[Code of Federal Regulations]
[Title 49, Volume 4]
[Revised as of October 1, 2003]
From the U.S. Government Printing Office via GPO Access
[CITE: 49CFR229.61]

[Page 314-315]
 
                        TITLE 49--TRANSPORTATION
 
       CHAPTER II--FEDERAL RAILROAD ADMINISTRATION, DEPARTMENT OF 
                             TRANSPORTATION
 
PART 229--RAILROAD LOCOMOTIVE SAFETY STANDARDS--Table of Contents
 
                     Subpart C--Safety Requirements
 
Sec. 229.61  Draft system.

    (a) A coupler may not have any of the following conditions:
    (1) A distance between the guard arm and the knuckle nose of more 
than 5\1/8\ inches on standard type couplers (MCB contour 1904) or more 
than 5\5/16\ inches on D&E couplers.
    (2) A crack or break in the side wall or pin bearing bosses outside 
of the shaded areas shown in Figure 1 or in the pulling face of the 
knuckle.

[[Page 315]]

[GRAPHIC] [TIFF OMITTED] TC01AP91.004

    (3) A coupler assembly without anti-creep protection.
    (4) Free slack in the coupler or drawbar not absorbed by friction 
devices or draft gears that exceeds one-half inches.
    (5) A broken or cracked coupler carrier.
    (6) A broken or cracked yoke.
    (7) A broken draft gear.
    (b) A device shall be provided under the lower end of all drawbar 
pins and articulated connection pins to prevent the pin from falling out 
of place in case of breakage.

                            Suspension System