[Code of Federal Regulations] [Title 40, Volume 18] [Revised as of July 1, 2003] From the U.S. Government Printing Office via GPO Access [CITE: 40CFR91.6] [Page 299-300] TITLE 40--PROTECTION OF ENVIRONMENT CHAPTER I--ENVIRONMENTAL PROTECTION AGENCY (CONTINUED) PART 91--CONTROL OF EMISSIONS FROM MARINE SPARK-IGNITION ENGINES--Table of Contents Subpart A--General Sec. 91.6 Reference materials. (a) Incorporation by reference. The documents in paragraph (b) of this section have been incorporated by reference. The incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be inspected at U.S. EPA, OAR, [[Page 300]] Air and Radiation Docket and Information Center, 401 M St., SW., Washington, DC 20460, or at the Office of the Federal Register, 800 N. Capitol St. NW., 7th Floor, Suite 700, Washington, DC 20001. (b) The following paragraphs and tables set forth the material that has been incorporated by reference in this part. (1) ASTM material. The following table sets forth material from the American Society for Testing and Materials which has been incorporated by reference. The first column lists the number and name of the material. The second column lists the section(s) of this part, other than Sec. 91.6, in which the matter is referenced. The second column is presented for information only and may not be all inclusive. Copies of these materials may be obtained from American Society for Testing and Materials, 1916 Race St., Philadelphia, PA 19103. ------------------------------------------------------------------------ Document number and name 40 CFR part 91 reference ------------------------------------------------------------------------ ASTM D86-93: Standard Test Method for Appendix A to Subpart D. Distillation of Petroleum Products. ASTM D323-90: Standard Test Method for Appendix A to Subpart D. Vapor Pressure of Petroleum Products (Reid Method). ASTM D1319-93: Standard Test Method for Appendix A to Subpart D. Hydrocarbon Types in Liquid Petroleum Products by Fluorescent Indicator Adsorption. ASTM D2622-92: Standard Test Method for Appendix A to Subpart D. Sulfur in Petroleum Products by X-Ray Spectrometry. ASTM D2699-92: Standard Test Method for Appendix A to Subpart D. Knock Characteristics of Motor Fuels by the Research Method. ASTM D2700-92: Standard Test Method for Appendix A to Subpart D. Knock Characteristics of Motor and Aviation Fuels by the Motor Method. ASTM D3231-89: Standard Test Method for Appendix A to Subpart D. Phosphorus in Gasoline. ASTM D3606-92: Standard Test Method for Appendix A to Subpart D. Determination of Benzene and Toluene in Finished Motor and Aviation Gasoline by Gas Chromatography. ASTM E29-93a: Standard Practice for 91.207; 91.120; 91.509; 91.1307. Using Significant Digits in Test Data to Determine Conformance with Specifications. ------------------------------------------------------------------------ (2) SAE material. The following table sets forth material from the Society of Automotive Engineers which has been incorporated by reference. The first column lists the number and name of the material. The second column lists the section(s) of this part, other than Sec. 91.7, in which the matter is referenced. The second column is presented for information only and may not be all inclusive. Copies of these materials may be obtained from Society of Automotive Engineers International, 400 Commonwealth Dr., Warrendale, PA 15096-0001. ------------------------------------------------------------------------ Document number and name 40 CFR part 91 reference ------------------------------------------------------------------------ SAE J1228/ISO 8665 November 91.104, 91.115; 91.118; 91.207; 91.1307. 1991 Small Craft-Marine Propulsion Engine and Systems-Power Measurements and Declarations. SAE J1930 June 1993 91.113. Electrical/Electronic Systems Diagnostic Terms, Definitions, Abbreviations and Acronyms. SAE Paper 770141 Optimization 91.316 of a Flame Ionization Detector for Determination of Hydrocarbon in Diluted Automotive Exhausts, Glenn D. Reschke, 1977. ------------------------------------------------------------------------