[Code of Federal Regulations] [Title 40, Volume 30] [Revised as of July 1, 2004] From the U.S. Government Printing Office via GPO Access [CITE: 40CFR1065.405] [Page 665] TITLE 40--PROTECTION OF ENVIRONMENT CHAPTER I--ENVIRONMENTAL PROTECTION AGENCY (CONTINUED) PART 1065_TEST PROCEDURES AND EQUIPMENT--Table of Contents Subpart E_Engine Selection, Preparation, and Service Accumulation Sec. 1065.405 Preparing and servicing a test engine. (a) If you are testing an emission-data engine for certification, make sure you have built it to represent production engines. (b) Run the test engine, with all emission-control systems operating, long enough to stabilize emission levels. If you accumulate 50 hours of operation, you may consider emission levels stable without measurement. (c) Do not service the test engine before you stabilize emission levels, unless we approve other maintenance in advance. This prohibition does not apply to your recommended oil and filter changes for newly produced engines, or to idle-speed adjustments. (d) Select engine operation for accumulating operating hours on your test engines to represent normal in-use operation for the engine family. (e) If you need more than 50 hours to stabilize emission levels, record your reasons and the method you use to do this. Give us these records if we ask for them. Effective Date Note: At 69 FR 39261, June 29, 2004, Sec. 1065.405 is amended by revising paragraph (b), effective Aug. 30, 2004. For the convenience of the user, the revised text is set forth as follows: Sec. 1065.405 Preparing and servicing a test engine. * * * * * (b) Run the test engine, with all emission-control systems operating, long enough to stabilize emission levels. (1) For SI engines, if you accumulate 50 hours of operation, you may consider emission levels stable without measurement. (2) For CI engines, if you accumulate 125 hours of operation, you may consider emission levels stable without measurement. * * * * *