[Code of Federal Regulations]
[Title 46, Volume 2]
[Revised as of October 1, 2004]
From the U.S. Government Printing Office via GPO Access
[CITE: 46CFR54.10-3]

[Page 153]
 
                           TITLE 46--SHIPPING
 
   CHAPTER I--COAST GUARD, DEPARTMENT OF HOMELAND SECURITY (CONTINUED)
 
PART 54_PRESSURE VESSELS--Table of Contents
 
             Subpart 54.10_Inspection, Reports, and Stamping
 
Sec. 54.10-3  Marine inspectors (replaces UG-90 and UG-91, and modifies 
UG-92 through UG-103).

    (a) Only marine inspectors shall apply the Coast Guard Symbol. They 
will not apply any other code symbol to pressure vessels.
    (b) All pressure vessels not exempted under provisions of Sec. 
54.01-15 shall be inspected by a marine inspector referring to 
procedures outlined in UG-92 through UG-103 of the ASME Code and 
Sec. Sec. 50.30-10, 50.30-15, and 50.30-20 of this subchapter. The 
marine inspector will then stamp the vessel with the Coast Guard Symbol.
    (c) Pressure vessels described in Sec. 54.01-5(c)(3), except 
pressure vessels in systems regulated under Sec. 58.60 of this chapter, 
must be visually examined by a marine inspector prior to installation. 
The marine inspector also reviews the associated plans and 
manufacturers' data reports. If, upon inspection, the pressure vessel 
complies with the applicable requirements in Sec. 54.01-5, the marine 
inspector stamps the pressure vessel with the Coast Guard Symbol.

[CGFR 68-82, 33 FR 18828, Dec. 18, 1968, as amended by CGD 77-147, 47 FR 
21810, May 20, 1982]