmitter that could not have been authorized under the regulations in effect prior to June 23, 1989, e.g., a transmitter operating under the provisions of Sec. 15.209 or Sec. 15.249 (below 960 MHz), the transition provisions in this section do not apply. Such receivers must comply with the regulations in this part. In addition, receivers are subject to the provisions in paragraph (f) of this section. (c) There are no restrictions on the operation or marketing of equipment complying with the regulations in effect prior to June 23, 1989. (d) Prior to May 25, 1991, person shall import, market or operate intentional radiators within the band 902-905 MHz under the provisions of Sec. 15.249. Until that date, the Commission will not issue a grant of equipment authorization for equipment operating under Sec. 15.249 if the equipment is designed to permit operation within the band 902-905 MHz. (e) For cordless telephones: The manufacture and importation of cordless telephones not complying with Sec. 15.214(d) of this part shall cease on or before September 11, 1991. These provisions will not apply to cordless telephones which are repaired or refurbished, or re- imported after repair or refurbishment. Applications for a grant of equipment authorization of cordless telephones not complying with Sec. 15.214(d) of this part will not be accepted by the Commission after May 10, 1991. Cordless telephones that have previously received equipment authorization and that, without modification, already comply with the requirements of Sec. 15.214(d) of this part, need not be reauthorized. (f) The manufacture or importation of scanning receivers, and frequency converters designed or marketed for use with scanning receivers, that do not comply with the provisions of Sec. 15.121(a)(1) shall cease on or before April 26, 1994. Effective April 26, 1993, the Commission will not grant equipment authorization for receivers that do not comply with the provisions of Sec. 15.121(a)(1). These rules do not prohibit the sale or use of authorized receivers manufactured in the United States, or imported into the United States, prior to April 26, 1994. (g) For CPU boards and power supplies designed to be used with personal computers: The manufacture and importation of these products shall cease on or before June 19, 1997 unless these products have been authorized under a Declaration of Conformity or a grant of certification, demonstrating compliance with all of the provisions in this part. Limited provisions, as detailed in Sec. 15.101(d), are provided to permit the importation and manufacture of these products subsequent to this date where the CPU boards and/or power supplies are marketed only to personal computer equipment manufacturers. (h) The manufacture or importation of scanning receivers, and frequency converters designed or marketed for use with scanning receivers, that do not comply with the provisions of Sec. 15.121 shall cease on or before October 25, 1999. Effective July 26, 1999 the Commission will not grant equipment authorization for receivers that do not comply with the provisions of Sec. 15.121. This paragraph does not prohibit the sale or use of authorized receivers manufactured in the United States, or imported into the United States, prior to October 25, 1999. (i) Effective October 16, 2002, an equipment approval may no longer be obtained for medical telemetry equipment operating under the provisions of Sec. 15.241 or Sec. 15.242. The requirements for obtaining an approval for medical telemetry equipment after this date are found in Subpart H of Part 95 of this chapter. (j) All radio frequency devices that are authorized under the certification, [[Page 693]] verification or declaration of conformity procedures on or after July 12, 2004 shall comply with the conducted limits specified in Sec. 15.107 or Sec. 15.207 as appropriate. All radio frequency devices that are manufactured or imported on or after July 11, 2005 shall comply with the conducted limits specified in Sec. 15.107 or Sec. 15.207, as appropriate. Equipment authorized, imported or manufactured prior to these dates shall comply with the conducted limits specified in Sec. 15.107 or Sec. 15.207, as appropriate, or with the conducted limits that were in effect immediately prior to September 9, 2002. (k) Radar detectors manufactured or imported after August 28, 2002 and marketed after September 27, 2002 shall comply with the regulations specified in this part. Radar detectors manufactured or imported prior to January 27, 2003 may be labeled with the information required by Sec. Sec. 2.925 and 15.19(a) of this chapter on the individual equipment carton rather than on the device, and are exempt from complying with the requirements of Sec. 15.21. [54 FR 17714, Apr. 25, 1989; 54 FR 32339, Aug. 7, 1989; 55 FR 25095, June 20, 1990; 56 FR 3785, Jan. 31, 1991; 58 FR 25575, Apr. 27, 1993; 61 FR 31049, June 19, 1996; 64 FR 22561, Apr. 27, 1999; 65 FR 44008, July 17, 2000; 67 FR 45670, July 10, 2002; 67 FR 48993, July 29, 2002]