[Code of Federal Regulations]
[Title 40, Volume 2]
[Revised as of July 1, 2003]
From the U.S. Government Printing Office via GPO Access
[CITE: 40CFR51.118]

[Page 148]
 
                   TITLE 40--PROTECTION OF ENVIRONMENT
 
         CHAPTER I--ENVIRONMENTAL PROTECTION AGENCY (CONTINUED)
 
PART 51--REQUIREMENTS FOR PREPARATION, ADOPTION, AND SUBMITTAL OF 
IMPLEMENTATION PLANS--Table of Contents
 
                       Subpart G--Control Strategy
 
Sec. 51.118  Stack height provisions.

    (a) The plan must provide that the degree of emission limitation 
required of any source for control of any air pollutant must not be 
affected by so much of any source's stack height that exceeds good 
engineering practice or by any other dispersion technique, except as 
provided in Sec. 51.118(b). The plan must provide that before a State 
submits to EPA a new or revised emission limitation that is based on a 
good engineering practice stack height that exceeds the height allowed 
by Sec. 51.100(ii) (1) or (2), the State must notify the public of the 
availabilty of the demonstration study and must provide opportunity for 
a public hearing on it. This section does not require the plan to 
restrict, in any manner, the actual stack height of any source.
    (b) The provisions of Sec. 51.118(a) shall not apply to (1) stack 
heights in existence, or dispersion techniques implemented on or before 
December 31, 1970, except where pollutants are being emitted from such 
stacks or using such dispersion techniques by sources, as defined in 
section 111(a)(3) of the Clean Air Act, which were constructed, or 
reconstructed, or for which major modifications, as defined in 
Secs. 51.165(a)(1)(v)(A), 51.166(b)(2)(i) and 52.21(b)(2)(i), were 
carried out after December 31, 1970; or (2) coal-fired steam electric 
generating units subject to the provisions of section 118 of the Clean 
Air Act, which commenced operation before July 1, 1957, and whose stacks 
were construced under a construction contract awarded before February 8, 
1974.