[Code of Federal Regulations]
[Title 40, Volume 14]
[Revised as of July 1, 2003]
From the U.S. Government Printing Office via GPO Access
[CITE: 40CFR75.6]

[Page 210-213]
 
                   TITLE 40--PROTECTION OF ENVIRONMENT
 
         CHAPTER I--ENVIRONMENTAL PROTECTION AGENCY (CONTINUED)
 
PART 75--CONTINUOUS EMISSION MONITORING--Table of Contents
 
                           Subpart A--General
 
Sec. 75.6  Incorporation by reference.

    The materials listed in this section are incorporated by reference 
in the corresponding sections noted. These incorporations by reference 
were approved by the Director of the Federal Register in accordance with 
5 U.S.C. 552(a) and 1 CFR part 51. These materials are incorporated as 
they existed on the date of approval, and a notice of any change in 
these materials will be published in the Federal Register. The materials 
are available for purchase at the corresponding address noted below and 
are available for inspection at the Office of the Federal Register, 800 
North Capitol Street, NW, Suite 700, Washington, DC, at the Public 
Information Reference Unit of the U.S. EPA, 401 M St., SW., Washington, 
DC and at the Library (MD-35), U.S. EPA, Research Triangle Park, North 
Carolina.
    (a) The following materials are available for purchase from the 
following addresses: American Society for Testing and Material (ASTM), 
1916 Race Street, Philadelphia, Pennsylvania 19103; and the University 
Microfilms International 300 North Zeeb Road, Ann Arbor, Michigan 48106.
    (1) ASTM D129-91, Standard Test Method for Sulfur in Petroleum 
Products (General Bomb Method), for appendices A and D of this part.
    (2) ASTM D240-87 (Reapproved 1991), Standard Test Method for Heat of 
Combustion of Liquid Hydrocarbon Fuels by Bomb Calorimeter, for 
appendices A, D and F of this part.
    (3) ASTM D287-82 (Reapproved 1987), Standard Test Method for API 
Gravity of Crude Petroleum and Petroleum Products (Hydrometer Method), 
for appendix D of this part.
    (4) ASTM D388-92, Standard Classification of Coals by Rank, 
incorporation by reference for appendix F of this part.
    (5) ASTM D941-88, Standard Test Method for Density and Relative 
Density (Specific Gravity) of Liquids by Lipkin Bicapillary Pycnometer, 
for appendix D of this part.
    (6) ASTM D1072-90, Standard Test Method for Total Sulfur in Fuel 
Gases, for appendix D of this part.
    (7) ASTM D1217-91, Standard Test Method for Density and Relative 
Density (Specific Gravity) of Liquids by Bingham Pycnometer, for 
appendix D of this part.
    (8) ASTM D1250-80 (Reapproved 1990), Standard Guide for Petroleum 
Measurement Tables, for appendix D of this part.

[[Page 211]]

    (9) ASTM D1298-85 (Reapproved 1990), Standard Practice for Density, 
Relative Density (Specific Gravity) or API Gravity of Crude Petroleum 
and Liquid Petroleum Products by Hydrometer Method, for appendix D of 
this part.
    (10) ASTM D1480-91, Standard Test Method for Density and Relative 
Density (Specific Gravity) of Viscous Materials by Bingham Pycnometer, 
for appendix D of this part.
    (11) ASTM D1481-91, Standard Test Method for Density and Relative 
Density (Specific Gravity) of Viscous Materials by Lipkin Bicapillary 
Pycnometer, for appendix D of this part.
    (12) ASTM D1552-90, Standard Test Method for Sulfur in Petroleum 
Products (High Temperature Method), for appendices A and D of the part.
    (13) ASTM D1826-88, Standard Test Method for Calorific (Heating) 
Value of Gases in Natural Gas Range by Continuous Recording Calorimeter, 
for appendices D and F to this part.
    (14) ASTM D1945-91, Standard Test Method for Analysis of Natural Gas 
by Gas Chromatography, for appendices F and G of this part.
    (15) ASTM D1946-90, Standard Practice for Analysis of Reformed Gas 
by Gas Chromatography, for appendices F and G of this part.
    (16) ASTM D1989-92, Standard Test Method for Gross Calorific Value 
of Coal and Coke by Microprocessor Controlled Isoperibol Calorimeters, 
for appendix F of this part.
    (17) ASTM D2013-86, Standard Method of Preparing Coal Samples for 
Analysis, for appendix F of this part.
    (18) ASTM D2015-91, Standard Test Method for Gross Calorific Value 
of Coal and Coke by the Adiabatic Bomb Calorimeter, for appendices A, D 
and F of this part.
    (19) ASTM D2234-89, Standard Test Methods for Collection of a Gross 
Sample of Coal, for appendix F of this part.
    (20) ASTM D2382-88, Standard Test Method for Heat of Combustion of 
Hydrocarbon Fuels by Bomb Calorimeter (High-Precision Method), for 
appendices D and F of this part.
    (21) ASTM D2502-87, Standard Test Method for Estimation of Molecular 
Weight (Relative Molecular Mass) of Petroleum Oils from Viscosity 
Measurements, for appendix G of this part.
    (22) ASTM D2503-82 (Reapproved 1987), Standard Test Method for 
Molecular Weight (Relative Molecular Mass) of Hydrocarbons by 
Thermoelectric Measurement of Vapor Pressure, for appendix G of this 
part.
    (23) ASTM D2622-92, Standard Test Method for Sulfur in Petroleum 
Products by X-Ray Spectrometry, for appendices A and D of this part.
    (24) ASTM D3174-89, Standard Test Method for Ash in the Analysis 
Sample of Coal and Coke From Coal, for appendix G of this part.
    (25) ASTM D3176-89, Standard Practice for Ultimate Analysis of Coal 
and Coke, for appendices A and F of this part.
    (26) ASTM D3177-89, Standard Test Methods for Total Sulfur in the 
Analysis Sample of Coal and Coke, for appendix A of this part.
    (27) ASTM D3178-89, Standard Test Methods for Carbon and Hydrogen in 
the Analysis Sample of Coal and Coke, for appendix G of this part.
    (28) ASTM D3238-90, Standard Test Method for Calculation of Carbon 
Distribution and Structural Group Analysis of Petroleum Oils by the n-d-
M Method, for appendix G of this part.
    (29) ASTM D3246-81 (Reapproved 1987), Standard Test Method for 
Sulfur in Petroleum Gas By Oxidative Microcoulometry, for appendix D of 
this part.
    (30) ASTM D3286-91a, Standard Test Method for Gross Calorific Value 
of Coal and Coke by the Isoperibol Bomb Calorimeter, for appendix F of 
this part.
    (31) ASTM D3588-91, Standard Practice for Calculating Heat Value, 
Compressibility Factor, and Relative Density (Specific Gravity) of 
Gaseous Fuels, for appendices D and F to this part.
    (32) ASTM D4052-91, Standard Test Method for Density and Relative 
Density of Liquids by Digital Density Meter, for appendix D of this 
part.
    (33) ASTM D4057-88, Standard Practice for Manual Sampling of 
Petroleum and Petroleum Products, for appendix D of this part.
    (34) ASTM D4177-82 (Reapproved 1990), Standard Practice for 
Automatic Sampling of Petroleum and Petroleum Products, for appendix D 
of this part.

[[Page 212]]

    (35) ASTM D4239-85, Standard Test Methods for Sulfur in the Analysis 
Sample of Coal and Coke Using High Temperature Tube Furnace Combustion 
Methods, for appendix A of this part.
    (36) ASTM D4294-90, Standard Test Method for Sulfur in Petroleum 
Products by Energy-Dispersive X-Ray Fluorescence Spectroscopy, for 
appendices A and D of this part.
    (37) ASTM D4468-85 (Reapproved 1989), Standard Test Method for Total 
Sulfur in Gaseous Fuels by Hydrogenolysis and Rateometric Colorimetry, 
for appendix D of this part.
    (38) ASTM D4891-89, Standard Test Method for Heating Value of Gases 
in Natural Gas Range by Stoichiometric Combustion, for appendices D and 
F to this part.
    (39) ASTM D5291-92, Standard Test Methods for Instrumental 
Determination of Carbon, Hydrogen, and Nitrogen in Petroleum Products 
and Lubricants, for appendices F and G to this part.
    (40) ASTM D5373-93, ``Standard Methods for Instrumental 
Determination of Carbon, Hydrogen, and Nitrogen in Laboratory Samples of 
Coal and Coke,'' for appendix G to this part.
    (41) ASTM D5504-94, Standard Test Method for Determination of Sulfur 
Compounds in Natural Gas and Gaseous Fuels by Gas Chromatography and 
Chemiluminescence, for appendix D of this part.
    (b) The following materials are available for purchase from the 
American Society of Mechanical Engineers (ASME), 22 Law Drive, Box 2350, 
Fairfield, NJ 07007-2350.
    (1) ASME MFC-3M-1989 with September 1990 Errata, Measurement of 
Fluid Flow in Pipes Using Orifice, Nozzle, and Venturi, for appendix D 
of this part.
    (2) ASME MFC-4M-1986 (Reaffirmed 1990), Measurement of Gas Flow by 
Turbine Meters, for appendix D of this part.
    (3) ASME-MFC-5M-1985, Measurement of Liquid Flow in Closed Conduits 
Using Transit-Time Ultrasonic Flowmeters, for appendix D of this part.
    (4) ASME MFC-6M-1987 with June 1987 Errata, Measurement of Fluid 
Flow in Pipes Using Vortex Flow Meters, for appendix D of this part.
    (5) ASME MFC-7M-1987 (Reaffirmed 1992), Measurement of Gas Flow by 
Means of Critical Flow Venturi Nozzles, for appendix D of this part.
    (6) ASME MFC-9M-1988 with December 1989 Errata, Measurement of 
Liquid Flow in Closed Conduits by Weighing Method, for appendix D of 
this part.
    (c) The following materials are available for purchase from the 
American National Standards Institute (ANSI), 11 W. 42nd Street, New 
York NY 10036: ISO 8316: 1987(E) Measurement of Liquid Flow in Closed 
Conduits-Method by Collection of the Liquid in a Volumetric Tank, for 
appendices D and E of this part.
    (d) The following materials are available for purchase from the 
following address: Gas Processors Association (GPA), 6526 East 60th 
Street, Tulsa, Oklahoma 74145:
    (1) GPA Standard 2172-86, Calculation of Gross Heating Value, 
Relative Density and Compressibility Factor for Natural Gas Mixtures 
from Compositional Analysis, for appendices D, E, and F of this part.
    (2) GPA Standard 2261-90, Analysis for Natural Gas and Similar 
Gaseous Mixtures by Gas Chromatography, for appendices D, F, and G of 
this part.
    (e) The following materials are available for purchase from the 
following address: American Gas Association, 1515 Wilson Boulevard, 
Arlington VA 22209:
    (1) American Gas Association Report No. 3: Orifice Metering of 
Natural Gas and Other Related Hydrocarbon Fluids, Part 1: General 
Equations and Uncertainty Guidelines (October 1990 Edition), Part 2: 
Specification and Installation Requirements (February 1991 Edition) and 
Part 3: Natural Gas Applications (August 1992 Edition), for appendices D 
and E of this part.
    (2) American Gas Association Transmission Measurement Committee 
Report No. 7: Measurement of Gas by Turbine Meters (Second Revision, 
April, 1996), for appendix D to this part.
    (f) The following materials are available for purchase from the 
following address: American Petroleum Institute, Publications 
Department, 1220 L Street NW, Washington, DC 20005-4070.

[[Page 213]]

    (1) American Petroleum Institute (API) Petroleum Measurement 
Standards, Chapter 3, Tank Gauging: Section 1A, Standard Practice for 
the Manual Gauging of Petroleum and Petroleum Products, December 1994; 
Section 1B, Standard Practice for Level Measurement of Liquid 
Hydrocarbons in Stationary Tanks by Automatic Tank Gauging, April 1992 
(reaffirmed January 1997); Section 2, Standard Practice for Gauging 
Petroleum and Petroleum Products in Tank Cars, September 1995; Section 
3, Standard Practice for Level Measurement of Liquid Hydrocarbons in 
Stationary Pressurized Storage Tanks by Automatic Tank Gauging, June 
1996; Section 4, Standard Practice for Level Measurement of Liquid 
Hydrocarbons on Marine Vessels by Automatic Tank Gauging, April 1995; 
and Section 5, Standard Practice for Level Measurement of Light 
Hydrocarbon Liquids Onboard Marine Vessels by Automatic Tank Gauging, 
March 1997; for Sec. 75.19.
    (2) Shop Testing of Automatic Liquid Level Gages, Bulletin 2509 B, 
December 1961 (Reaffirmed August 1987, October 1992), for Sec. 75.19.
    (3) American Petroleum Institute (API) Section 2, ``Conventional 
Pipe Provers,'' Section 3, ``Small Volume Provers,'' and Section 5, 
``Master-Meter Provers,'' from Chapter 4 of the Manual of Petroleum 
Measurement Standards, October 1988 (Reaffirmed 1993), for appendix D to 
this part.

[58 FR 3701, Jan. 11, 1993, as amended at 60 FR 26517, May 17, 1995; 61 
FR 59157, Nov. 20, 1996; 63 FR 57499, Oct. 27, 1998; 64 FR 28589, May 
26, 1999; 67 FR 40422, June 12, 2002]