[Code of Federal Regulations] [Title 40, Volume 26] [Revised as of July 1, 2003] From the U.S. Government Printing Office via GPO Access [CITE: 40CFR419.36] [Page 373-374] TITLE 40-PROTECTION OF ENVIRONMENT CHAPTER I-ENVIRONMENTAL PROTECTION AGENCY (CONTINUED) PART 419-PETROLEUM REFINING POINT SOURCE CATEGORY--Table of Contents Subpart C-Petrochemical Subcategory Sec. 419.36 Standards of performance for new sources (NSPS). (a) Any new source subject to this subpart must achieve the following new source performance standards (NSPS): ------------------------------------------------------------------------ NSPS Effluent Limitations --------------------------- Average of daily values Pollutant or pollutant property Maximum for for 30 any 1 day consecutive days shall not exceed ------------------------------------------------------------------------ Metric units (kilograms per 1,000 m\3\ of feedstock) --------------- BOD5........................................ 21.8 11.6 TSS......................................... 14.9 9.5 COD\1\...................................... 133.0 69.0 Oil and grease.............................. 6.6 3.5 Phenolic compounds.......................... 0.158 .077 Ammonia as N................................ 23.4 10.7 Sulfide..................................... 0.140 0.063 Total chromium.............................. 0.32 0.19 Hexavalent chromium......................... 0.025 0.012 pH.......................................... (\2\) (\2\) --------------- English units (pounds per 1,000 bbl of feedstock) --------------- BOD5........................................ 7.7 4.1 TSS......................................... 5.2 3.3 COD\1\...................................... 47.0 24.0 Oil and grease.............................. 2.4 1.3 Phenolic compounds.......................... 0.056 0.027 Ammonia as N................................ 8.3 3.8 Sulfide..................................... 0.050 0.022 Total chromium.............................. 0.116 0.068 Hexavalent chromium......................... 0.0096 0.0044 pH.......................................... (\2\) (\2\) ------------------------------------------------------------------------ \1\ See footnote following table in Sec. 419.13(d). \2\ Within the range of 6.0 to 9.0. (b) The limits set forth in paragraph (a) of this section are to be multiplied by the following factors to calculate the maximum for any one day and maximum average of daily values for thirty consecutive days. (1) Size factor. ------------------------------------------------------------------------ 1,000 bbl of feedstock per stream day Size factor ------------------------------------------------------------------------ Less than 24.9............................................. 0.73 25.0 to 49.9............................................... 0.76 50.0 to 74.9............................................... 0.83 75.0 to 99.9............................................... 0.91 100.0 to 124.9............................................. 0.99 125.0 to 149.9............................................. 1.08 150.0 or greater........................................... 1.13 ------------------------------------------------------------------------ (2) Process factor. ------------------------------------------------------------------------ Process Process configuration factor ------------------------------------------------------------------------ Less than 4.49............................................. 0.73 4.5 to 5.49................................................ 0.80 5.5 to 5.99................................................ 0.91 6.0 to 6.49................................................ 0.99 6.5 to 6.99................................................ 1.08 7.0 to 7.49................................................ 1.17 7.5 to 7.99................................................ 1.28 8.0 to 8.49................................................ 1.39 8.5 to 8.99................................................ 1.51 9.0 to 9.49................................................ 1.65 9.5 or greater............................................. 1.72 ------------------------------------------------------------------------ [[Page 374]] (3) See the comprehensive example in subpart D, Sec. 419.42(b)(3). (c) The provisions of Sec. 419.16(c) apply to discharges of process wastewater pollutants attributable to ballast water by a point source subject to the provisions of this subpart. (d) The quantity and quality of pollutants or pollutant properties controlled by this paragraph, attributable to once-through cooling water, are excluded from the discharge allowed by paragraph (b) of this section. Once-through cooling water may be discharged with a total organic carbon concentration not to exceed 5 mg/l. (e) Effluent Limitations for Runoff. [Reserved] [47 FR 46446, Oct. 18, 1982, as amended at 50 FR 28523, July 12, 1985; 50 FR 32414, Aug. 12, 1985]