[Code of Federal Regulations]
[Title 40, Volume 30]
[Revised as of July 1, 2004]
From the U.S. Government Printing Office via GPO Access
[CITE: 40CFR1065.1]
[Page 647-649]
TITLE 40--PROTECTION OF ENVIRONMENT
CHAPTER I--ENVIRONMENTAL PROTECTION AGENCY (CONTINUED)
PART 1065_TEST PROCEDURES AND EQUIPMENT--Table of Contents
Subpart A_Applicability and General Provisions
Sec. 1065.1 Applicability.
Subpart A_Applicability and General Provisions
Sec.
1065.1 Applicability.
1065.5 Overview of test procedures.
1065.10 Other test procedures.
1065.15 Engine testing.
1065.20 Limits for test conditions.
Subpart B_Equipment and Analyzers
1065.101 Overview.
1065.105 Dynamometer and engine equipment specifications.
1065.110 Exhaust gas sampling system; spark-ignition (SI) engines.
[[Page 648]]
1065.115 Exhaust gas sampling system; compression-ignition engines.
1065.120 Raw sampling. [Reserved]
1065.125 Analyzers (overview/general response characteristics).
1065.130 Hydrocarbon analyzers.
1065.135 NOX analyzers.
1065.140 CO and CO2 analyzers.
1065.145 Smoke meters. [Reserved]
1065.150 Flow meters.
1065.155 Temperature and pressure sensors.
Subpart C_Test Fuels and Analytical Gases
1065.201 General requirements for test fuels.
1065.205 Test fuel specifications for distillate diesel fuel.
1065.210 Test fuel specifications for gasoline.
1065.215 Test fuel specifications for natural gas.
1065.220 Test fuel specifications for liquefied petroleum gas.
1065.240 Lubricating oils.
1065.250 Analytical gases.
Subpart D_Analyzer and Equipment Calibrations
1065.301 Overview.
1065.305 International calibration standards.
1065.310 CVS calibration.
1065.315 Torque calibration.
Subpart E_Engine Selection, Preparation, and Service Accumulation
1065.401 Selecting a test engine.
1065.405 Preparing and servicing a test engine.
1065.410 Service limits for stabilized test engines.
1065.415 Durability demonstration.
Subpart F_Running an Emission Test
1065.501 Overview of the engine dynamometer test procedures.
1065.510 Engine mapping procedures.
1065.515 Test cycle generation.
1065.520 Engine starting, restarting, and shutdown.
1065.525 Engine dynamometer test run.
1065.530 Test cycle validation criteria.
Subpart G_Data Analysis and Calculations
1065.601 Overview.
1065.605 Required records.
1065.610 Bag sample analysis.
1065.615 Bag sample calculations.
1065.620 Continuous sample analysis and calculations.
Subpart H_Particulate Measurements
1065.701 Particulate measurements.
Subpart I_Testing With Oxygenated Fuels
1065.801 Applicability.
1065.805 Sampling system.
1065.810 Calculations.
Subpart J_Field Testing
1065.901 Applicability.
1065.905 General provisions.
1065.910 Measurement accuracy and precision.
1065.915 Equipment specifications for SI engines.
1065.920 Equipment setup and test run for SI engines.
1065.925 Calculations.
1065.930 Specifications for mass air flow sensors.
1065.935 Specifications for THC analyzers.
1065.940 Specifications for NOX and air/fuel sensors.
1065.945 Specifications for CO analyzers.
1065.950 Specifications for speed and torque measurement.
Subpart K_Definitions and Other Reference Information
1065.1001 Definitions.
1065.1005 Symbols, acronyms, and abbreviations.
1065.1010 Reference materials.
1065.1015 Confidential information.
Authority: 42 U.S.C. 7401-7671(q).
Source: 67 FR 68347, Nov. 8, 2002, unless otherwise noted.
(a) This part describes the procedures that apply to testing that we
require for the following engines or for equipment using the following
engines:
(1) Large nonroad spark-ignition engines we regulate under 40 CFR
part 1048.
(2) Vehicles that we regulate under 40 CFR part 1051 (i.e.,
recreational SI vehicles) that are regulated based on engine testing.
See 40 CFR part 1051 to determine which vehicles may be certified based
on engine test data.
(b) This part does not apply to any of the following engine or
vehicle categories:
(1) Light-duty highway vehicles (see 40 CFR part 86).
(2) Heavy-duty highway Otto-cycle engines (see 40 CFR part 86).
[[Page 649]]
(3) Heavy-duty highway diesel engines (see 40 CFR part 86).
(4) Aircraft engines (see 40 CFR part 87).
(5) Locomotive engines (see 40 CFR part 92).
(6) Land-based nonroad diesel engines (see 40 CFR part 89).
(7) General marine engines (see 40 CFR parts 89 and 94).
(8) Marine outboard and personal watercraft engines (see 40 CFR part
91).
(9) Small nonroad spark-ignition engines (see 40 CFR part 90).
(c) This part is addressed to you as a manufacturer, but it applies
equally to anyone who does testing for you, and to us when we conduct
testing to determine if you meet emission standards.
(d) Paragraph (a) of this section identifies the parts of the CFR
that define emission standards and other requirements for particular
types of engines. In this part 1065, we refer to each of these other
parts generically as the ``standard-setting part.'' For example, 40 CFR
part 1051 is always the standard-setting part for snowmobiles. Follow
the standard-setting part if it differs from this part.
(e) For equipment subject to this part and regulated under
equipment-based or vehicle-based standards, interpret the term
``engine'' in this part to include equipment and vehicles(see 40 CFR
1068.30).
Effective Date Note: At 69 FR 39260, June 29, 2004, Sec. 1065.1 was
amended by revising paragraph (a) and removing and reserving paragraph
(b)(6), effective Aug. 30, 2004. For the convenience of the user, the
revised text is set forth as follows:
Sec. 1065.1 Applicability.
(a) This part describes the procedures that apply to testing that we
require for the following engines or for equipment using the following
engines:
(1) Large nonroad spark-ignition engines we regulate under 40 CFR
part 1048.
(2) Vehicles that we regulate under 40 CFR part 1051 (i.e.,
recreational SI vehicles) that are regulated based on engine testing.
See 40 CFR part 1051 to determine which vehicles may be certified based
on engine test data.
(3) Land-based nonroad compression-ignition engines we regulate
under 40 CFR part 1039.
* * * * *