[Code of Federal Regulations]
[Title 50, Volume 4]
[Revised as of October 1, 2002]
From the U.S. Government Printing Office via GPO Access
[CITE: 50CFR648.84]

[Page 396-397]
 
                    TITLE 50--WILDLIFE AND FISHERIES
 
                         DEPARTMENT OF COMMERCE
 
PART 648--FISHERIES OF THE NORTHEASTERN UNITED STATES--Table of Contents
 
  Subpart F--Management Measures for the NE Multispecies and Monkfish 
                                Fisheries
 
Sec. 648.84  Gear-marking requirements and gear restrictions.

    (a) Bottom-tending fixed gear, including, but not limited to, 
gillnets and longlines designed for, capable of, or fishing for NE 
multispecies or monkfish, must have the name of the owner or vessel or 
the official number of that vessel permanently affixed to

[[Page 397]]

any buoys, gillnets, longlines, or other appropriate gear so that the 
name of the owner or vessel or the official number of the vessel is 
visible on the surface of the water.
    (b) Bottom-tending fixed gear, including, but not limited to 
gillnets or longline gear, must be marked so that the westernmost end 
(measuring the half compass circle from magnetic south through west to, 
and including, north) of the gear displays a standard 12-inch (30.5-cm) 
tetrahedral corner radar reflector and a pennant positioned on a staff 
at least 6 ft (1.8 m) above the buoy. The easternmost end (meaning the 
half compass circle from magnetic north through east to, and including, 
south) of the gear need display only the standard 12-inch (30.5-cm) 
tetrahedral radar reflector positioned in the same way.
    (c) Continuous gillnets must not exceed 6,600 ft (2,011.7 m) between 
the end buoys.
    (d) In the GOM/GB regulated mesh area specified in Sec. 648.80(a), 
gillnet gear set in an irregular pattern or in any way that deviates 
more than 30 deg. from the original course of the set must be marked at 
the extremity of the deviation with an additional marker, which must 
display two or more visible streamers and may either be attached to or 
independent of the gear.

[61 FR 34968, July 3, 1996, as amended at 64 FR 54747, Oct. 7, 1999]