[Code of Federal Regulations] [Title 40, Volume 27] [Revised as ofJuly 1, 2003] From the U.S. Government Printing Office via GPO Access [CITE: 40CFR428.52] [Page 68-69] TITLE 40--PROTECTION OF ENVIRONMENT CHAPTER I--ENVIRONMENTAL PROTECTION AGENCY (CONTINUED) PART 428--RUBBER MANUFACTURING POINT SOURCE CATEGORY--Table of Contents Subpart E--Small-Sized General Molded, Extruded, and Fabricated Rubber Plants Subcategory Sec. 428.52 Effluent limitations guidelines representing the degree of effluent reduction attainable by the application of the best practicable control technology currently available. Except as provided in Secs. 125.30 through 125.32, any existing point source subject to this subpart shall achieve the following effluent limitations representing the degree of effluent reduction attainable by the application of the best practicable control technology currently available (BPT): (a) The following limitations establish the quantity or quality of pollutants or pollutant properties, controlled by this section, which may be discharged by a point source subject to the provisions of this subpart after application of the best practicable control technology currently available: ------------------------------------------------------------------------ Effluent limitations ----------------------------- Average of daily Effluent characteristic Maximum values for 30 for any 1 consecutive days day shall not exceed- - ------------------------------------------------------------------------ Metric units (kg/kkg of raw material) ------------- Oil and grease............................ 0.70 0.25 TSS....................................... 1.28 0.64 pH........................................ (\1\) (\1\) ------------- English units (lb/1,000 lb of raw material) ------------- Oil and grease............................ 0.70 0.25 TSS....................................... 1.28 0.65 pH........................................ (\1\) (\1\) ------------------------------------------------------------------------ \1\ Within the range 6.0 to 9.0. (b) The following limitations establish the quantity or quality of pollutants or pollutant properties, controlled by this section, and attributable to lead-sheathed hose production, which may be discharged by a point source subject to the provisions of this subpart after application of the best practicable control technology currently available, in addition to the limitations set forth by Sec. 428.52(a): ------------------------------------------------------------------------ Effluent limitations ----------------------------- Average of daily Effluent characteristic Maximum values for 30 for any 1 consecutive days day shall not exceed- - ------------------------------------------------------------------------ Metric units (kg/kkg of raw material) ------------- Lead...................................... 0.0017 0.0007 ------------- English units (lb/1,000 lb of raw material) ------------- Lead...................................... 0.0017 0.0007 ------------------------------------------------------------------------ (c) The following limitations establish the quantity or quality of pollutants or pollutant properties, controlled by this section, and attributable to wet scrubbers, which may be discharged by a point source subject to the provisions of this subpart after application of the best practicable control technology currently available, in addition to the limitations set forth by Sec. 428.52(a): [[Page 69]] ------------------------------------------------------------------------ Effluent limitations ----------------------------- Average of daily Effluent characteristic Maximum values for 30 for any 1 consecutive days day shall not exceed- - ------------------------------------------------------------------------ Metric units (kg/kkg of raw material equivalent) ------------- TSS....................................... 5.8 2.9 ------------- English units (lb/1,000 lb of raw material equivalent) ------------- TSS....................................... 5.8 2.9 ------------------------------------------------------------------------ [40 FR 2336, Jan. 10, 1975, as amended at 60 FR 33963, June 29, 1995]