[Code of Federal Regulations] [Title 40, Volume 27] [Revised as ofJuly 1, 2003] From the U.S. Government Printing Office via GPO Access [CITE: 40CFR428.55] [Page 69-70] TITLE 40--PROTECTION OF ENVIRONMENT CHAPTER I--ENVIRONMENTAL PROTECTION AGENCY (CONTINUED) PART 428--RUBBER MANUFACTURING POINT SOURCE CATEGORY--Table of Contents Subpart E--Small-Sized General Molded, Extruded, and Fabricated Rubber Plants Subcategory Sec. 428.55 Standards of performance for new sources. (a) The following standards of performance establish the quantity or quality of pollutants or pollutant properties, controlled by this section, which may be discharged by a new source subject to the provisions of this subpart: [[Page 70]] ------------------------------------------------------------------------ Effluent limitations ----------------------------- Average of daily Effluent characteristic Maximum values for 30 for any 1 consecutive days day shall not exceed- - ------------------------------------------------------------------------ Metric units (kg/kkg of raw material) ------------- Oil and grease............................ 0.70 0.25 TSS....................................... 1.28 0.64 pH........................................ (\1\) (\1\) ------------- English units (lb/1,000 lb of raw material) ------------- Oil and grease............................ 0.70 0.25 TSS....................................... 1.28 0.64 pH........................................ (\1\) (\1\) ------------------------------------------------------------------------ \1\ Within the range 6.0 to 9.0. (b) The following standards of performance establish the quantity or quality of pollutants or pollutant properties, controlled by this section, and attributable to lead-sheathed hose production, which may be discharged by a new source subject to the provisions of this subpart, in addition to the limitations set forth by Sec. 428.55(a): ------------------------------------------------------------------------ Effluent limitations ----------------------------- Average of daily Effluent characteristic Maximum values for 30 for any 1 consecutive days day shall not exceed- - ------------------------------------------------------------------------ Metric units (kg/kkg of raw material) ------------- Lead...................................... 0.0017 0.0007 ------------- English units (lb/1,000 lb of raw material) ------------- Lead...................................... 0.0017 0.0007 ------------------------------------------------------------------------