[Code of Federal Regulations] [Title 40, Volume 27] [Revised as ofJuly 1, 2003] From the U.S. Government Printing Office via GPO Access [CITE: 40CFR465.33] [Page 605] TITLE 40--PROTECTION OF ENVIRONMENT CHAPTER I--ENVIRONMENTAL PROTECTION AGENCY (CONTINUED) PART 465--COIL COATING POINT SOURCE CATEGORY--Table of Contents Subpart C--Aluminum Basis Material Subcategory Sec. 465.33 New source performance standards. The following standards of performance establish the quantity or quality of pollutants or pollutant properties, controlled by this section, which may be discharged by a new source subject to the provisions of this subpart. Subpart C ------------------------------------------------------------------------ NSPS ------------------------------------- Maximum for any 1 Maximum for Pollutant or pollutant property day monthly average ------------------------------------- ------------------------------------------------------------------------ mg/m\2\ (pounds per 1 million ft \2\) of area processed ----------- Chromium.......................... 0.18 (0.037) 0.072 (0.015) Cyanide........................... 0.095 (0.020) 0.038 (0.008) Zinc.............................. 0.49 (0.10) 0.20 (0.041) Aluminum.......................... 1.44 (0.30) 0.59 (0.121) Oil and Grease.................... 4.75 (0.98) 4.75 (0.98) TSS............................... 7.13 (1.46) 5.70 (1.17) pH................................ (\1\) (\1\) (\1\) (\1\) ------------------------------------------------------------------------ \1\ Within the range of 7.5 to 10.0 at all times. [47 FR 54244, Dec. 1, 1982; 49 FR 33649, Aug. 24, 1984]