[Code of Federal Regulations]
[Title 40, Volume 26]
[Revised as of July 1, 2003]
From the U.S. Government Printing Office via GPO Access
[CITE: 40CFR419.56]

[Page 386-387]
 
                TITLE 40-PROTECTION OF ENVIRONMENT
 
      CHAPTER I-ENVIRONMENTAL PROTECTION AGENCY (CONTINUED)
 
PART 419-PETROLEUM REFINING POINT SOURCE CATEGORY--Table of Contents
 
                 Subpart E-Integrated Subcategory
 
Sec. 419.56  Standards of performance for new sources (NSPS).

    (a) Any new source subject to this subpart must achieve the 
following new source performance standards (NSPS):

------------------------------------------------------------------------
                                                      NSPS effluent
                                                        limitation
                                                ------------------------
                                                              Average of
                                                                daily
        Pollutant or pollutant property            Maximum    values for
                                                  for any 1       30
                                                     day     consecutive
                                                              days shall
                                                              not exceed
------------------------------------------------------------------------
                                                 Metric units (kilograms
                                                    per 1,000 m \3\ of
                                                        feedstock)

                                                -------------
BOD5...........................................    41.6         22.1
TSS............................................    28.1         17.9
COD \1\........................................   295.0        152.0
Oil and grease.................................    12.6          6.7
Phenolic compounds.............................     0.30         0.14
Ammonia as N...................................    23.4         10.7
Sulfide........................................     0.26         0.12
Total chromium.................................     0.64         0.37
Hexavalent chromium............................     0.052        0.024
pH.............................................  (\2\)       (\2\)

                                                -------------
                                                  English units (pounds
                                                     per 1,000 bbl of
                                                        feedstock)

                                                -------------
BOD5...........................................    14.7          7.8
TSS............................................     9.9          6.3
COD \1\........................................   104.0         54.0
Oil and grease.................................     4.5          2.4
Phenolic compounds.............................     0.105        0.051
Ammonia as N...................................     8.3          3.8
Sulfide........................................     0.093        0.042
Total chromium.................................     0.220        0.13
Hexavalent chromium............................     0.019        0.0084

[[Page 387]]


pH.............................................  (\2\)       (\2\)
------------------------------------------------------------------------
\1\ See footnote following table in Sec. 419.13(d).
\2\ Within the range 6.0 to 9.0.

    (b) The limits set forth in paragraph (a) of this section are to be 
multiplied by the following factors to calculate the maximum for any one 
day and maximum average of daily values for thirty consecutive days.
    (1) Size factor.

------------------------------------------------------------------------
                                                                  Size
            1,000 bbl of feedstock per stream day                factor
------------------------------------------------------------------------
Less than 124.9..............................................       0.73
125.0 to 149.9...............................................       0.76
150.0 to 174.9...............................................       0.83
175.0 to 199.9...............................................       0.91
200 to 224.9.................................................       0.99
225 or greater...............................................       1.04
------------------------------------------------------------------------

    (2) Process factor.

------------------------------------------------------------------------
                                                                Process
                    Process configuration                        factor
------------------------------------------------------------------------
Less than 6.49...............................................       0.75
6.5 to 7.49..................................................       0.82
7.5 to 7.99..................................................       0.92
8.0 to 8.49..................................................       1.00
8.5 to 8.99..................................................       1.10
9.0 to 9.49..................................................       1.20
9.5 to 9.99..................................................       1.30
10.0 to 10.49................................................       1.42
10.5 to 10.99................................................       1.54
11.0 to 11.49................................................       1.68
11.5 to 11.99................................................       1.83
12.0 to 12.49................................................       1.99
12.5 to 12.99................................................       2.17
13.0 or greater..............................................       2.26
------------------------------------------------------------------------

    (3) See the comprehensive example in subpart D, Sec. 
419.42(b)(3).
    (c) The provisions of Sec. 419.16(c) apply to discharges 
of process wastewater pollutants attributable to ballast water by a 
point source subject to the provision of this subpart.
    (d) The quantity and quality of pollutants or pollutant properties 
controlled by this paragraph, attributable to once-through cooling 
water, are excluded from the discharge allowed by paragraph (b) of this 
section. Once-through cooling water may be discharged with a total 
organic carbon concentration not to exceed 5 mg/l.
    (e) Effluent Limitations for Runoff. [Reserved]

[47 FR 46446, Oct. 18, 1982, as amended at 50 FR 28523, 28528, July 12, 
1985; 50 FR 32414, Aug. 12, 1985]