[Code of Federal Regulations] [Title 40, Volume 27] [Revised as ofJuly 1, 2003] From the U.S. Government Printing Office via GPO Access [CITE: 40CFR428.43] [Page 67] TITLE 40--PROTECTION OF ENVIRONMENT CHAPTER I--ENVIRONMENTAL PROTECTION AGENCY (CONTINUED) PART 428--RUBBER MANUFACTURING POINT SOURCE CATEGORY--Table of Contents Subpart D--Latex Rubber Subcategory Sec. 428.43 Effluent limitations guidelines representing the degree of effluent reduction attainable by the application of the best available technology economically achievable. The following limitations establish the quantity or quality of pollutants or pollutant properties, controlled by this section, which may be discharged by a point source subject to the provisions of this subpart after application of the best available technology economically achievable: ------------------------------------------------------------------------ Effluent limitations ----------------------------- Average of daily Effluent characteristic Maximum values for 30 for any 1 consecutive days day shall not exceed- - ------------------------------------------------------------------------ Metric units (kg/kkg of product) ------------- COD....................................... 2.66 1.78 BOD5...................................... 0.11 .07 TSS....................................... 0.21 .14 Oil and grease............................ 0.11 .07 pH........................................ (\1\) (\1\) ------------- English units (lb/1,000 lb of product) ------------- COD....................................... 2.66 1.78 BOD5...................................... 0.11 .07 TSS....................................... 0.21 .14 Oil and grease............................ 0.11 .07 pH........................................ (\1\) (\1\) ------------------------------------------------------------------------ \1\ Within the range 6.0 to 9.0.