[Code of Federal Regulations] [Title 16, Volume 2] [Revised as of January 1, 2003] From the U.S. Government Printing Office via GPO Access [CITE: 16CFR1115.13] [Page 166-168] TITLE 16--COMMERCIAL PRACTICES CHAPTER II--CONSUMER PRODUCT SAFETY COMMISSION PART 1115--SUBSTANTIAL PRODUCT HAZARD REPORTS--Table of Contents Subpart A--General Interpretation Sec. 1115.13 Content and form of reports; delegations of authority. (a) Written reports. The chief executive officer of the subject firm should sign any written reports to the Commission under section 15(b) of the CPSA unless this responsibility has been delegated by filing a written delegation of authority with the Commission's Office of Compliance and Enforcement, Division of Corrective Actions. Delegations of authority filed with the Commission under Sec. 1115.9 of the previous regulations interpreting section 15 of the CPSA will remain in effect until revoked by the chief executive officer of the subject firm. The delegation may be in the following form: Delegation of Authority (Name of company) ------------------. I ---------------- hereby certify that I am Chief Executive Officer of the above-named company and that as such I am authorized to sign documents and to certify on behalf of said company the accuracy and completeness of information in such documents. Pursuant to the power vested in me, I hereby delegate all or, to the extent indicated below, a portion of that authority to the person listed below. This delegation is effective until revoked in writing. Authority delegated to: (Name)__________________________________________________________________ (Address)_______________________________________________________________ (Title)_________________________________________________________________ Extent of authority: ---------------------- Signed: (Name)__________________________________________________________________ (Address)_______________________________________________________________ (Title)_________________________________________________________________ (b) Distributors and retailers. A distributor or retailer of a product (who is neither a manufacturer nor an importer of that product) satisfies the initial reporting requirements either by telephoning or writing the Office of Compliance and Enforcement, Division of Corrective Actions, Consumer Product Safety Commission, Washington, DC 20207, phone 301-504-0608; by sending a letter describing the noncompliance, defect or risk of injury to the manufacturer (or importer) of the product and sending a copy of the letter to the Commission's Division of Corrective Actions; or by forwarding to the Commission's Division of Corrective Actions reportable information received from another firm. A distributor or retailer who receives reportable information from a manufacturer (or importer) shall report to the Commission unless the manufacturer (or importer) informs the distributor or retailer that a report has been made to the Commission. A report under this paragraph should contain the information detailed in paragraph (c) of this section insofar as it is known to the distributor or retailer. Unless further information is requested by the staff, this action will constitute a sufficient report insofar as the distributor or retailer is concerned. [[Page 167]] (c) Initial report. Immediately after a subject firm has obtained information which reasonably supports the conclusion that a product fails to comply with an applicable consumer product safety rule or a voluntary standard, contains a defecat which could create a substantial risk of serious injury or death, the subject firm should provide the Division of Corrective Actions, Office of Compliance, Consumer Product Safety Commission, Washington, DC 20207 (telephone: 301-504-0608), with an initial report containing the information listed in paragraphs (c) (1) through (6) of this section. This initial report may be made by any means, but if it is not in writing, it should be confirmed in writing within 48 hours of the initial report. (See Sec. 1115.14 for time computations.) The initial report should contain, insofar as is reasonably available and/or applicable: (1) An identification and description of the product. (2) The name and address of the manufacturer (or importer) or, if the manufacturer or importer is not known, the names and addresses of all known distributors and retailers of the product. (3) The nature and extent of the possible defect, the failure to comply, or the risk. (4) The nature and extent of the injury or risk of injury associated with the product. (5) The name and address of the person informing the Commission. (6) To the extent such information is then reasonably available, the data specified in Sec. 1115.13(d). (d) Full report. Subject firms which file initial reports are required to file full reports in accordance with this paragraph. Retailers and distributors may satisfy their reporting obligations in accordance with Sec. 1115.13(b). At any time after an initial report, the staff may modify the requirements detailed in this section with respect to any subject firm. If the staff preliminarily determines that there is no substantial product hazard, it may inform the firm that its reporting obligation has been fulfilled. However, a subject firm would be required to report if it later became aware of new information indicating a reportable defect, noncompliance, or risk, whether the new information related to the same or another consumer product. Unless modified by staff action, the following information, to the extent that it is reasonably available and/or applicable, constitutes a ``full report,'' must be submitted to the staff, and must be supplemented or corrected as new or different information becomes known: (1) The name, address, and title of the person submitting the ``full report'' to the Commission. (2) The name and address of the manufacturer (or importer) of the product and the addresses of the manufacturing plants for that product. (3) An identification and description of the product(s). Give retail prices, model numbers, serial numbers, and date codes. Describe any identifying marks and their location on the product. Provide a picture or a sample of the product. (4) A description of the nature of the defect, failure to comply, or risk. If technical drawings, test results, schematics, diagrams, blueprints, or other graphic depictions are available, attach copies. (5) The nature of the injury or the possible injury associated with the product defect, failure to comply, or risk. (6) The manner in which and the date when the information about the defect, noncompliance, or risk (e.g., complaints, reported injuries, quality control testing) was obtained. If any complaints related to the safety of the product or any allegations or reports of injuries associated with the product have been received, copies of such complaints or reports (or a summary thereof) shall be attached. Give a chronological account of facts or events leading to the report under section 15(b) of the CPSA, beginning with receipt of the first information which ultimately led to the report. Also included may be an analysis of these facts or events. (7) The total number of products and units involved. (8) The dates when products and units were manufactured, imported, distributed, and sold at retail. (9) The number of products and units in each of the following: in the possession of the manufacturer or importer, in the possession of private labelers, in [[Page 168]] the possession of distributors, in the possession of retailers, and in the possession of consumers. (10) An explanation of any changes (e.g., designs, adjustments, and additional parts, quality control, testing) that have been or will be effected to correct the defect, failure to comply, or risk and of the steps that have been or will be taken to prevent similar occurrences in the future together with the timetable for implementing such changes and steps. (11) Information that has been or will be given to purchasers, including consumers, about the defect, noncompliance, or risk with a description of how this information has been or will be communicated. This shall include copies or drafts of any letters, press releases, warning labels, or other written information that has been or will be given to purchasers, including consumers. (12) The details of and schedule for any contemplated refund, replacement, or repair actions, including plans for disposing of returned products (e.g., repair, destroy, return to foreign manufacturer). (13) A detailed explanation and description of the marketing and distribution of the product from the manufacturer (including importer) to the consumer (e.g., use of sales representatives, independent contractors, and/or jobbers; installation of the product, if any, and by whom). (14) Upon request, the names and addresses of all distributors, retailers, and purchasers, including consumers. (15) Such further information necessary or appropriate to the functions of the Commission as is requested by the staff. [43 FR 34998, Aug. 7, 1978, as amended at 57 FR 34229, Aug. 4, 1992]