[Code of Federal Regulations]
[Title 33, Volume 2]
[Revised as of July 1, 2003]
From the U.S. Government Printing Office via GPO Access
[CITE: 33CFR162.165]

[Page 574-576]
 
                TITLE 33--NAVIGATION AND NAVIGABLE WATERS
 
   CHAPTER I--COAST GUARD, DEPARTMENT OF HOMELAND SECURITY (CONTINUED)
 
PART 162--INLAND WATERWAYS NAVIGATION REGULATIONS--Table of Contents

Sec. 162.65  All waterways tributary to the Atlantic Ocean south of 
Chesapeake Bay and all waterways tributary to the Gulf of Mexico east and 
south of St. 
          Marks, Fla.

    (a) Description. This section applies to the following:
    (1) Waterways. All navigable waters of the United States, natural or 
artificial, including bays, lakes, sounds, rivers, creeks, intracoastal 
waterways, as well as canals and channels of all types, which are 
tributary to or connected by other waterways with the Atlantic Ocean 
south of Chesapeake Bay or with the Gulf of Mexico east and south of St. 
Marks, Florida.
    (2) United States property. All river and harbor lands owned by the 
United States in or along the waterways described in paragraph (a)(1) of 
this paragraph, including lock sites and all structures thereon, other 
sites for Government structures and for the accommodation and use of 
employees of the United States, and rights of way and spoil disposal 
areas to the extent of Federal interest therein.
    (3) Vessels and rafts. The term ``vessel'' as used in this section 
includes all floating things moved over these waterways other than 
rafts.
    (b) Waterways--(1) Fairway. A clear channel shall at all times be 
left open to permit free and unobstructed navigation by all types of 
vessels and rafts that normally use the various waterways or sections 
thereof. The District Commander may specify the width of the fairway 
required in the various waterways under his charge.
    (2) Stoppage in waterway, anchorage or mooring. (i) No vessels or 
rafts shall anchor or moor in any of the land cuts or other narrow parts 
of the waterway, except in case of an emergency. Whenever it becomes 
necessary for a vessel or raft to stop in any such portions of the 
waterway it shall be securely fastened to one bank and as close to the 
bank as possible. This shall be done only at such a place and under such 
conditions as will not obstruct or prevent the passage of other vessels 
or craft. Stoppages shall be only for such periods as may be necessary.

[[Page 575]]

    (ii) No vessel or raft will be allowed to use any portion of the 
fairway as a mooring place except temporarily as authorized above 
without the written permission from the District Commander.
    (iii) When tied up, all vessels must be moored by bow and stern 
lines. Rafts and tows shall be secured at sufficiently close intervals 
to insure their not being drawn away from the bank by winds, currents or 
the suction of passing vessels. Tow lines shall be shortened so that the 
different parts of the tow shall be as close together as possible. In 
narrow sections, no vessel or raft shall be tied abreast of another.
    (iv) Lights shall be displayed in accordance with provisions of the 
Navigation Rules, International-Inland, Commandant Instruction M16672.2 
(series).
    (v) No vessel, even if fastened to the bank as prescribed in 
paragraph (b)(2)(i) of this section, shall be left without a sufficient 
crew to care for it properly.
    (vi) Vessels will not be permitted to load or unload in any of the 
land cuts except as a regular established landing or wharf without 
written permission secured in advance from the District Commander.
    (vii) No vessel, regardless of size, shall anchor in a dredged 
channel or narrow portion of a waterway for the purpose of fishing, if 
navigation is obstructed, thereby.
    (viii) Except in cases of emergency the dropping of anchors, 
weights, or other ground tackle, within areas occupied by submarine 
cable or pipe crossings, is prohibited. Such crossings will ordinarily 
be marked by signboards on each bank of the shore or indicated on coast 
charts.
    (3) Speed. (i) Vessels shall proceed at a speed which will not 
endanger other vessels or structures and will not interfere with any 
work in progress incident to maintaining, improving, surveying or 
marking the channel.
    (ii) Official signs indicating limiting speeds through critical 
portions of the waterways shall be strictly obeyed.
    (iii) Vessels approaching and passing through a bridge shall so 
govern their speed as to insure passage through the bridge without 
damage to the bridge or its fenders.
    (4) Assembly and handling of tows. (i) All vessels drawing tows and 
equipped with rudders shall use two tow lines or a bridle and shorten 
them to the greatest possible extent so as to have full control at all 
times. The various parts of a tow shall be securely assembled with the 
individual units connected by lines as short as practicable. If 
necessary, as in the case of lengthy or cumbersome tows or tows in 
restricted channels, the District Commander may require that tows be 
broken up and may require the installation of a rudder, drag or other 
approved steering device on the tow in order to avoid obstructing 
navigation or damaging the property of others, including aids to 
navigation maintained by the United States or under its authorization, 
by collision or otherwise.
    (ii) No tow shall be drawn by a vessel that has insufficient power 
or crew to permit ready maneuverability and safe handling.
    (iii) Tows desiring to pass a bridge shall approach the opening 
along the axis of the channel so as to pass through without danger of 
striking the bridge or its fenders. No vessel or tow shall navigate 
through a drawbridge until the movable span is fully opened.
    (iv) In the event that it is evident to the master of a towing 
vessel that a tow cannot be safely handled through a bridge, it will be 
brought to anchor and the towed vessels will be taken through the bridge 
in small units, or singly if necessary, or the tow will wait until 
navigation conditions have improved to such an extent that the tow can 
pass through the bridge without damage.
    (5) Projections from vessels. No vessel carrying a deck load which 
overhangs or projects over the side of said vessel, or whose rigging 
projects over the side of the vessel so as to endanger passing vessels, 
wharves or other property, will enter or pass through any of the narrow 
parts of the waterway.
    (6) Meeting and passing. Vessels, on meeting or overtaking, shall 
give the proper signals and pass in accordance with the Navigation 
Rules, International-Inland, Commandant Instruction M16672.2 (series). 
Rafts shall give to vessels the side demanded by proper signal. All 
vessels approaching dredges

[[Page 576]]

or other plant engaged on improvements to a waterway, shall give the 
signal for passing and slow down sufficiently to stop if so ordered or 
if no answering signal is received. On receiving the answering signal, 
they shall then proceed to pass at a speed sufficiently slow to insure 
safe navigation.
    Note: The Corps of Engineers also has regulations dealing with this 
section in 33 CFR Part 207.

[CGD 75-082, 42 FR 51759, Sept. 29, 1977, as amended by CGD 93-072, 59 
FR 39963, Aug. 5, 1994; USCG-2000-7223, 65 FR 40058, June 29, 2000]