[Code of Federal Regulations]
[Title 41, Volume 3]
[Revised as of July 1, 2003]
From the U.S. Government Printing Office via GPO Access
[CITE: 41CFR102-34.110]

[Page 80]
 
           TITLE 41--PUBLIC CONTRACTS AND PROPERTY MANAGEMENT
 
               CHAPTER 102--FEDERAL MANAGEMENT REGULATION
 
PART 102-34--MOTOR VEHICLE MANAGEMENT--Table of Contents
 
          Subpart B--Identifying and Registering Motor Vehicles
 
Sec. 102-34.110  What motor vehicle identification must we put on motor 
vehicles we purchase or lease?

    (a) For motor vehicles with rear windows, display:
    (1) ``For Official Use Only,'' in letters \1/2\ to \3/4\ inch high.
    (2) ``U.S. Government'' in letters \3/4\ to 1 inch high; and
    (3) The full name of the department, agency, establishment, 
corporation, or service owning or leasing the motor vehicle (in letters 
1 to 1\1/2\ inch high), or in the alternative, a title that describes 
the activity in which it is operated (if the title readily identifies 
the department, agency, establishment, corporation, or service 
concerned).
    (b) For other than motor vehicle rear windows, display the motor 
vehicle identification in paragraphs (a)(1) through (3) of this section, 
but:
    (1) Use letters 1 to 1\1/2\ inches high in colors contrasting to the 
motor vehicle.
    (2) If you use subsidiary words or titles of subordinate units, use 
letters \1/2\ inch to \3/4\ inch high.
    (c) The preferred material is a decal of elastomeric pigmented film 
type for ease of application and removal.

    Note to Sec. 102-34.110: Each agency or activity is responsible for 
acquiring its own decals. Replace this motor vehicle identification when 
necessary due to damage or wear.