[Code of Federal Regulations]
[Title 33, Volume 2]
[Revised as of July 1, 2003]
From the U.S. Government Printing Office via GPO Access
[CITE: 33CFR157.24]

[Page 468]
 
                TITLE 33--NAVIGATION AND NAVIGABLE WATERS
 
   CHAPTER I--COAST GUARD, DEPARTMENT OF HOMELAND SECURITY (CONTINUED)
 
PART 157--RULES FOR THE PROTECTION OF THE MARINE ENVIRONMENT RELATING TO 
TANK VESSELS CARRYING OIL IN BULK--Table of Contents
 
             Subpart B--Design, Equipment, and Installation
 
Sec. 157.24  Submission of calculations, plans, and specifications.

    The owner, builder or designer of a new vessel to which this part 
applies shall submit the documentation specified in this section to the 
Coast Guard before that vessel enters the navigable waters of the United 
States. The owner, builder, or designer of a vessel that must comply 
with Sec. 157.10d shall submit the documentation specified in this 
section to the Coast Guard before that vessel enters the navigable 
waters of the United States or the U.S. Exclusive Economic Zone.
    (a) Calculations to substantiate compliance with the tank 
arrangement and size requirements under Sec. 157.19, or a letter from 
the government of the vessel's flag state that certifies compliance 
with:
    (1) Section 157.19; or
    (2) Regulations 24 of Annex I of the International Convention for 
the Prevention of Pollution from Ships, 1973.
    (b) Except for a new vessel that is a foreign vessel, calculations 
to substantiate compliance with subdivisions and damage stability 
requirements under Sec. 157.21.
    (c) Plans and calculations to substantiate compliance with the 
applicable segregated ballast and double hull requirements in Sec.Sec. 
157.09, 157.10, 157.10a, 157.10b, or 157.10d, or certification from the 
government of the vessel's flag state that the vessel complies with the 
segregated ballast and double hull requirements in:
    (1) Sections 157.09, 157.10, 157.10a, 157.10b, or 157.10d, as 
applicable; or
    (2) For a vessel to which Sec. 157.10d does not apply, Regulations 
13 and 13E of the MARPOL 73/78.
    (d) Plans and specifications for the vessel that include:
    (1) Design characteristics;
    (2) A lines plan;
    (3) Curves of form (hydrostatic curves) or hydrostatic tables;
    (4) A general arrangement plan of each deck and level;
    (5) Inboard and outboard profile plans showing oiltight and 
watertight bulkheads;
    (6) A midship section plan;
    (7) A capacity plan showing the capacity and the vertical and 
longitudinal centers of gravity of each cargo space, tank, and similar 
space;
    (8) Tank sounding tables or tank capacity tables;
    (9) Draft mark locations;
    (10) Detailed plans of watertight doors; and
    (11) Detailed plans of vents.

[CGD 75-240, 41 FR 54180, Dec. 13, 1976, as amended by CGD 77-058b, 45 
FR 43708, June 30, 1980; CGD 79-152, 45 FR 82250, Dec. 15, 1980; CGD 90-
051, 57 FR 36244, Aug. 12, 1992; USCG-2000-7641, 66 FR 55573, Nov. 2, 
2001]